Diama and Kora Interior LED Wall Light

Diama and Kora Interior LED Wall Light
Diama and Kora
Interior LED Wall Light
Cat. No. LWL033KWE (Diama)
LWL053KWE (Kora)
Instruction Sheet
Class II Construction
LWL033KWE
LWL053KWE
Please read instruction sheet before commencing installation. Installation must be performed by a registered electrical contractor.
1
Description
Cat no.
Description
Height
Width
Depth
Lumens^
Nominal
Colour Temp
LWL033KWE
White Wall light 7.5W LED Warm White (non dimmable)
175mm
197mm
79mm
520lm
3000K
LWL053KWE
White Wall light 8.3W LED Warm White (non dimmable)
100mm
100mm
100mm
335lm
3000K
2
LED Lamp Life
30,000 HrsRated Average Lamp LED Life @25ºC in open air
3
Mounting Instructions
Follow the steps below.
A. Using mounting bracket as a template, mark and drill holes for mounting.
B. Fix the mounting bracket onto the wall with screws.
C. Connect the active and neutral supply wires to the driver terminal.
Ensure double-insulated cable is brought in to the LED driver housing.
Refer to Fig. 2.
D. Fix the fixture to the mounting bracket using the grub screws supplied.
Bracket
Figure 1.
Figure 2.
^Lumen values quoted are typical and can vary at different colour temperatures and between manufacturers.
# Installation must be by a Registered Electrical Contractor.
Disclaimers
Warranty
Customer Service
HPM Legrand warrants this product for a period of 6 years from the date of purchase.
For all Customer Service and Technical Support
please call Monday to Friday during business hours.
See the Warranty card enclosed with this product for further details.
HPM Legrand Australia
1300 369 777
www.hpm.com.au
HPM Legrand New Zealand
0800 476 009
www.hpm.co.nz
ABN: 31 000 102 661
LE07093ACB
These goods come with guarantees that cannot be excluded under the Australian and New
Zealand Consumer Laws. You are entitled to a replacement or a refund for a major failure
and for compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired if the goods fail to be acceptable quality and the failure
does not amount to a major failure.
05_2015
1. This product must be installed and used as per these instructions. 2. This product should only be cleaned with a damp cloth. Cleaning agents and solvents should not be
used. 3. This product is not dimmable. 4. This product has been designed to minimise the effects of interference from off peak electricity signals. Interference in the form of
light flicker is still possible in some cases depending on proximity to the signal injection point. 5. This product contains no serviceable parts and no attempt should be
made to repair this product. If the product is faulty it should be discarded. 7. Severe electromagnetic interference from other products may cause malfunction of this
product. 8. The material in this product may vary in colour from batch to batch. Colour matching from one batch to another cannot be guaranteed. 9. Electrical installations
periodically receive transient over voltages. This product has been designed to minimise the effect of such voltages on connected equipment. It may not give full protection
for extreme over voltage transients such as those resulting from a close lighting strike. 10. Lamp LED life is an average and will be reduced by frequent switching. 11. This
product utilises intellectual property in the form of registered designs, trademarks, and/or patents. Such intellectual property remains the property of HPM Legrand in all
cases. 12. HPM Legrand reserves the right to modify the specifications of this product at any time.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising