π H-1886 INDUSTRIAL LAMINATOR

π H-1886 INDUSTRIAL LAMINATOR
π H-1886
INDUSTRIAL
LAMINATOR
1-800-295-5510
uline.com
WARNING! For your protection, do not
connect the laminator to electric power
until you read these instructions.
Instructions
Before operating the laminator, please review the
following guidelines.
4. Place the item to laminate into the pouch. Then
place the pouch into the carrier.
1. Determine the correct temperature setting for the
pouch you intend to laminate.
5. Press the AMBER READY/RUN switch ON. The motor will
engage and the rollers will begin turning.
2. Set temperature control to the prescribed setting.
6. Insert the carrier into the front opening of the
laminator. Insert the carrier lengthwise, folded edge
first, straight into the opening.
NOTE: For first time operation, set the
temperature to the lower end of the
recommended temperature range and test
lamination. If the pouch is not properly sealed,
the temperature can be raised slightly and
the pouch can be reprocessed at the higher
temperature. If the temperature is set too high,
the pouch and/or item being laminated may
be damaged.
3. Turn GREEN POWER switch ON. Allow the laminator
to warm up for approximately 2 minutes. Once
laminator’s temperature is ready, the AMBER
READY/RUN switch light will begin to blink indicating
the laminator is ready to laminate.
π
7. The carrier will exit the rear of the laminator when the
process is completed.
POUCH / TYPE
SETTING
3 MIL Pouch With Carrier
#1 to #2
5 MIL Pouch With Carrier
#2 to #3
7 MIL Pouch With Carrier
#3 to #4
10 MIL Pouch With Carrier
#3 to #4
NOTE: Start at the lowest temperature.
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
0814 IH-1886
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement