KPA Series Amplifiers
KPA Series Amplifiers
Two-channel Digital Amps with K8 Bus
KEY FEATURES
TECHNICAL SPECIFICATIONS
K8 system compatible
Power factor correction
Low cost of operation and ownership
Load monitoring
Comprehensive protection feature set
Full status monitoring
Small and light weight
High efficiency
Downloadable status log
Single cable connection for digital audio and control
Optional advanced function DSP
PRODUCT DESCRIPTION
The KPA series amplifiers are specifically designed for
fixed installations where high sonic performance and
ease of installation and management are paramount.
Each KPA amplifier is equipped with analogue and
K8 bus digital inputs. Used in conjunction with
Klein+Hummel K8 products, the KPA series amplifiers
provide a flexible, easy to manage signal and power
train for houses of worship, performance halls, arenas
and stadiums.
Power Requirements
Power supply
Power factor
115-230V (±15%)
more than 0.95 from 500W to full
power
Operating temperature 0° C, 45° C (32°F, 113°F)
Weight
12Kg (26.5 lbs.)
External dimensions
Standard rack 19" (W), 1 RU 1.75"
(H), 18.7" (D)
Audio Section
Bandwith (1W, 8 Ohm) 20Hz-20KHz ±0,2 dB
Damping factor (8 Ohm) (20Hz-200Hz) > 5000
Slew Rate (8 Ohm)
50V/uS (input filter bypassed)
S/N ratio
>110 dB
Distortion THD
Max < 0.5% from 1W to full power
(typically < 0.05%)
Intermodulation
Max < 0.5% from 1W to full power
(typically < 0.05%)
SMPTE
Intermodulation
Max<0.5% from 1W to full power
(typically < 0.05%)
DIM
Inputs
Impedance
Gain
Outputs
Balanced to ground, XLR female
combo jack 6.3mm,
K8 digital audio bus, RJ-45
10 Ohm each leg, balanced to ground
26, 29, 32, 35dB, user selectable
Neutrik 4-pole Speakon (pins 1+ 2+
paralleled,1-2- paralleled)
OUTPUT POWER SPECIFICATIONS (Watts per channel, EIAJ measurement conditions)
KPA 2400
KPA 2290
KPA 2220
2 Ohm
6000
4500
3000
Stereo Mode
4 Ohm
4000
2900
2200
8 Ohm
2000
1450
1100
4 Ohm
12000
9000
6000
Bridged Mode
8 Ohm
8000
5800
4400
16 Ohm
4000
2900
2200
KPA Series Amplifiers
Two-channel Digital Amps with K8 Bus
K8 CONTROL FEATURES
TECHNICAL SPECIFICATIONS
Control Functions
via K8
Link
Power on/off, optional DSP all
settings, thermal limiting, input
current limiting, clip limiting,
output voltage limiting, average
output power limiting
K8 loop through, RJ-45, passive
bus coupling
K8 channel select
Rotary switch, behind front panel,
software override
Control
Directly via K8 bus
Termination Switch
4-position DIP
Digital Audio Format
48 kHz sampling rate, 24 bit,
proprietary
Latency
½ millisecond worst case,
analogue in to analogue out
K8 Rear Panel Indicators Sync, Wink
Monitoring
Functions via K8:
 
Load impedance, temperature,
input signal level, output voltage,
output
  current
Additional Amplifier Load short shutdown and self
Protection:
recovery, thermal limiting, DC
and infrasonic and ultrasonic
frequency signal protection
MECHANICAL DRAWING



 



ARCHITECT
& ENGINEERING
SPECS
K + H Vertriebs- und
Entwicklungsgesellschaft mbH
Auf dem Kessellande 4a
30900 Wedemark, Germany




   




 
 



provide
2 channels of


 
 
 
 

 

 
http://www.klein-hummel.com
 


The audio
poweramplifier shall be 1 EIA rack
unit tall and
amplification at 4000/2900/2200 Watts
 


into 4 Ohms,
be capable of driving a load
power factor correction, have a 1 Watt bandwidth
 to 2 Ohms, provide
 down

 shall
 
of 20Hz-20kHz (+/- 2 dB), have a signal to noise ratio greater than 110dB, slew rate of at least 50V/microsecond, typical
total harmonic distortion of 0.05% and shall not exceed 0.5% at full power. Gain shall be user selectable from 26, 29, 32
and 35 dB settings. Inputs shall be K+H K8 system compatible and analog. K8 digital audio channels shall be selectable
via rotary switches behind the front panel. Remote monitoring and control shall be via the same cable as digital audio
distribution and shall include load monitoring capability. The amplifier shall be capable of inrush current limiting, clip
limiting, power supply current draw limiting, output voltage limiting, thermal protection, load short protection and


recovery. The audio power amplifier shall be the
K+H
KPA Series.




 
 










http://www.klein-hummel.com


http://www.klein-hummel.com




K + H Vertriebs- und
K + H Vertriebsund
Entwicklungsgesellschaft
mbH
Entwicklungsgesellschaft
mbH
Auf dem Kessellande
4a
Auf dem Kessellande
4a
30900 Wedemark,
Germany
30900 Wedemark, Germany
K+H Vertriebs- und Entwicklungsgesellschaft mbH
Auf dem Kessellande 4A
30900 Wedemark
Germany


  
    






 
 
  

  











Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising