instructions - Urban Jürgensen

instructions - Urban Jürgensen
INSTRUCTIONS
MOVEMENTS P4 + P8
INSTRUCTIONS
MOVEMENTS P4 + P8
CONTENTS
M A N U A L LY W O U N D 4
SETTING THE TIME
4
P O W E R R E S E RV E I N D I C AT O R 5
MOON PHASE CORRECTION
5
P E R P E T UA L C A L E N DA R 6
S E RV I C E 8
C E RT I F I C AT E O F A U T H E N T I C I T Y 8
WA R R A N T Y 9
WAT E R R E S I S TA N C E 9
Q UA L I T Y C O N T R O L 9
N
SEP OV
Y
JAN
R MA
MA
INSTRUCTIONS
JUL
M A N U A L LY W O U N D
The winding crown is used to wind the watch and to set
the time. Your watch has a manually wound movement. We
recommend that you wind your watch every day at about the
same time, preferably in the morning (about 15 clockwise turns
of the crown).
Caution: Please wind the watch before you put it on. This
way you avoid lateral pressure on the crown tube which in the
course of the years could wear the tube out. Turn the crown
gently and uniformly and stop when you feel resistance; if you
wind the watch too vigorously, it might damage the movement.
SETTING THE TIME
This is accomplished by pulling the crown outwards to the
hand setting position. This will simultaneously engage the
hack mechanism feature, therefore the second’s hand will stop
running in order to enable the precise setting of the seconds.
Turn the crown till the hands indicate the right time (only
possible clockwise for Urban Jürgensen
P8 movement). In
some situations the watch might need a slight twisting motion
to start the movement running again.
4
MOVEMENTS P4 + P8
Y
N
SEP OV
R MA
MA
JAN
JUL
P O W E R R E S E RV E I N D I C AT O R
This new patented system uses a differential gearing and
forms an important addition to a precision movement, visually
indicating the mainspring’s state of winding. The power reserve
indicator hand will move up as the mainspring is being wound.
When fully wound, the hand will stop moving at “UP” (circa 60
hours power reserve). As the watch unwinds, the indicator’s
position will show the power reserve left in the mainspring. To
insure the best chronometric results, it is advisable to rewind
your watch before the indicator reaches the last quarter
segment of the scale. In fact it may happen that the watch
stops before the main spring is completely unwound; this is
natural, as the spring is also affected by temperature.
R MA
MA
MOON PHASE CORRECTION
The moon-phase display advances in the morning. Its
mechanism is active between 9 and 11 a.m. Please do not
attempt to adjust the moon phase in this time period. Each time
the push piece at 10 o’clock is actuated, the moon-phase disk
will advance by one day. To begin the correction procedure,
advance the moon-phase disk until a full moon is displayed in
the middle of the aperture. Consult a moon-phase calendar or
visit www.urbanjurgensen.com to find out how many days have
elapsed since the last full moon (including the day on which you
correct the display). To correctly set the moon-phase display,
press the push piece as many times as the number of days that
have elapsed since the last full moon.
5
INSTRUCTIONS
Y
N
SEP OV
R MA
MA
JAN
JUL
P E R P E T UA L C A L E N DA R
The perpetual calendar indicates the date, the day of the week,
and the month. It will change correctly in a month with 30 or
31 days, and also in February with 28 days. In leap years when
February has 29 days it will automatically add an extra day.
The date, day, and month are complemented by a leap year
indication and a moon-phase display, which is so accurate that
it deviates from the true lunar cycle by only one day in 122
years. If the watch is wound daily, the perpetual calendar will
not require any corrections before February 28, 2100, which
is a secular year that by exception omits the 29th of February.
ADJUSTING THE PERPETUAL CALENDAR
The perpetual calendar change mechanism is active between
10 PM and 2 AM and the moon phase between 12 noon and
2 PM. During these time periods please do not attempt to
adjust the calendar or the moon phase. It could damage the
mechanism.
In order to avoid damage please follow these
steps carefully.
1.
If the watch has stopped wind it by turning the crown 15
times in clockwise direction.
