Ceramic Sinks
Ceramic Sinks
Installation
Customer Care Department • The
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu
www.cda.eu
Installation
Before Installation
Offer up the sink to the worktop and/or the cabinets to confirm that
the external dimensions of the bowl are compatible with the cabinets
themselves.
Confirm that with the sink in position:
•
There is adequate space to install any taps or other required
accessories.
•
There is adequate space to install the waste pipework and that any
necessary modification to internal shelves to accommodate the waste
(and trap) is acceptable.
•
Access to any water stop-cock or other services will still be adequate
after the installation.
Cutting the tap hole
Only cut/punch the tap hole from the top face of the sink.
•
Select the tap hole position based on whether left hand or right hand
drainer is required.
•
Locate the centre of the required tap hole by transferring
measurements from the cast in features on the underside. Cover the
top of the tap hole cut-out area with masking tape.
•
Caution: Ensure that the sink is supported under the hole to be cut
out.
•
Using a centre punch and hammer, make an initial cud in the glaze at
the centre of the required hole.
•
Still using the punch and hammer enlarge the cut to the full hole size
required for the tap by carefully chipping away.
2
Installation
•
Refer to the cut-out sizes on the back of this manual and use them
to mark out where the worktop needs to be cut. Double-check the
dimensions before cutting the worktop aperture.
•
After cutting out the worktop aperture, we recommend you seal the
cut edges with silicone (or similar) sealant to help prevent ingress of
water.
•
It is often easier to mount the taps, waste-fitting and overflow onto the
sink prior to fitting the sink to the worktop.
•
Position the sink on the worktop, bedding it into a bed of silicone
sealant.
•
After positioning the sink, leave it untouched for 24 hours to allow
the sealant to cure before any water is run into it.
•
The taps, waste-fitting and overflow can now be mounted onto the
sink (if not already done) and fully connected to their respective
services.
•
To check the waste for leaks, close the plug/basket of the waste
fitting, open the tap and fill the sink to the level of the overflow; turn
off the tap and wait several minutes to verify that the water doesn’t
drain away.
•
Empty the sink.
After fitting, ensure that the enclosed “Ceramic Sinks Use and
Maintenance” guide is retained for the customer and/or user of the
sink.
E & O E. All instructions, dimensions and illustrations are provided for guidance only. CDA reserve the
right to change specifications without prior notice.
3
Cut-Out Dimensions
1010
480
510
970
KC23 &
KC24
1010
485
510
985
KC73 &
KC74
Please contact our Customer Care Department for Service on the details below
Customer Care Department
The
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : [email protected]
Customer Care Department • The
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu
Copyright © CDA 2015
www.cda.eu
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement