PAG Quasar Charger

PAG Quasar Charger
DATA SHEET
PAG Quasar Charger
PAGLOK LI-ION CHARGER & CAMERA POWER SUPPLY
• Fast, sequential charging for Li-Ion and Ni-MH PAGlok batteries
• Available with or without integral 50W camera power supply
• Automatic Charge Rate Selection
• Li-Ion Battery Recovery Program
• Ultra-compact, lightweight, and robust
DESCRIPTION
The two-channel PAG Quasar is an ultra-compact unit that
incorporates a multi-chemistry fast-charger with a 50W
camera power supply, making it the ideal location charger.
The Quasar features two PAGlok connectors and is
specifically designed for charging Li-Ion and Ni-MH PAGlok
batteries. It incorporates two PP90 sockets that allow the
charging of PAG and Sony V-Mount Li-Ion and Ni-MH
batteries, via PAG charge adaptors. See Specification below
for the correct Charge Adaptor Model No.
The Quasar features a Li-Ion charge program that is
instigated by PAG intelligent Li-Ion batteries. For non-Li-Ion
batteries, the Quasar features Auto Charge-Rate Selection.
The charge rate is determined by the battery’s cell-chemistry,
state-of-charge, capacity, condition and cycle history.
The Quasar applies the best charge regime to achieve a fully
charged battery with the maximum capacity and cycle life.
Alternatively, the charge rate can be manually selected.
This PAG developed technology is unique to PAG chargers.
The PAG Quasar charges sequentially, and is so efficient that
in some cases two batteries can be fully-charged in less time
than it takes a simultaneous charger, which shares current
equally across the channels.
The Quasar is available with a built-in camera power supply
that provides a nominal 50W output, for powering a
professional broadcast camera. In this mode the screen
displays an accurate digital bar-graph of power consumption.
S P E C I F I C AT I O N
Recovery Charge:
This special program conditions the battery for
a period of one hour. The charger will then
automatically enter the Main Charge program,
which will run until the battery is fully charged.
This program also recovers PAG Li-Ion
batteries when the internal safety protection
circuit has tripped.
PAG Quasar Charger / Power Supply
Model 9752
PAG Quasar Charger
Model 9726
Battery Connectors:
• 2 x PAGlok.
• 2 x PP90 *
Ancillary Charging Programs:
The following programs may be automatically
entered after charging:
• Balancing Charge.
• Self-adjusting Maintenance Charge
(not applied to PAG Li-Ion batteries).
* PP90 (2.1mm) connectors (polarised
connector suitable for 2.1mm coaxial DC
power connectors. NOTE: centre pin
negative).
Range of Batteries Charged:
• PAGlok Lithium-Ion batteries.
• Nickel-Metal Hydride batteries having
nominal voltages of between 4.8V and
14.4V, and nominal capacities of between
1Ah and 10Ah.
• Nickel-Cadmium batteries having nominal
voltages of between 4.8V and 14.4V, and
nominal capacities of between 1Ah and
10Ah.
Self Test Program:
The internal microcomputer constantly
monitors the battery under charge or process
as well as the operation of the charger’s own
functions which will be shut down to a safe
condition should any of the tests fail.
Mains Input:
100-250V~. Frequency 47-63 Hz. Maximum
power consumption 100W.
Charge Adaptors:
Model 9617
PAG V-Mount
Li-Ion/Ni-MH batteries
Model 9610
Sony V-Mount
Li-Ion batteries
Main Charge Program:
• Auto Mode - automatically selects the
correct charge current.
• Manual selection - 2A or 3A charge
current.
• Li-Ion voltage-charge program only
available with PAG intelligent batteries or
suitable PAG intelligent adaptor. PAG
intelligent batteries automatically over-ride
the Auto Mode or Manual selection, and
control their own charge regime.
Output Protection:
Charger protected against short circuit, open
circuit, excess battery voltage and reverse
battery voltage.
AC Mains Failure Protection:
Should mains failure occur during a charging
program, or whilst the charger is connected, it
will shut down to a safe condition.
Safety:
Designed to comply with electrical safety
standard EN60065 and UL6500.
NOTE: U.K. mains leads are fitted with a 1"
fuse to BS1362 rated 5A as standard.
European Union Directives:
Complies with the following EU Directives:
• EMC Directive 89/336/EU.
• Low Voltage Directive 73/23/EU.
Operating Temperature Range:
0°C to 40°C (+32°F to +104°F).
Dimensions:
Height: 72mm (2.8").
Width: 135mm (5.3").
Depth: 185mm (7.3").
Weight: 882g (1.94lbs approx.).
Camera Power Supply (Model 9752 only):
Operation:
The camera power supply function is operated
by connecting the camera to the charger’s
power supply output connector. Charging is
suspended whilst the power supply is in use.
Output:
13.5V to 15V DC, 3.7A (50W nominal), for
powering a camera only.
Output Connector:
XLR4F (pin 1 neg. pin 4 pos.).
User Interface:
PAG Quasar is simple to operate, with a large
backlit LCD display which shows the charge
rate, the charge program, battery cellchemistry, battery voltage, discharge capacity
and charge loaded. The front panel
incorporates a soft function switch for the
selection of programs and interrogation of
charge data.
PAG Ltd.
565 Kingston Road
London SW20 8SA
United Kingdom
E [email protected]
T +44 (0)20 8543 3131
F +44 (0)20 8540 4116
www.paguk.com
© NOV 2014 PAG Ltd. PAG is the trademark of PAG Ltd.
PAG reserves the right to change the specifications
contained herein without notice
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement