Brodit 513405 holder Datasheet

23 July, 2012, www.brodit.com, © 2012 Brodit AB
Product 513405
513405 Active holder for fixed installation. With tilt swivel, with Molex adapter system. 2A charger.
An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without
cables hanging over the interior!
You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter
to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS
receiver or other own solutions (can not be used for data communication or audio connection).
12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional
installation recommended.
The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Attach onto ProClip
Mounting Platform.
EAN: 7320285134058
Item no 513405 fits:
Samsung Galaxy Ace 2 GT-I8160 (For all countries)
1 (2)
INSTALLATION INSTRUCTIONS
1.
2.
3.
4.
Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The
charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be
installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the
cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape
provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does
not get hot! Note: If you are connecting a GPS/Data device to the holder please ensure the charger unit is located
in a position within easy reach of any GPS or charging adapters. Route the power cable from the charger unit to
the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground
connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the
vehicle that is controlled by the ignition switch of the vehicle. How to mount the holder: 1. Loosen the screw in the
center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate
onto the desired position. Screw the attaching plate into place with the enclosed screws. 3. Place the holder over
the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread
starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the
holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in
place, but still can be adjusted. 4. The holder is in place.
2 (2)