2.
Pull the crown in setting position and turn the time forwards
until you see the date and day of the week change.
3.
Turn the hands 6 hours’ forwards to approximately 6
o´clock in the morning. In this position you can set all
functions without any risk of damaging the movement.
4.
To set the month and date, press the correction push
piece at 4 o’clock gently as many times as needed to
display the correct month and date.
6
MOVEMENTS P4 + P8
5.
To set the day of the week, press the correction push piece
at 8 o´clock gently as many times as needed to display the
correct day of the week.
6.
To set the moon phase, press the correction push piece at
10 o´clock as many times as needed to display the correct
moon phase.
If the watch has not been worn for a long time and correction of
the leap year indication is necessary. Follow instructions above
carefully except at point 4.
Which changes to:
To set the month, date and leap year, press the correction push
piece at 4 o´clock gently as many times as needed to display
the correct month, date and leap year (4 = leap year, 1 = 1st
year after a leap year, 2 = 2nd year after a leap year, 3 = 3rd
year after a leap year). After all adjustments are made set the
watch forwards to the actual time.
SHOULD YOU ADVANCE THE DATE TOO FAR
The movement of the watch may be stopped by pulling out the
winding crown to the hand-setting position and leaving it in this
condition until a day after the displayed day has passed. Then
by turning the hands forwards, past midnight, the calendar
indications can be corrected. Bearing in mind the a.m./p.m.
time, the watch can finally be set to the correct time.
You may also do the basic adjustment all over by following the
instructions above.
In case of doubt consult either a registered Urban Jürgensen
dealer or call the Urban Jürgensen After Sales service.
7
INSTRUCTIONS
S E RV I C E
Your watch has a robust and durable movement, therefore
servicing is only recommended every 5 to 6 years if the watch is
being worn on a daily basis. The watch should only be serviced
by Urban Jürgensen S.A. Switzerland or by officially authorised
service points. If non-authorized service has been done the
warranty will be void. Our watchmakers will test, clean, oil
and adjust the movement according to Urban Jürgensen
specifications. Case, and buckle will be cleaned and polished.
Dial restoring will only be carried out on request. Please accept
that the service procedure might require anywhere from a few
weeks to a couple of months. Upon completion your watch
will be in like new condition, and it will be returned with a new
one-year guaranty.
C E RT I F I C AT E O F A U T H E N T I C I T Y
Your watch is delivered with a certificate of authenticity that
indicates the movement and case numbers. The certificate is
valid only if it is dated, stamped and signed by an authorized
Urban Jürgensen retailer. It guarantees the authenticity
of your watch and validates your warranty privileges for a
period of 5 years after the date of sale. The unique movement
and case numbers of each watch are registered in the
Urban Jürgensen workshop journals. With this information,
you may also register your watch in the owners section on the
website: www.urbanjurgensen.com.
8
MOVEMENTS P4 + P8
WA R R A N T Y
Urban Jürgensen guarantees your watch against any manufacturing defect for a period 5 years as from the date of sale.
For warranty to be effective it is essential that the authorised
retailer where you purchased the watch has dated, signed and
stamped the certificate of authenticity.
WAT E R R E S I S TA N C E
Your watch is sealed in order to protect the movement from
dust and moisture and to prevent damage in case of exposure
to water. Nonetheless, we recommend that you prevent direct
contact with water, especially if your watch is fitted with a
leather strap.
Q UA L I T Y C O N T R O L
Movements and fully assembled watches are subject to a series
of technical tests and visual inspections to verify the accuracy,
winding ease, power reserve, reliability, water resistance, and
overall appearance. After it was assembled, your watch has run
for several weeks before leaving our atelier.
9
Urban Jürgensen reserves the right to modify the information
in this booklet at any time.
Refer to www.urbanjurgensen.com for the latest information.
Urban Jürgensen. Chemin Creux 18. 2503 Biel/Bienne. Switzerland.
Tel: +41 32 365 15 26. Fax: +41 32 365 22 66.
1015
H O N O U R I N G
T I M E L E S S
T R A D I T I O N S
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising