Features • Frequency response shaped specifically

Features • Frequency response shaped specifically
Features
• Frequency response shaped specifically for kick drums and bass instruments
• Built–in dynamic locking stand adapter with integral XLR connector simplifies
setup, especially inside a kick drum
• Studio quality performance, even at extremely high sound pressure levels
• Supercardioid pattern for high gain before feedback and superior rejection of
unwanted noise
• Hardened steel mesh grille that resists wear and abuse
• Advanced pneumatic shock mount system that minimizes transmission of
mechanical noise and vibration
• Neodymium magnet for high signal–to–noise ratio output
• Low sensitivity to varying load impedance
• Legendary Shure quality and reliability
Specifications
Type
Dynamic (moving coil)
Frequency Response
20 to 10,000 Hz
NOTE: The curve below shows onaxis response at a distance of 2 feet from a
uniform sound source. Your response may vary, depending on microphone
position.
Polar Pattern
Supercardioid, rotationally symmetrical about microphone axis
Output Level (at 1,000 Hz)
Open Circuit Voltage: -64 dBV/Pa* (0.6 mV)*1 Pa = 94 dB SPL
Impedance
Rated impedance is 150 ohms (45 ohms actual) for connection to microphone
inputs rated low Z
Phasing
Positive pressure on diaphragm produces positive voltage on pin 2 with respect to
pin 3
Maximum SPL
174 dB at 1000 Hz (calculated)
Connector
Three-pin professional audio connector (male XLR type)
Case
Silver blue enamel-painted die cast metal with hardened, matte-finished steel
grille
Adjustable, Locking Stand Adapter
Integral, dynamic locking, adjustable through 180 degrees, with standard 5/8"-27
thread
Net Weight
605 grams (21.6 oz)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement