CAL. VD51
TIME/CALENDAR
l Hour, minute and second hands
l Date displayed in numerals
ENGLISH
NPWA64_E.indd 1
CAL. VD51
CHRONOGRAPH
STOPWATCH
l Measures up to 60 minutes in 1-second increments
l Split time measurement
13/01/25 13:5
DISPLAY AND CROWN/BUTTONS
STOPWATCH second hand
Hour hand
50
55
60
5
45
40
10
15
SEC.
35 30 25
20
a
b
c
5
Second hand
50
55 60 5
45
40
CROWN
10
Date
15
MIN.
35 30 25
a: Normal position
b: First click
(date setting)
c: Second click
(time setting)
20
B
1 Turn Crown counterclockwise until you no
longer feel the threads turning.
2 Crown can be pulled out.
Locking the crown
1 Push Crown back in to normal position.
English
English
Unlocking the crown
Minute hand
A
SCREW DOWN CROWN
[for models with screw down crown]
2 Turn Crown clockwise while pressing it
lightly until tight.
STOPWATCH minute hand
2
NPWA64_E.indd 2-3
3
13/01/25 13:53
lBefore setting the time, be sure to check that the STOPWATCH second
and minute hands return to the “0” position when the stopwatch is
reset.
If any STOPWATCH hands do not return to the "0" position when the
stopwatch is reset, reset the positions of the STOPWATCH hands by
following the procedure below.
STOPWATCH second hand
4
NPWA64_E.indd 4-5
60
10
45
40
A
5
15
SEC.
35 30 25
20
A
OR
B
5
55 60 5
10
50
45
40
15
MIN.
35 30 25
20
B
s
Case 1 If the stopwatch is measuring, press the button A to stop
it, and then press the button B to reset it.
Case 2 If the stopwatch is stopped, press the button B to reset
it.
Case 3 If the split time is displayed, press the button B to return
the display to the normal display mode, and press the
button A to stop the stopwatch. And then, press the
button B again to reset it.
55
50
STOPWATCH minute hand
Pull out to the s ec on d
click.
Press to reset the position of the
STOPWATCH second hand to
the "0" position.
Press to reset the position of the
STOPWATCH minute hand to
the "0" position.
English
English
HOW TO RESET THE STOPWATCH
If the stopwatch is in use, press the buttons in the following order
to reset it, and then, check if the STOPWATCH hands are at the "0"
position.
CROWN
s
STOPWATCH HAND POSITION ADJUSTMENT
The hand move quickly if the
re s p e c t i v e b u t t o n s a re ke p t
pressed.
CROWN
Push back in to the normal
position.
5
13/01/25 13:53
TIME SETTING
CROWN Pull out when the second hand is at
Second hand
stopped.
Hour hand
Second hand
CROWN Pull out to the first click.
55
English
10
50
15
SEC.
35 30 25
20
5
55 60 5
10
50
45
40
15
MIN.
35 30 25
20
Date
Minute hand
6
NPWA64_E.indd 6-7
Do not set the date between 9:00
P.M. and 1:00 A.M. Otherwise, the
date may not change properly.
If it is necessary to set the date
d u ri n g th at ti m e p e ri o d , fi rst
c h a n g e th e ti m e to a ny ti m e
outside it, set the date, and then
reset the time to the correct time.
15
SEC.
35 30 25
20
5
55 60 5
CROWN Turn to set the hour and minute
hands to the desired time.
10
50
45
40
45
40
day’s date appears.
5
10
45
40
When the crown is at the second click
position, do not press any button, as doing
so will start the stopwatch .
5
15
MIN.
35 30 25
Hour hand
20
When setting the hour hand, check that the
AM/PM is correctly set.
When setting the minute hand, first
advance it 4 to 5 minutes ahead of the
desired time and then turn it back to the
exact minute.
CROWN
English
60
60
50
CROWN Turn clockwise until the previous
55
the 12 o’clock position.
The second hand will stop on the spot.
Minute hand
lBefore setting the time, check that the stopwatch measurement is
Push back in to normal position in
accordance with a time signal.
7
13/01/25 13:53
STOPWATCH
Standard measurement
Ex) Bascketball game
5
10
45
40
A Start / Stop / Restart
15
SEC.
35 30 25
20
B Reset
B
A
s
NPWA64_E.indd 8-9
MIN.
35 30 25
B
s
8
15
s
10
s
40
B
RESET
• Restart and stop of the stopwatch can be repeated as many times as
necessary by pressing the button A.
Split time measurement
A
STOPWATCH
minute hand
A
STOP
(Game over)
Ex) 5,000m race
20
55 60 5
50
45
A
RESTART
(Restart of game)
English
60
A
STOP
(Time out)
s
A
START
s
English
Accumulated elapsed time measurement
s
55
50
B
RESET
STOP
(Start of game)
STOPWATCH
second hand
A
s
A
START
s
If the STOPWATCH hands do not return to the "0" position when the stopwatch is
reset to "0", follow the procedure in "STOPWATCH HAND POSITION ADJUSTMENT".
Ex) 100m race
s
lThe stopwatch measures up to 60 minutes in 1-second increments.
lThe measured time is indicated by the STOPWATCH hands that move
independently of the hands for time display.
l Before using the stopwatch, be sure to check that the crown is set at the
normal position and that the STOPWATCH hands are reset to the “0”
position.
B
START
SPLIT
SPLIT RELEASE
STOP
RESET
• Measurement and release of the split time can be repeated as many times
as necessary by pressing the button B.
9
13/01/25 13:53
After the battery is replaced with a new one, or in case any of the hands should move
improperly, follow the procedure below to reset the hands to the “0” position.
