Bouncepad Floorstanding

Assembly Instructions

Tools you’ll need...

a b c d

Tools Key a b c

10mm Spanner / Adjustable Wrench

Socket Screwdriver iPad Transformer (supplied with your iPad, use where necessary) d

What’s in the box?

1

Note your key number

2

3

4

5 6

10 11 12 13

8

Components Key

10

11

8

9

12

13

5

6

3

4

77

1

2

Base Cover with Cover Collar

Floorstanding Base

Floorstanding Pole

Secure Case

Key x 2

2m / 78 ” USB Cable

T20 Driver Bit / T20 Pin Torx Driver Bit

P22 Driver Bit

Case Washer

M6 Washer x 4

M6 Hex Nut x 4

M4 x 25mm / 1” Pin Torx Buttonhead Security Screw x 4

M6 x 25mm / 1” Pozi Countersunk Pozi Screw x 4

9

1

Attach the Floorstanding Pole to the Floorstanding Base.

Ensure the cable channel is positioned towards the rear of the unit. If you wish to secure the unit to the floor, use the four M6 sized countersunk holes in the Floorstanding Base, using a screw that is suitable for your floor material.

11

10 a

3

13

2

Front

2

Slide the Base Cover over the Floorstanding Pole. Align the cable notch in the Base Cover with the cable channel in the

Floorstanding Base.

1

3

Attach the Secure Case to the Floorstanding Pole.

Be sure to fully engage all screws in their threads before tightening. Always use a hand screwdriver for this step. b

9

11

7

Take care on installation, the face of the Secure Case may scratch if in contact with tools.

4

You can mount the case portrait or landscape.

UK +44 (0) 20 3693 0000 [email protected] l USA 1-888-423-3885 [email protected] l DE +49 (0) 30 6098 5170 [email protected] I © 2014 Bouncepad Spotspot Ltd. All rights reserved.

4a

Feed the supplied cable through the Floorstanding Pole.

6

4b

After the cable is fed through the Pole and Base, place plastic platform into position, resting the cable on top.

1 d c

5

To increase the length of your power cable (optional). Firstly, remove the plug attached to your iPad Transformer and connect to the Power Extension Cable. Feed the supplied USB cable through the

Floorstanding Pole, then connect to the PowerExtension Cable via your iPad Transformer (supplied with your iPad).

d

6 c

6

Complete the alignment of the Bouncepad. Firstly, l oosen the four screws (shown below) slightly and align the case to be horizontal.

W hen the case is aligned, tighten screws up again using a hand screwdriver.

7

Unlock and remove the face of the Secure Case.

8

Connect cable to Tablet and place into Secure Case. Your

Bouncepad is set up to house the tablet model specified in your order. If you need to use a different tablet, please contact us for a conversion kit.

9

Lock the face of the Secure Case back into place.

5

Installation guidelines. To minimise glare on the screen, avoid installing the Bouncepad directly below a source of light.

Maintenance of your Bouncepad. To keep your Bouncepad looking its best, clean regularly with screen wipes.

1070mm / 42 “

(height from the ground to the centre of the screen)

UK +44 (0) 20 3693 0000 [email protected] l USA 1-888-423-3885 [email protected] l DE +49 (0) 30 6098 5170 [email protected] I © 2014 Bouncepad Spotspot Ltd. All rights reserved.