AN103
ADK0061 Dev Kit User Guide
Introduction
Thank you for purchasing the HSS™ A0061 15 input Development kit from AlSentis L.L.C. This kit provides the means to
evaluate, design, and troubleshoot with the A0061 IC from AlSentis. The Dev Kit can be used in conjunction with Touch
Studio software or stand alone in your design as a first pass prototype.
ADK0061 Development Kit Contents
The ADK0061 Development kit consists of 2 components:
Controller Board
1 - A0061 Controller Board
2 - 15 button Evaluation Panel
Evaluation Panel
© 2013 AlSentis®
Document Number AN103 Rev 1.00
AN103
A0061 Controller Board
The A0061 Controller Board consists of 3 main circuits:
1 - Power Supply
Input: +5, 9, 0r 12Vdc / 100 ma
DC Jack 2.1mm I.D. / 5.5mm O.D. Center terminal +Vdc
2 - Sensor IC
15 HSS™ Touch Sensor buttons
0.100” - 16 pin header connector to connect the evaluation panel or any other sensor board
3 - Address and Communication
3 address jumpers for multi-chip I2C communication
0.100” - 6 pin header connector for the Alsentis USB to I2C bridge
Power Supply
Address and
Sensor IC
Communication
© 2013 AlSentis®
Document Number AN103 Rev 1.00
2
AN103
A0061 Evaluation Panel
The A0061 Evaluation Panel consists of 3 pieces:
1 - 2mm Plastic Substrate with Graphics
2 - 15 electrode Sensor PCB
3 - Connector
16 Pos. Sullins PPTC161LGBN-RC
Sensor Number
GND
0
© 2013 AlSentis®
1
2
3
4
5
6
7
8
9
Document Number AN103 Rev 1.00
10
11
12
13
14
3
AN103
© 2013 AlSentis®
Document Number AN103 Rev 1.00
4
">
