Battery Charger Specification
Battery Charger Specification
Model No.: PFC001
Document No.: JSC002
1 Scope:
This specification is applicable to Pairdeer Battery Charger for 2 or 4 AA/AAA Ni-MH/Ni-Cd Batteries, PFC001,
distributed by ZHONGYIN (NINGBO) BATTERY CO., LTD.
2 Product Features
2.1 Battery Type
Two (2) independent 2.8VDC channels, each channel charges two (2) batteries. Batteries could be charged
only in pairs.
2.2 -dv cut off
The high sensitivity -dv detector stops charging once it detects the batteries are fully charged.
2.3 Defective and Non-rechargeable battery detection
This function protects the charger if you attempt to charge defective or non-rechargeable batteries. Charging
alkaline batteries is not recommended and may cause battery leakage or even more hazardous.
2.4 Reverse Polarity Protection
The electrical circuit protects the charger and batteries from being damaged by incorrectly installed batteries.
2.5 Over Current Protection
Maintain a constant charging current during the charging cycle. (Value referred to section 3.1.2)
2.6 Timer Control Protection
The charger automatically detects the correct charging time and the main charging current changes to a trickle
current. The charger always shuts off the main charging current and switches to trickle charge after 3 hours
(Input DC12V) or 6 hours (Input 5VDC), regardless of the charging time.
2.7 Over Temperature Protection
Protect the batteries from being damaged by overheating (60℃±10℃).
2.8 Low Battery Leakage Current
If the battery charger is not connected to input power and left in the charger, the charger will discharge the
batteries using a pre-determined current. (Value referred to section 2.1.5)
2.9 Trickle Charge After Full Charge
After batteries are fully charged, a small current will be applied to the batteries. (Value referred to section
2.1.3)
2.10 Short Circuit Protection
If one attempts to charge shorted batteries, the indicator will flash alternately
2.11 Zero Voltage Jump Start
Restore the battery if the battery voltage is 0V
2.12 Charging Indicators
Red LED on : Charging
Green LED on :Fully charged and trickle charging.
Red LED Flashing :
- Defective batteries or Non-rechargeable battery
- Short circuit
Revision: A0
Tech. Dept. of Zhongyin (Ningbo) Battery Co., Ltd.
Add: 99 Dahetou St., Duantang, Ningbo, P.R.China
Tel: 86 574 87491087 Fax: 86 574 87493903
WebSite:http://www.sonluk.com
Page 1 of 7
2008-08-15
Battery Charger Specification
Model No.: PFC001
Document No.: JSC002
3. Electrical Performance and Tests
3.1 Charging Unit
3.1.1 Input
Input voltage 12V (Adapter or car plug) or 5V(PC USB)
Input current: Iin≥1A
3.1.2 Charging current
12Vdc Input
AA*2/*4: 800-1000mA (Standard: 900mA)
AAA*2/*4: 400-600mA (Standard: 500mA)
5Vdc Input
AA*2/*4: 400-600mA (Standard: 500mA)
AAA*2/*4: 200-400mA (Standard: 300mA)
3.1.3 Trickle charge current
AA: 50mA ±10%
AAA: 30mA ±10%
3.1.4 Charging voltage
Two (2) independent 2.8VDC channels, each channel charges two (2) batteries. Charges only in pairs.
3.1.5 Battery leakage current
0.5mA MAX
3.1.6 Short circuit protection
Io<10mA
3.2 AC To DC Adapter
3.2.1 Input voltage
100~240Vac 47~63Hz
3.2.2 Output voltage
12Vdc±10%
3.2.3 Output current
≥1000mA
3.3 Car plug
3.3.1 Output voltage
10.8~16Vdc
3.4 PC USB
3.4.1 Output voltage
5Vdc±5%
3.4.2 Output current
≥1000Ma
Revision: A0
Tech. Dept. of Zhongyin (Ningbo) Battery Co., Ltd.
Add: 99 Dahetou St., Duantang, Ningbo, P.R.China
Tel: 86 574 87491087 Fax: 86 574 87493903
WebSite:http://www.sonluk.com
Page 2 of 7
2008-08-15
Battery Charger Specification
Model No.: PFC001
Document No.: JSC002
4. Mechanical Tests and Requirements
4.1 Drop test
Drop from a height of 3 feet onto a concrete floor covered with 1/8 inch vinyl tile. Drop 3 times total, each time
on a different product surface.
Expected result: The unit should still meet section 2.1.2.requirements
4.2 Surface
Damage and rusting are not permitted.
5 Operating and Storage Conditions
5.1 Operating Temperature
-5℃~40℃/20%~90% RH (Non Condensing)
5.2 Storage Temperature
-25℃~80℃/10%~95% RH (Non Condensing)
5.3 -△V Precision Control:
≤5mV
5.4 Time Control:
3h±10%
5.5 Temperature Control
60±10℃
6 Safety and Environment Regulations
CE/ROHS compliant
7. Product Inspections
7.1 Inspections of all products
- Charging voltages (3.1.4)
- Charging current (3.1.2)
- LED indicators (2.12)
- Outside intense vibration
- Polarity of charging channel
- Surface (4.2)
- Charging AA or AAA at least once (@25 oC)
7.2 Inspections of selected products
- Over current protection (2.5)
- Over temperature (2.7)
- Drop test (4.1)
Revision: A0
Tech. Dept. of Zhongyin (Ningbo) Battery Co., Ltd.
Add: 99 Dahetou St., Duantang, Ningbo, P.R.China
Tel: 86 574 87491087 Fax: 86 574 87493903
WebSite:http://www.sonluk.com
Page 3 of 7
2008-08-15
Battery Charger Specification
Model No.: PFC001
Document No.: JSC002
8. Cautions
•
•
•
•
•
•
•
•
Children should use product only under adult supervision.
Mixing batteries of different capacities and sizes in the charger may influence the charging times or
damage the batteries.
Correctly insert the batteries and avoid reversing the +/- polarities.
Cut off power after the batteries are fully charged.
The charger is intended for use with Ni-MH/Ni-Cd batteries only. Charging other battery types may
cause explosions, breakage, personal injury or property damage.
Incorrect use may result in electric shock
For indoor use only. Keep away from humid and hot places.
Do not disassemble or reassemble the charger.
9. Charging Times
Battery Type
AA Ni-MH
AA Ni-MH
AAA Ni-MH
AA Ni-Cd
AA Ni-Cd
AAA Ni-Cd
Battery capacity
2000mAh
1500mAh
600mAh
1000mAh
800mAh
300mAh
Revision: A0
Tech. Dept. of Zhongyin (Ningbo) Battery Co., Ltd.
Add: 99 Dahetou St., Duantang, Ningbo, P.R.China
Tel: 86 574 87491087 Fax: 86 574 87493903
WebSite:http://www.sonluk.com
Page 4 of 7
Time
Input 12V
Input 5v
2.7h
2h
1.4h
1.3h
1.1h
43min
4.8h
3.6h
2.4h
2.4h
2h
1.2h
2008-08-15
Battery Charger Specification
Model No.: PFC001
Document No.: JSC002
10. Mechanical Drawing
Unit: mm
65.0
28.9
47.0
109.5
52.0
2.0
2.0
Revision: A0
Tech. Dept. of Zhongyin (Ningbo) Battery Co., Ltd.
Add: 99 Dahetou St., Duantang, Ningbo, P.R.China
Tel: 86 574 87491087 Fax: 86 574 87493903
WebSite:http://www.sonluk.com
Page 5 of 7
2008-08-15
Battery Charger Specification
Model No.: PFC001
Document No.: JSC002
11 Figure of Unit Product Sales Packaging
Revision: A0
Tech. Dept. of Zhongyin (Ningbo) Battery Co., Ltd.
Add: 99 Dahetou St., Duantang, Ningbo, P.R.China
Tel: 86 574 87491087 Fax: 86 574 87493903
WebSite:http://www.sonluk.com
Page 6 of 7
2008-08-15
Battery Charger Specification
Model No.: PFC001
Document No.: JSC002
History and Deviation of Revision
Revision History
Revision
A0
Date
2008-8-15
By
Revision: A0
Tech. Dept. of Zhongyin (Ningbo) Battery Co., Ltd.
Add: 99 Dahetou St., Duantang, Ningbo, P.R.China
Tel: 86 574 87491087 Fax: 86 574 87493903
WebSite:http://www.sonluk.com
Description of Change
New release
Page 7 of 7
2008-08-15
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising