Culligan RVF 10 Water Filter System Installation Instructions

Below you will find brief information for Water Filter System RVF 10. The RVF-10 system reduces foul tastes, odors, and sediment from potable drinking water. It includes 3/4" flexible hose couplings and the NCP-10 replacement cartridge. This system may reduce water flow slightly.

PDF Download
Document
Culligan Water Filter System RVF 10 Installation Instructions | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Reduces foul tastes, odors, and sediment
  • Includes 3/4" flexible hose couplings
  • NCP-10 replacement cartridge
  • Easy installation
  • Cartridge replacement instructions
  • Troubleshooting guide
  • May reduce water flow slightly
  • Protect from freezing
  • Do not use with microbiologically unsafe or unknown quality water

Frequently asked questions

Follow the instructions on the first page of the manual. Make sure to use Teflon tape and tighten fittings securely, but not too tightly. Install the system between two hoses, connecting the outlet to the storage tank inlet and the inlet to the water faucet.

Turn off the water supply, depress the red pressure relief button, unscrew the filter housing, remove and discard the existing cartridge, rinse and scrub the housing and cap, replace the O-ring with petroleum jelly, place the new cartridge in the housing, screw it back onto the cap and flush the system.

If leaks occur between the cap and bottom of the housing, clean the O-ring, lubricate it with petroleum jelly and replace it securely. If leaks occur at the inlet/outlet connections, tighten the fittings 1/2 turn. If leaks persist, contact Technical Support at 1-800-721-9243.
Preparing document for printing…
0%