UNITY TABLE LAMP SERENITY TABLE LAMP INCLUDES THE

UNITY TABLE LAMP SERENITY TABLE LAMP INCLUDES THE
INSTALLATION INSTRUCTIONS
Model:
TF1904, TF1930
Fixture Family:
UNITY TABLE LAMP
Document Description: Unity and Serenity Table Lamp
TF1904, TF1930 Series Luminaires
1717 West Civic Drive Milwaukee, WI 53209
414-354-6600
Design Modification Rights Reserved
© Visa Lighting
Drawing: 761969XX
Eng: MJB
TF1904 (UNITY)
TF1930 (SERENITY)
Sheet: 1 of 2
INCLUDES THE
FOLLOWING
CONFIGURATIONS:
Rev: C
UNITY TABLE LAMP
SERENITY TABLE LAMP
Date Drawn: 07/12/10
!
When using electrical equipment, basic safety precautions should always be followed, including the following:
• Read all instructions carefully before installing and save for future use.
• Make sure all connections are in accordance with the National Electrical Code and local regulations.
• To avoid possible electric shock, be sure the power supply is turned off before servicing or installing the fixture
• Service should be performed by qualified personnel.
• These instructions may not cover all details or variations. If additional information is needed, please contact Visa Lighting.
INSTALLATION INSTRUCTIONS
Model:
TF1904, TF1930
Fixture Family:
UNITY TABLE LAMP
Document Description: Unity and Serenity Table Lamp
TF1904, TF1930 Series Luminaires
TYPICAL FIXTURE
1717 West Civic Drive Milwaukee, WI 53209
414-354-6600
Design Modification Rights Reserved
© Visa Lighting
FINIAL
Drawing: 761969XX
Rev: C
Sheet: 2 of 2
1/4" PIPE NIPPLE
9/16"
Eng: MJB
MOUNTING SURFACE
1-1/2"
LOCK NUTS
1.
2.
NOTE:
1.
2.
!
Drill 9/16" diameter mounting holes in mounting surface at 1-1/2" on center.
Lower 1/4" pipe nipple through mounting holes. Place clamp plate in position and secure table lamp
in place by tightening lock nuts.
1/4" pipe nipple length protruding from base of table lamp may be adjusted by turning the 1/4" pipe nipple
clockwise or counter clockwise.
If with top lens, remove protective coating from lens. Remove finial layon lens and secure shade and lens
with finial.
When using electrical equipment, basic safety precautions should always be followed, including the following:
• Read all instructions carefully before installing and save for future use.
• Make sure all connections are in accordance with the National Electrical Code and local regulations.
• To avoid possible electric shock, be sure the power supply is turned off before servicing or installing the fixture
• Service should be performed by qualified personnel.
• These instructions may not cover all details or variations. If additional information is needed, please contact Visa Lighting.
Date Drawn: 07/12/10
CLAMP PLATE
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement