model spa900 surface mount

model spa900 surface mount
Page 1 of 2
Document Number
XM-LGT1PMEX-R9A
LGTR9A-Rev150512
FIRE RESEARCH CORPORATION
26 Southern Blvd., Nesconset, NY 11767
TEL 631.724.8888 FAX 631.360.9727
TOLL FREE 1.800.645.0074
www.fireresearch.com
MODEL SPA900
SURFACE MOUNT
INSTALLATION INSTRUCTIONS
Before mounting check the identification label on the light for specific voltage and current requirements. Check that the length of
the wiring is correct.
The light fixture has a vehicle panel seal is designed to make a weather tight seal at the fixture and the mounting panel. This requires
a hole to be drilled for the wires.
Note: Before drilling holes place the light in position to check for fit. Ensure that the light is clear from all obstructions.
Install Surface Mount Model SPA900
Note: Do not use Loctite on any screws near the lamphead lens. FRC led lampheads use Lexan lenses that can become
brittle and prone to cracking when exposed to Loctite compounds.
1. Measure and mark the mounting hole locations and through hole for the wiring. The mounting holes through the light bezel
are clearance for #10 screws. Refer to drawings on page 2.
2. Drill the four (4) mounting holes and wire feedthrough hole.
Note: Ensure that the light is mounted with the word TOP on the lens up.
3. Connect the wiring, place the two (2) mounting gaskets in position on each side of the light. Ensure that the vehicle panel seal
is aligned over the wire feedthrough and seated correctly against the mounting surface. Secure the light with four (4) screws.
Wiring 12/24 VDC
Connect the RED wire to POWER
Connect the BLACK wire to GROUND.
SPA900 Surface
Mount Light
MAINTENANCE
Use a clean soft cloth, mild soap, and water to clean the lens.
NOTE: FRC led lampheads use Lexan lenses and cleaning with abrasive materials, solvents, or most chemical cleaners can
cause lens surface degradation and reduced performance of the light. Some chemicals will cause the lens to become
brittle and prone to cracking.
NO CUTOUT REQUIRED
Drill four (4) holes for screws and
one (1) centered hole for the wires.
Install Surface Mount Model SPA900 Light
Page 2 of 2
LGTR9A-Rev150512
7 1/4"
Drill wire hole from 3/8" to a
maximum of 7/8" diameter.
3 5/8"
The vehicle panel seal is designed
to make a weather tight seal at the
light and the mounting panel.
Fitted edge seals
at the light.
2 5/8"
5 1/4"
Washer presses on
the rolled lip
and seals at the
mounting panel.
Mounting holes are
clearance or tapped
for #10 screws.
Note: Ensure that the top of the light is up.
The lens redirects the light down along the
vehicle and out onto the working area. It
must be mounted with the word TOP up.
Note: Do not use Loctite on any screws near the lamphead lens.
FRC led lampheads use Lexan lenses that can become brittle and
prone to cracking when exposed to Loctite compounds.
1 3/4"
9"
6 3/4"
The word
TOP is up.
The beveled edge
of lens is down.
Light Lens
Light Housing
Mounting Gasket (2)
Mounting Surface
Cooling
Fins.
Vehicle
Panel Seal.
Red wire to power.
Black wire to ground.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising