METAL GRILL FEATURING HIGH HEAT MAX page 1 of 2 Heat up your next outdoor gathering with this Krylon® High Heat Max grill project. PROJECT TIME 1 hour SKILL LEVEL 1 2 3 4 5 MATERIALS Krylon® High Heat Max Aluminum All-purpose cleaner/degreaser Sandpaper or wire brush Rag Drop cloth INSTRUCTIONS 1 Set up a spray area by covering work area with a drop cloth. Make sure it is a well-ventilated area. 2 Prep surface by sanding any rough areas. If there are areas with flaking rust, use a wire brush to remove it. 3 Thoroughly clean the grill and lid with an all-purpose cleaner/degreaser, making sure that there are no remnants of grease or drippings from food on the surface. Rinse with water and allow to dry. 4 Tape off handles, grilling grate and any other surfaces that you do not want to paint. 5 Remove the lid from the grill, painting the items separately. 6 Holding the can of Krylon High Heat Max - Aluminum 6-8 inches from the surface, begin painting using a sweeping side-to-side motion with slight overlap. Painter’s tape (continued on next page) METAL GRILL FEATURING HIGH HEAT MAX page 2 of 2 Heat up your next outdoor gathering with this Krylon® High Heat Max grill project. PROJECT TIME 1 hour SKILL LEVEL 1 2 3 4 5 INSTRUCTIONS 7 Allow paint to dry for 30-60 seconds. 8 Continue to apply light, multiple coats, waiting 30-60 seconds between each, until you are satisfied with the appearance. 9 NOTE: Do not apply paint to the inside of the grill lid, to the inside base if it is a charcoal grill, or onto the grill grate on which food is placed. 10 Krylon High Heat Max dries to the touch in 10 minutes and to handle in about an hour. 11 Allow to dry overnight before using.