HPM Legrand Diama LWL033KWE, Kora LWL053KWE LED Wall Light Instruction Sheet

Diama and Kora

Interior LED Wall Light

Cat. No. LWL033KWE (Diama)

LWL053KWE (Kora)

Instruction Sheet

Class II Construction

LWL033KWE LWL053KWE

Please read instruction sheet before commencing installation. Installation must be performed by a registered electrical contractor.

1 Description

Cat no.

LWL033KWE

LWL053KWE

Description

White Wall light 7.5W LED Warm White (non dimmable)

White Wall light 8.3W LED Warm White (non dimmable)

Height

175mm

100mm

Width

197mm

100mm

Depth

79mm

100mm

Lumens ^

520lm

335lm

Nominal

Colour Temp

3000K

3000K

2 LED Lamp Life

30,000 Hrs Rated Average Lamp LED Life @25ºC in open air

3 Mounting Instructions

Follow the steps below.

A. Using mounting bracket as a template, mark and drill holes for mounting.

B. Fix the mounting bracket onto the wall with screws.

C. Connect the active and neutral supply wires to the driver terminal.

Ensure double-insulated cable is brought in to the LED driver housing.

Refer to Fig. 2.

D. Fix the fixture to the mounting bracket using the grub screws supplied.

Bracket

Figure 1.

Figure 2.

^ Lumen values quoted are typical and can vary at different colour temperatures and between manufacturers.

# Installation must be by a Registered Electrical Contractor.

Disclaimers

1. This product must be installed and used as per these instructions. 2. This product should only be cleaned with a damp cloth. Cleaning agents and solvents should not be used. 3. This product is not dimmable. 4. This product has been designed to minimise the effects of interference from off peak electricity signals. Interference in the form of light flicker is still possible in some cases depending on proximity to the signal injection point. 5. This product contains no serviceable parts and no attempt should be made to repair this product. If the product is faulty it should be discarded. 7. Severe electromagnetic interference from other products may cause malfunction of this product. 8. The material in this product may vary in colour from batch to batch. Colour matching from one batch to another cannot be guaranteed. 9. Electrical installations periodically receive transient over voltages. This product has been designed to minimise the effect of such voltages on connected equipment. It may not give full protection for extreme over voltage transients such as those resulting from a close lighting strike. 10. Lamp LED life is an average and will be reduced by frequent switching. 11. This product utilises intellectual property in the form of registered designs, trademarks, and/or patents. Such intellectual property remains the property of HPM Legrand in all cases. 12. HPM Legrand reserves the right to modify the specifications of this product at any time.

Warranty

HPM Legrand warrants this product for a period of 6 years from the date of purchase.

These goods come with guarantees that cannot be excluded under the Australian and New

Zealand Consumer Laws. You are entitled to a replacement or a refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired if the goods fail to be acceptable quality and the failure does not amount to a major failure.

See the Warranty card enclosed with this product for further details.

Customer Service

For all Customer Service and Technical Support please call Monday to Friday during business hours.

HPM Legrand Australia

1300 369 777 www.hpm.com.au

HPM Legrand New Zealand

0800 476 009 www.hpm.co.nz

ABN: 31 000 102 661