Owner’s

Manual

ARTICA

TOP FREEZERS

BOTTOM FREEZERS

FREEZERS

REFRIGERATORS

CONTENTS

2 Unpacking and Installation

3 Electrical Installation

3 Models

3 Refrigerators

4 Operating the Refrigerator

4 Freezers

4 Freezing Guide

5 Defrosting

5 Cleaning

6 Maintenance

6 Service www.defy.co.za

INTRODUCTION

Congratulations on the purchase of this quality appliance.

We, the manufacturer, trust that you will enjoy many years of trouble free use. Please read these instructions carefully before using the refrigerator. This book will provide you with information on how to operate and care for your appliance in order that you gain the maximum benefit from it.

UNPACKING

•

•

•

Please ensure that packaging material is disposed of in a responsible manner. Plastic bags for example should be cut up to prevent children playing with them and accidentally suffocating.

If the appliance is damaged in any way, do not use it. Report the damage to your dealer, who will take the necessary corrective action.

INSTALLATION

•

•

The appliance should be positioned in a dry, well aired place away from heat sources such as stoves, geysers and direct sunlight.

It is essential to level the unit by turning the two adjustable levelling feet at the front of the unit either in or out.

It is advisable to adjust the cabinet so that it tilts slightly backwards. This will assist the doors to close by themselves. It will also ensure proper drainage of defrost water from the cold plate

Spirit level Spirit level

Front view

Side View

ELECTRICAL INSTALLATION

This appliance uses a 220-250V/50 Hz power supply.

Use only a 15 amp 3 pin plug.

If the mains power cord is damaged, it must be replaced by a qualified electrician.

This appliance must be earthed and the manufacturer and the seller do not accept responsibility for any damage due to incorrect electrical connection.

MODELS

Defy manufactures a number upright models in various configurations.

Please determine which type you have purchased and read only the appropriate instructions

as indicated by the numbers 1,2,3,4 or 5

REFRIGERATORS – MODELS 1 2 4 5

Switching on and setting the temperature

• Push the 15-amp plug into an earthed wall socket and switch on the power.

•

•

Ensure that the thermostat (located at the interior lamp housing) is not in the OFF position.

A setting midway on the dial should generally give satisfactory results.

• Should it be required, the thermostat may be turned to the right for a lower and to the left for a higher temperature.

OPERATING THE REFRIGERATOR – MODELS 1 2 4 5

Storage guide

• Do not cover the shelves with paper or anything which could prevent airflow between the shelves.

•

•

•

The shelves may be adjusted up or down depending on storage requirements. Pull the shelf forwards and out.

Reposition at a different level.

A bottle gate facility in one of the shelves, when hinged upwards, allows tall items to

•

•

• protrude through the shelf into the space above.

Avoid placing food wrapped in paper against the cold plate at the back of the refrigerator. The paper could freeze to the plate and later, during defrosting, slide into and block the defrost water drain located in the trough below the cold plate.

Foods with strong aromas should be stored in sealed containers to prevent flavour transfer to other foods.

Separate vegetable crispers enable non-compatible foods to be stored without one tainting the other.

FREEZERS – MODEL 3

Freezer thermostat (setting the temperature).

• The freezer thermostat is located on the kick panel and may be adjusted by inserting a coin in the slot and turning the knob to the desired setting

A setting midway on the dial should generally give satisfactory results but should it be required, the thermostat may be turned to the right for a lower and to the left for a higher temperature.

FREEZING GUIDE – MODELS 1 2 3 5

•

•

•

•

•

•

•

•

•

•

Operate the freezer for 12 hours before loading it.

If you are loading bulk into the freezer, load one quarter at a time and allow to freeze before loading the next quarter.

Divide food into reasonable portions according to your requirements.

Allow hot food to cool before putting it in the freezer.

Seal all foods, or place in airtight containers to prevent dehydration.

Remember, liquids can increase in volume when frozen. Do not store sealed bottles, jars or cans in the freezer as the contents will freeze, expand and rupture the container.

Do not exceed the expiry date shown on food packs.

Where fitted, the storage baskets may be partially or completely pulled out to facilitate loading.

The calendar on the inside of the freezer door serves as a guide and shows the safe storage period ( in months ) for the depicted foods.

The ice scraper, supplied and fitted to the freezer door, may be used to assist the defrosting process.

DEFROSTING – MODELS 1 2 3 5

•

•

•

•

•

•

•

•

Refrigerators and refrigerator sections defrost automatically.

Freezers and freezer sections need to be defrosted periodically, or whenever the frost build up inside the freezer reaches a thickness of 4 mm.

Switch off the power at the wall socket.

Remove contents and store in a cool place.

Leave the door open during defrosting.

When the frost begins to soften, wipe it up.

Model 3 has a drain extension piece stored on the freezer door. Push this into position at the bottom of the freezer and place a shallow container below the drain. Allow the defrost water to drain into the container before disposing of it.

When defrosting is complete, clean and dry out the unit. Replace the shelf / baskets and the frozen food.

• Switch on the power at the wall socket and resume normal operation.

Caution

Never attempt to scrape frost or ice off the freezer walls with a sharp object. Use only the plastic ice scraper provided.

WARNING:

If the appliance is fitted with a lock, always keep the key in a safe place where small children cannot reach it.

CLEANING

•

•

•

•

•

•

•

•

•

Always disconnect the plug from the mains socket before cleaning the appliance.

Remember that turning the thermostat to “0” does not switch the power off to the unit.

Clean the inside of the appliance whenever necessary using a solution of warm water and Bicarbonate of Soda. (1 tablespoon to every 2 litres of water).

Dry with a soft cloth.

Do not use pot scourers or abrasive powders to clean the appliance.

Spillages, especially citric and acidic juices, must be wiped up immediately as they could stain the product.

Always ensure that the defrost drain, below the cold plate in the refrigerator compartment, is clean and free of obstructions.

Shelves and freezer baskets, where fitted, may be removed for cleaning purposes.

The back of the unit may be vacuumed or dusted using a soft bristle brush.

A mild furniture polish may be used on the exterior cabinet to add lustre and protect against finger marks.

Moisture formation

• If the refrigerator or freezer is located in a hot and humid area, and the door is opened

• frequently, water droplets or dew may form on the interior walls of the appliance.

This has no effect on the performance and the water may simply be wiped up using an absorbent cloth.

Replacing the lamp bulb.

•

•

•

•

Unplug the power cord at the wall socket.

Unclip the light cover by gently pulling the rear edge forward.

Unscrew the bulb and replace it with a new bulb ( not exceeding 15 watts ).

Replace the light cover by inserting the clip on its front edge into the slot of the thermostat housing and then snapping in the clip on the rear edge.

MAINTENANCE

Owner’s responsibility

Since the following are not factory faults they are the owners responsibility:

•

•

•

Damage to the exterior finish.

Breakage of glass and other components.

Replacement of light bulbs.

•

•

•

Damage caused through improper use of the appliance.

Damage caused by moving the appliance.

Blocked defrost drain (refrigerator section).

SERVICE

Before calling a service technician to assist with a problem, please check:

• Is the thermostat in the OFF position? The thermostat should be set to an ON

• position.

Is the power switched OFF? The power should be ON.

•

•

Has a house fuse blown or a circuit tripped out? Repair or re-set as necessary.

Is the 15-amp plug pushed firmly into the wall socket? Check another appliance such as a toaster or kettle in the same socket.

•

•

Has the door been left open for a long time? Close the door and monitor performance.

Is the drain hole below the cold plate blocked? Clean out the hole with a suitable flexible wire and then pour a small quantity of Bicarbonate of Soda and water solution down the hole to rinse away any remaining debris.

Remember that you may be charged for a service call, even during the warranty period, if the fault is caused by any of the above

If you have followed the instructions and still have a problem, contact the nearest

Defy Service Centre. They will be able to advise you on any aspect of the machine or send a qualified technician to repair it.

The manufacturer strives for continuous improvements. For this reason, the text and illustrations in this book are subject to change without notice

Part Number 061 636