city select lux

city select lux
Stroller
©2017 baby jogger PD349711E 6/17
ASSEMBLY INSTRUCTIONS
babyjogger.com
EN
1
4
17
3
2
5
5
15
21
20
14
21
20
13
6
18
9
7
19
19
12
8
11
16
10
1
Handlebar
12
Front Wheel Release Button
2
Handlebar Adjustment Button
13
Footwell
3
Parking Brake
14
Harness Buckle
4
Parking Brake Lock
15
Harness Pads
5
Seat Mounting Bracket
16
Storage Lock
6
Rear Wheel Release Button
17
Canopy
7
Rear Wheel
18
Seat Recline Button
8
Storage Basket
19
2nd Seat Adapter Mounting Slots
9
Footwell Adjustment Button
20
Quick Fold Handles
10
Front Wheel
21
Accessory Mounting Slots
11
Swivel/Lock
2
1
2
3
4
5
6
7
8
3
9
10
11
12
13
14
B
C
A
15
CLICK
4
16
17
18
19
20
21
22
5
CLICK
23
24
CLICK
25
26
CLICK
27
28
6
29
30
31
32
33
35
34
7
EN
36
37
38
8
WARNING
IMPORTANT - Keep these instructions for
future reference.
Read these instructions carefully before
use. Your child’s safety may be affected if
you do not follow these instructions.
•Accessories which are not approved by
Baby Jogger shall not be used.
•Watch out for cars - never assume that a
driver can see you and your child.
•The passenger shall remain seated (no
standing in the stroller).
•It may be unsafe to use replacement
parts other than those supplied or
approved by Baby Jogger.
• Always keep fingers away from moving parts when folding, unfolding, or adjusting the stroller to prevent finger/
body part entrapment or pinching.
WARNING: TO AVOID INJURY OR
DEATH:
• ALWAYS APPLY THE BRAKES
WHENEVER THE STROLLER IS
STATIONARY.
• DO NOT LEAVE CHILDREN
UNATTENDED.
• SECURE THE CHILD IN THE HARNESS
AT ALL TIMES.
• DO NOT CARRY EXTRA CHILDREN OR
BAGS ON THIS STROLLER.
• MAKE SURE CHILDREN ARE CLEAR OF
ANY MOVING PARTS IF YOU ADJUST
THE STROLLER.
WARNING: USE THE HARNESS AT ALL
TIMES.
WARNING: USE THE STRAP TO STOP
THE STROLLER ROLLING AWAY.
SINGLE STROLLER
•This stroller seats one passenger.
WARNING: NOT RECOMMENDED
FOR A CHILD UNDER 6 MONTHS
OLD. Maximum weight is 45 lb (20 kg);
maximum height is 40 in (101.6 cm).
•Total weight load recommended for this
stroller is 57 lb (26 kg). 45 lb (20 kg)
in the seat, 2.2 lb (1 kg) in the seat back
pocket, and 15 lb (7 kg) in the basket.
WARNING: This stroller is not suitable for
running, jogging, skating or rollerblading.
WARNING: Never leave your child
unattended.
WARNING: Always use the restraint
system.
WARNING: Check that the pram
body or seat unit attachment or car
seat attachment devices are correctly
engaged before use.
WARNING: To avoid injury, ensure that
your child is kept away when unfolding
and folding this product.
WARNING: Do not let your child play
with this product.
WARNING: Parcels or accessory items, or
WARNING: Never leave the harness
both, placed on the unit may cause the
buckled when not fitted to a child. The
unit to become unstable.
harness can form loops that pose a
WARNING: Any load attached to the
strangulation hazard to the child.
handle affects the stability of the
WARNING: Do not use stroller near
pushchair.
open fires or exposed flames.
•This seat should be used in the most
WARNING: The stroller is designed for
reclined position until a child can sit up
flat or gently sloping surfaces and may
unaided, roll over, or push itself up on it’s
become unstable on higher sloping and
hands and knees.
uneven surfaces. Care should be taken
•Stroller is not meant to be used for
by the parent to prevent the stroller from
transporting children up or down stairs,
tipping over.
travelators or escalators. Damage
resulting to stroller will not be covered
under warranty.
•This stroller does not replace a cot or
a bed. Should your child need to sleep,
then it should be placed in a suitable
pram body, cot, or bed.
9
EN
EN
FRAME
1Unpack the stroller frame from the box
and set the wheels aside. Unlock the
stroller by pulling the Storage Lock Lever.
2 Lift the Handlebar away from the lower frame. The stroller will click into place.
3Place the stroller in the upright position.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
4Installation
• L ay stroller on its back so the
Handlebar is resting on the floor.
•A
ttach the Front Wheel by sliding it
into the front wheel mount until it
clicks. Gently pull on the Front Wheel
to make sure it is properly attached.
5Removal
•W
hile pressing the front wheel release
button, gently slide the Front Wheel
out of the front wheel mount.
SWIVEL FEATURE
6Press the Swivel Lock button down
and slide the Swivel Lock to the left to
lock the front wheel assembly in a fixed
position for long distance strolling.
7Press the Swivel Lock button down
and slide the Swivel Lock to the right
to allow the front wheel assembly to
swivel.
WARNING: When loading and unloading child, lock the front wheel in a fixed position. Although the front wheel of your stroller locks, it is not intended for jogging or exercise purposes.
REAR WHEELS
8Installation
• Align the Rear Wheel axle with the
wheel mount on the stroller frame
and insert it into the wheel mount
until it clicks into place.
• Gently pull on the Rear Wheel to
make sure it is properly attached.
9Removal
• While pressing the Wheel Release
Button, gently slide the Rear Wheel
out of the wheel mount.
BRAKE
10 To engage quick brake squeeze on the brake lever.
11To Lock the Brakes: gently push the
Brake Lever forward until it clicks into
place.
12To Release the Brakes: Pull the Parking
brake lock towards you.
WARNING: Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving.
13 If the rear wheels are not breaking
together evenly, you may adjust the
stroller’s brakes. The brake for the
wheel that continues to spin even while
breaking must be tightened: Locate
the adjuster on the wheel hub (A) with
the loose brakes. Loosen the brake’s
short ring (B) to adjust the long cylinder
ring (C). Unscrew the long cylinder
ring further from the wheel hub (A) to
tighten the cable. (Please do not over
tighten!) To lock the rings, tighten the
short ring (B) against the wheel hub (A)
while holding the long cylinder ring (C)
in place.
Squeeze the Hand Brake gradually to
give you better control over your stroller.
SEAT - UNFOLD THE SEAT
14Holding the footwell and the top of the
seat, open the seat.
15The seat will lock into its open position.
CANOPY
16Attach the canopy to the frame: Attach
the Canopy’s brackets to the sides of
the seat frame.
17 Attach the 2 fastening strips on the canopy to the top of the seat.
ADJUSTING SAFETY HARNESS
18From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper. Turn
stopper and pass through the openings
in the PE board and seat fabric.
19Reinsert stopper at seat opening closest
to child’s shoulders. Pass back through
seat fabric and PE board. Tug on strap
to ensure stopper is locked. Repeat on
both sides.
10
WARNING: Avoid serious injury from
falling or sliding out. Always properly
adjust and fasten safety harness.
WARNING: Always use the crotch strap
in combination with the shoulder straps
and waist belt.
20Slide the Harness Pads up to access
plastic guide on strap.
21Hold the plastic guide and pull strap to
tighten or loosen.
USING SAFETY HARNESS
22Insert side strap buckle into harness
buckle on both sides.
23Insert connected harness and side strap
buckles into the sides of the crotch
buckle.
24Press button on crotch buckle to
release.
PLACE THE SEAT ON THE FRAME
25Align the Accessory Mounting Brackets
with the mounting brackets on the
stroller frame.
26Slide the seat into the brackets until it
clicks into place. Ensure that both sides
of the seat are securely fastened into
the frame before use.
NOTE: The seat may be installed either
forward-facing or rear-facing.
REMOVE THE SEAT
27Press gray tabs on Mounting Brackets
and pull up.
WARNING: Always remove your child
from the seat before removing the seat
from the frame.
RECLINE THE SEAT
28Squeeze the Seat Recline Button
located at the top of the seat, behind
the canopy.
29Pull down to lower the seat and pull up
to raise the seat until it clicks into the
desired position.
HANDLE HEIGHT ADJUSTMENT
30Squeeze the Handle Adjustment Button
and slide the handle up or down to the
desired length.
ADJUSTABLE FOOTWELL
31Adjust the angle: Press the Adjustment
Buttons on the Footwell and move it up
or down until it clicks into the desired
position.
BASKET REMOVAL
32Unfasten the top snaps of the Basket
around the middle support bar of the
frame. Then unfasten the bottom snaps
around the side support bars of the
frame.
33Unhook the top front plastic loop from
over the metal knob on the back of the
frame. Repeat for the opposite side.
FOLDING
•Remove your child from the seat.
• The stroller may be folded with or without the seat attached, and forward-
facing or rear-facing.
• When folding rear-facing, it is recommended that the seat be reclined all the way before folding.
• Always recline the seat to its most
upright position and place it in the
forward-facing for the most compact
fold.
