Vehicles Wires Alambres Del Vehículo Câblage De
Vehicles Wires
Alambres Del Vehículo
Câblage De Véhicule
Black
Negro
Noir
Upgraded Harness
Arnés Mejorado
Faisceau De Câbles Amélioré
Blue & Yellow
Orange & Black Anaranjado Y Negro Azul Y Amarillo
Bleu ET Jaune
Orange ET Noir Black & White
Negro Y Blanco
Noir ET Blanc
(Thin Black)
Gray/Gris/Gris
Purple
Malva
Mauve
White Purple & WhiteDark Blue & White
Blanco Malva Y BlancoAzul Oscuro Y Blanco
Blanc Mauve ET Blanc
Bleu Fonce ET Blanc
Orange & Green
Anaranjado Y Verde
Orange ET Vert
(Thick Black)
Black/Negro/Noir
Thin Black
Negro Delgado
Noir Mince
Gray
Gris
Gris
Purple
Malva
Mauve
Thick Black
Negro Grueso
Epais Noir
Sender Ground
Puesta A Tierra Del
Transmisor
Mise A La Masse Du
Capteur De Niveau
D’Essence
Pump Power
Alimentación De
La Bomba
Alimentation De
La Pompe
Sender Signal
Señal Del
Transmisor
Signal Du Capteur De
Niveau D’Essence
Pump Ground
Puesta A Tierra De
La Bomba
Mise A La Masse De
La Pompe
Toll Free Tech Hotline: 1-855-827-7732
New Harness
Installation
Instructions
Your new Precise fuel pump comes equipped with
an improved connector and wiring harness. On the
back side of this page you will find detailed colorcoded instructions for matching the old vehicle wires
to the new improved harness. It is critical that you
follow these instructions carefully; disregarding
these instructions may result in pump failure and
subsequent warranty denial.
sample of Old Vehicle
Harness connector
sample of New improved
Vehicle Harness connector
SAMPLE OF Old Design
SAMPLE OF New IMPROVED design
Harness replacement instructions:
1.Disassemble the wires from the vehicles
protective wiring loom.
2.Cut back wires in vehicle’s harness
approximately 6-8 inches from harness
connector in order to have the finished
harness close to the original length. (Make
sure the cuts are staggered 2-3 inches apart
so they will fit neatly back in the wiring loom).
3.Strip ¼ inch of wire from both the wiring
harness as well as the vehicle wires using a
wire stripper.
Old Harness
connector
NEW IMPROVED
connector
4.Match the wires using the color coded
diagram illustrated on the back side of this sheet.
5.Using the included butt connectors, insert
and crimp the wire to make a tight connection using a wire crimping tool.
(There are two size butt connectors
included with your harness; make sure to
match the proper connector for the wire size).
Top view
Top view
side view
side view
The harness is now ready to be installed.
Photos for illustration purposes only. Your Fuel Pump Assembly may look different than above.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising