T1000
Information
T500
■ Complementary class A/B bipolar outputs, using the
T Series
Power Amplifiers
T Series high performance power amplifiers
are designed for use in a variety of applications
in the fixed installation market where sonic
quality is the highest priority. The T1000 and
T500, at 500W and 250W per channel
respectively, will bring the well renowned MC 2
sound quality and reliability to a wider range of
users.
Building on the MC 2
commitment to sound quality
and reliability, these exciting
new products have been
designed with complementary
AB bipolar outputs, using the unique MC 2
current driven floating drive stage and
conventional analogue level controls. The sound
quality is maintained over a very wide range of
load and temperature conditions. Sophisticated
‘side chain’ limiters prevent distortion and
speaker damage but are out-of-circuit until the
onset of clipping.
The control circuitry provides full protection
against short circuits, DC and excessive
temperature together with inrush current
limiting and delayed ‘turn on’. All adding up to
genuine ‘state of the art’ amplifiers.
unique MC 2 current driven floating drive stage, which
gives one of the ‘cleanest’ sounds available.
■ Sophisticated monitoring of amplifier temperature and
load conditions.
■ Proprietary control and protection circuitry continuously
checks for all fault conditions such as shorted outputs,
DC on outputs, excessive temperature (blocked air flow),
component failure etc… and disconnects the outputs,
if such an event occurs.
■ Low noise vari-speed fans.
■ ‘Side-chain’ clip limiter prevents speaker damage from
clipped signals but only comes into the signal path during
limiting, and is inaudible during normal operation.
■ Audio ‘fade-up’ on Power-on.
■ Optional internal crossover cards available.
■ New proprietary ‘Ultra Cool’ heatsink.
■ Full mains inrush protection.
2
All MC products come with
a full 5-year warranty.
T1000
T500
Connectors
Controls
Indicators
Inputs
Outputs
XLR 3 pin
4 pole SPEAKON
Front panel
2 x level controls
1 x power on/off switch
1 x power, 2 x limit, 2 x signal present
1 x auto protect
Specifications
T1000
T500
300
500
700
175
250
0-0
1000
1380
500
0-0
THD @ Rated Power 4 ohms
1 kHz
20Hz-20 kHz
<0.008%
<0.03%
<0.008%
<0.03%
Input CMRR
>90 dB
>90 dB
Hum & Noise
-105 dB
-105 dB
Gain
32dB
32dB
Sensitivity for rated output, 4 ohms
+3.5dBu (1.2v)
+1dBu (870mv)
Damping Factor 1 kHz, 8 ohms
>400
>400
Frequency response
20Hz-20kHz
+0/-0.5 dB
20Hz-20kHz
+0/-0.5 dB
Output Power
(Watts RMS) per channel
8 ohms @ 1kHz
4 ohms @ 1kHz
2 ohms @ 1kHz
Mono bridged
8 ohms @ 1kHz
4 ohms @ 1kHz
M
Kingsgate
Heathpark
Honiton
Devon
Input impedance
(actively balanced)
20k ohms
20k ohms
Dimensions - 2U (mm)
88 x 482 x 428
88 x 482 x 428
Weight
18kgs
15kgs
Power requirement
230 VAC
@ 8 amps max
115 VAC
@ 16 amps max
230 VAC
@ 6 amps max
115 VAC
@ 12 amps max
ENGLAND
EX14 1YG
T500 | T1000 | T1500 | T2000
Tel: +44 (0)1404 44633
Fax: +44 (0)1404 44660
website: www.mc2-audio.co.uk
email: mc2@mc2-audio.co.uk
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising