LED Flood Light With PIR Sensor

LED Flood Light With PIR Sensor

Please read in full before installation and keep for future reference

Safety/General Information

• This product is for outdoor use only.

• Do not mount this product on flammable or conductive surfaces.

• Ensure the power supply is switched off before fitting or servicing.

• This product contains glass, take care while installing.

• This product can become hot during use, allow to cool before handling.

• This product must be fitted in accordance with current IEE wiring regulations.

• If you are unsure about any aspect of the installation of this product, please consult a qualified electrician.

• Remember to recheck all electrical connections at each stage of installation

• This product must be earthed.

Maintenance instructions

• This product contains no user serviceable parts.

• Periodically wipe any dirt or debris away from the exterior housing to ensure even heat dissipation.

Required Tools

Masonry Drill

8mm drill bit

Philips Screwdriver

Wire clippers

Small Terminal Screwdriver

Suitable wall plugs

INSTALLATION

1.

Determine a location to install your LED floodlight.

2.

Ensure that the mains electrical supply is switched off before any installation work begins. If required remove the circuit fuse or MCB.

3.

Mark the drill holes locations on the wall by aligning the unit’s bracket against the wall.

4.

Connect the loose ends of the wire to an IP rated

Junction box or similar device ensuring the polarities of

Live, Earth and Neutral are correctly connected.

When creating connections, make sure the terminals are secured tight and that no wires are protruding.

5.

Switch on the electricity and check all connections.

6.

Angle the floodlight as required and fix into place.

Lighting Range

PIR SENSOR

General information

• Do not obstruct the PIR sensor

• Surfaces that reflect light (high visibility workwear etc.) can cause the PIR sensor to behave erratically

• Ensure the area you want the sensor to work in is free of objects that may move, such objects may trip the sensor.

• Do not attempt to open or tamper with the sensor housing

Over ride feature

If you require the light to remain illuminated you can over ride the PIR sensor.To do this, switch off the power to the unit for 3 seconds and then switch back on. The light will now remain on. To disable this function, turn the unit off again for 20 seconds and then turn back on. THe unit will now function as normal.

SENS

This option adjusts the sensitivity of the PIR sensor. If for example the light is switching on when people are walking by your property then you would reduce this, if you have a wide area you want to cover then the sensor will need to be increased. (This setting does not generally need to be adjusted)

TIME

Adjusts the amount of time that the light remains switched on after the sensor detects movement.

* Min 5 seconds (+/- 1 sec) Max 6 mins (+/- 1 min)

LUX

Determines the amount of ambient light required for the sensor to become active. The Maximum setting will make the light switch on at all times of the day. The Minimum setting will cause the unit to only work at night time.

Setup

* Please note- Each installation of this sensor light will have several variables (area of coverage, obstacles etc.) meaning there is no defined setup process, a method of trial and error will be required on the part of the user.

•

Point the sensor in the general direction you require it to cover

(see image below for clarification). Please note that the angle of the PIR can affect the detection range.

•

•

Adjust the SENS, TIME, LUX to the desired settings, ideally this should be performed at the approximate time of day you will require the unit to become active.

The unit may need to be periodically adjusted to account for seasonal changes in light.