Legrand Wiremold UL2065BD 24-Outlet 15-Amp Industrial Power Strip, 15 ft. Cord Instructions / Assembly

Perma Power Computer Grade Surge Protectors from Wiremold / Legrand
are available in impact resistant housings and in lengths up to 13 1/4"
[337mm]. All Perma Power Computer Grade Surge Protectors are Listed or
Recognized by Underwriters Laboratories under File No. E66421 and all 15A
Units are CSA Certified under File No. LR62645. All units are in compliance
with the National Electrical Code and the Canadian Electrical Code.
Computer Grade Surge Protectors
INSTALLATION INSTRUCTIONS
j
Installation Instruction No.: INSPPR01R3 – Updated March 2007
TYPICAL INSTALLATION:
All Perma Power Computer Grade Surge Protectors from Wiremold / Legrand conform to and should be installed and properly grounded in compliance with requirements of the
current National Electrical Code, Canadian Electrical Code or codes administered by local authorities. CAUTION: All electrical products may represent a possible shock or fire
hazard if improperly installed or used. Do not plug into another relocatable power tap. The 3-prong, grounding type plugs in all units are for use with 3-prong, grounded
receptacles only. Modifying or bypassing the ground pin for use in a non-grounded receptacle or plugging into another relocatable power tap may lead to electrical shock, is not
recommended and voids the product warranty. All units are designed for interior use in dry locations only. Check all local and national electrical codes for proper installation.
MOUNTING INSTRUCTIONS:
SNAP-ON/SLIDE-OFF:
Screw mounting clips
into mounting surface
on a straight line.
Measure 1" [25mm] in
from each end of the
unit. Place unit’s mounting rails in
one side of mounting clips and
snap in position so unit is flush with mounting
surface. To remove unit, simply slide it out
of clips.
KEYHOLE MOUNTING:
Measure distance from
center of keyhole slots.
Mark this distance on the
surface to be mounted.
Install mounting screws into surface. Leave
screw head about 1/8" [3mm] above surface.
Place unit over screws. Slide unit left, right or
down to secure it in position.
.
PHONE/FAX/DATA LINES:
Install surge protector
according to instructions
above. Insert one end of the
6' [1.8m] phone/fax/data cord
(provided) into wall jack.
Insert other end into the “LINE
INPUT” jack on the surge
protector. Insert one end of the phone/fax/data cord,
from the equipment to be protected, into the “LINE
OUTPUT” jack on the surge protector. Insert the other
end into the appropriate jack on the equipment.
About your Perma Power Product: Each unit is 100% tested prior to packaging. All Surge Suppressors feature electrical and mechanical grounding
and a resettable circuit breaker for overload protection. All units are rated 15 Amps, 120 volts, 60 Hz.
About your Surge Protector: Perma Power surge protectors are designed to protect electronic equipment from the destructive effects of surges, spikes
and noise. However, a surge protector is not a lightning arrestor and does not protect equipment in the rare instance that lightning actually strikes the
building service entrance or antenna. All surge suppressors feature a surge indicator light which indicates that the unit is operating at full protection.
Troubleshooting: If you are receiving no power to your Perma Power product, first make sure the unit is plugged firmly into your wall outlet. Plug the
unit into a different wall outlet to verify the condition. If there is still no power, the built-in circuit breaker may need to be reset. If you are still having
problems, please call technical support at 1-800-736-8739.
Surge Protector Warranty Information:
All Perma Power Computer Grade Plug-In Surge Protectors offer a Five-Year Product Warranty and $10,000 Connected Equipment Warranty.
Wiremold / Legrand will repair or replace, at our discretion, any Perma Power plug-in surge protector which proves to be defective up to five years from
the date of purchase. In addition, Wiremold / Legrand will reimburse the original owner of a registered Perma Power Computer Grade Surge Protector for
damage caused to any properly connected equipment by an AC surge if the surge protector is found to be at fault, up to a maximum of $10,000.*
All Perma Power Computer Grade Rack Mount Surge Protectors offer a Five-Year Product Warranty. Wiremold / Legrand will repair or replace, at our
discretion, any Perma Power Computer Grade Rack Mount Surge Protector which proves to be defective up to five years from the date of purchase.
*Consult enclosed Warranty Card for complete details.
Wiremold / Legrand
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S. 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
© Copyright 2007 Wiremold / Legrand All Rights Reserved
INSPPR01R3 – Updated March 2007 – For latest specs visit www.wiremold.com