34 Pull up on the seats footwell and fold the seat upwards.
35Pull up on the quick fold handles and let the frame collapse. Push down on
the stroller frame with your thumb to
make lifting the quick fold handels
easier. Make sure the storage lock lever
clicks into place.
• The stroller should be carried by holding
the frame in a secure and balanced
position to avoid any potential injuries
from falls.
REMOVING THE SEAT FABRIC
36 Unsnap the seat fabric from the seat
frame.
37 From the back of the seat, unfasten the hook-and-loop and slide the strap
through the D-ring.
38Press the Footwell Adjustment Buttons
and pull out on the Footwell to remove the footwell bar from the seat frame.
Pull the seat fabric out of the channel in the Footwell bar.
11
EN
EN
CARE AND MAINTENANCE
To preserve the longevity of your stroller,
it is important to perform simple, regular
maintenance. From time to time, make sure
that the joints and folding areas are still in
good condition. If you hear any squeaking
or feel tension, you can take your stroller
to a local bike shop for added lubrication.
All repairs should only be carried out by an
authorized dealer.
WASHING
Seat Fabric
•You can machine wash your stroller’s
seat in cold water with a mild detergent.
•Be sure to remove the metal frame and
PE boards from the seat before washing.
•Do not use solvents, caustic or abrasive
cleaning materials.
•To minimize shrinkage, simply reattach
the seat to the frame to dry.
•Do not press, iron, dry clean, tumble dry
or wring the fabric.
•If the seat covers need to be replaced,
only use parts from a Baby Jogger
Authorized Dealer. They are the only
ones that are guaranteed to have been
safety tested and designed to fit this
seat.
Plastic/Metal Parts
•Wipe clean using a mild soap and warm
water.
•You must not remove, dismantle or alter
any part of the seat folding mechanism
or brakes.
Wheel Care
•The wheels can be cleaned using a
damp cloth. They will need to be dried
completely with a soft towel or cloth.
12
STORING
•Sunshine can fade seat fabric and dry
out tires, so storing your stroller indoors
will prolong its good looks.
•DO NOT store outside.
•Ensure that the stroller is dry before
storing for prolonged periods.
•Always store the stroller in a dry
environment.
•Store the stroller in a safe place when
not in use (i.e. where children cannot
play with it).
•DO NOT place heavy objects on top of
the stroller.
•DO NOT store the stroller near a direct
heat source such as a radiator or fire.
REGISTER YOUR STROLLER ONLINE AT
www.babyjogger.com/register
Baby Jogger’s Limited Lifetime Warranty:
Baby Jogger warrants that the frame is free of manufacturer defects for the lifetime of
the product. Manufacturer’s defects include but are not limited to the breaking of welds
and frame tube damage. Textile or soft side materials and all other components shall be
warranted for one year from the date of purchase (except for tubes and tires). Proof of
purchase is required to make a warranty claim and the warranty is only extended to the
original purchaser.
THIS WARRANTY DOES NOT COVER:
• Normal wear and tear
• Corrosion or rust
•Incorrect assembly, or the installation of third party parts or accessories not compatible with the original design
• Accidental or intentional damage, abuse or neglect, or use on stairs or escalators.
• Commercial use
• Improper storage/care of the unit
This warranty specifically excludes claims for indirect, incidental, or consequential
damages. The implied warranties of merchantibility and fitness for a particular purpose is
according to the specific warranty period for this model unit at time of purchase. Some
states do not allow the exclusion or limitation of incidental or consquential damages, so
the above limitations or exclustions may not apply to you. This warranty gives you specific
legal rights, and you may also have other rights which vary from state to state. To know
what your legal rights are in your state, consult your local or state consumer affairs office
or your State’s Attorney General.
If your stroller was purchased outside of the United States, please
contact the distributor in the country nearest you. Their contact
information can be found on our website at http://www.babyjogger.
com/retailers/#international. Claims for warranty outside of the
country in which the product was purchased may incure shipping
charges.
NOTE: When contacting Baby Jogger distributor regarding your stroller,
please have your stroller’s serial number and manufacturing date
ready. It can be found on the right fold mechanism.
IN AUSTRALIA CONTACT:
Call: 1300.661.885
Fax: 03.9873.1433
Mail: The Amazing Baby Company
11 Maurice Court
Nunawading, Victoria 3131
Australia
IN NEW ZEALAND CONTACT:
Call: (64) 03.338.7613
Fax: (64) 03.338.7615
Mail: Baby First Limited
10 Moncur Place
Middleton
Christchurch, 8024
New Zealand
13
EN
NOTES:
14
NOTES:
15

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project