Battery life : Approx. 2 years
CROWN Pull out to the second click.
: SEIKO SR920SW
50
55
60
5
45
NPWA64_E.indd 10-11
AND
5
50
55 60 5
45
40
10
15
MIN.
35 30 25
20
A
The STOPWATCH minute hand
moves correspondingly with the
STOPWATCH second hand.
The hands move quickly if the
respective buttons are kept
pressed.
B
Press and hold simultaneously
B for 2 seconds or longer.
The STOPWATCH second hand
turns half a circle counterclockwise,
and then returns to where it was.
Press to reset the position of
the STOPWATCH second hand
to the "0" position.
Press to reset the position of
the STOPWATCH minute hands
to the "0" position.
CROWN Turn to set the hour and minute
hands to the desired time.
s
10
20
s
l If the stopwatch is used for more than 60 minutes a day, the battery life may be less
than the specified period.
l As the battery is inserted at the factory to check the function and performance of
the watch, its actual life once in your possession may be less than the specified
period.
lWhen the battery expires, be sure to replace it as soon as possible to prevent any
malfunction.
l We recommend that you contact an AUTHORIZED PULSAR DEALER for battery
replacement.
l After the battery is replaced with a new one, adjust the stopwatch hand position and
set the time.
A
15
SEC.
35 30 25
English
English
40
10
s
Battery
s
2
Years
lNecessary procedure after battery change
s
BATTERY CHANGE
CROWN Push back in to normal position. 11
13/01/25 13:53
WARNING
children. If a child swallows it, consult a doctor immediately.
lNever short-circuit, tamper with or heat the battery, and never expose it to fire. The battery may burst, become very hot or catch fire.
CAUTION
l The battery is not rechargeable. Never attempt to recharge it, as this
may cause battery leakage or damage to the battery.
12
NPWA64_E.indd 12-13
WATER RESISTANCE
l Non-water resistant
If “WATER RESISTANT” is not
inscribed on the case back, your
watch is not water resistant, and
care should be taken not to get
it wet as water may damage the movement. If
the watch becomes wet, we suggest that you
have it checked by an AUTHORIZED PULSAR
DEALER or SERVICE CENTER.
l Water resistance (3 bar)
I f “ WATER RESISTA N T ” i s
inscribed on the case back,
your watch is designed and
manufactured to withstand up
to 3 bar, such as acci­d ental
contact with splashes of water or rain, but it
is not designed for swimming or diving.
l Water resistance (5 bar)*
If “WATER RESISTANT 5 BAR”
is inscribed on the case back,
your watch is designed and
manufactured to withstand up
to 5 bar and is suitable for swimming, yachting
and taking a shower.
l Water resistance (10 bar/15 bar/20
bar)*
If “WATER RESISTANT 10 BAR”,
“WATER RESISTANT 15 BAR” or
“WATER RESISTANT 20 BAR” is
inscribed on the case back, your
watch is designed and manufactured to withstand
up to 10 bar/15 bar/20 bar and is suitable for taking
a bath, shallow diving, but not for scuba diving.
We recommend that you wear a PULSAR Diver’s
watch for scuba diving.
13
English
English
l Do not remove the battery from the watch.
lIf it is necessary to take out the battery, keep it out of the reach of
TO PRESERVE THE QUALITY OF YOUR WATCH
13/01/25 13:53
NOTE:
Pressure in bar is a test pressure and should not be considered as
corresponding to actual diving depth since swimming movement tends
to increase the pressure at a given depth. Care should also be taken on
diving into water.
TEMPERATURES
Your watch works with
5
stable accuracy within a
temperature range of 5° C
5
and 35° C (41° F and 95° F).
Te m p e r a t u r e s o v e r
50° C (122° F) may cause battery
leakage
or
shorten the battery life.
14
NPWA64_E.indd 14-15
Do not leave your watch in very low
temperatures below –5° C (+23° F)
for a long time since the cold may
cause a slight time loss or gain.
However, the above conditions will
be corrected when the watch returns
to normal temperature.
MAGNETISM
Yo u r w a t c h w i l l b e
adversely af fected by
strong magnetism. Keep
it away from close contact
with magnetic objects.
SHOCKS & VIBRATION
CARE OF CASE AND BRACELET
To prevent possible rusting of
the case and bracelet caused by
dust, moisture and perspiration,
wipe them periodically with a
soft dry cloth.
PERIODIC CHECK
Light activities will not
It is recommended that the
affect your watch, but be
watch be checked once
every 2 to 3 years. Have
careful not to drop your
your watch checked by an
watch or hit it against
AUTHORIZED PULSAR
hard surfaces, as this
may cause damage.
DEALER or SER­
V ICE CENTER to
ensure that the case, crown, buttons,
CHEMICALS
gasket and crystal seal remain intact.
Be careful not to expose
PRECAUTION REGARDING
the watch to solvents,
CASE BACK PROTECTIVE FILM
mercury, cosmetic spray,
detergents, adhesives
If your watch has a
or paints. Otherwise,
protective film and/or a
the case, bracelet, etc. may
sticker on the case back,
become discolored, deteriorated or
be sure to peel them off
damaged.
before using your watch.
English
English
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the
crown is pushed in completely.
Do not operate the crown when the watch is wet or in water. If used in sea water,
rinse the watch in fresh water and dry it completely.
* When taking a shower with the water resistance 5 bar watch, or taking a bath with
the water resistance 10, 15 or 20 bar watch, be sure to observe the following:
• Do not operate the crown when the watch is wet.
• If the watch is left in warm water, a slight time loss or gain may be caused.
This condition, however, will be corrected when the watch returns to normal
temperature.
15
13/01/25 13:53
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising