AS-1500_Manual 4 PDF.cdr
ON/OFF Switch.
Hold for two seconds to turn ON.
Hold to turn OFF.
Transmitter Menu Down Button.
Please See (System Setup) on page
5.
LCD screen.
Please See (System Setup) on page 5.
Input Level. Controls Level of Rear
Panel Inputs.
Transmitter Set Button.
Please See (System Setup) on page 5.
Transmitter Menu Up Button.
Please See (System Setup) on page 5.
Headphone Jack.
Headphone Output Control.
Controls Headphone Volume. Turn
left to decrease the audio level, turn
right to increase.
DC Power Input Jack.
Left XLR/1/4" Combo Input Jack.
Right XLR/1/4" Combo Input Jack.
PAD Switch.
Use to adjust Input Gain.To cut gain,set to (-12dB).
To leave gain unaffected set the switch to (0dB).
Antenna Jack. 50 ohm.
1 Output Level Control and On/Off switch.
2 Earphone Jack.
3 Antenna.
4 LCD screen.
Please See ( S ystem S etup) on page 6.
5 Low Battery Indicator.
6 RF Signal LED.
Lights when RF Signal is received.
7 Receiver Menu Up Button.
8 Receiver Menu Down Button.
9 ESC Button. To Exit Menu Setup.
10 SET Button. Use this to select Menu Parameters.
Wearing the Bodypack Receiver
Belt Clip: For best results, clip the receiver onto a belt by
pushing the receiver down onto the belt as far as possible.
For Guitarists: Slide the guitar strap ”through” the receiver
clip.
Changing Batteries
Expected life for two Alkaline batteries is approximately 6 hours.
When the LCD battery indicator is flashing,
the batteries should be replaced (see below).
The “Low Battery” LED (above) will also light at this point.
Select a Group and Channel:
Press “SET” button, “GROUP” will display, press
or
button to select suitable frequency group number, as
shown in Diagram 1 on the left. Then press “ SET” again ,
“CHANNEL” will display, press or to select suitable
channel, as shown in Diagram 2 . on the left.
Note: When using multiple systems, for optimum results
set all of the systems to the same group number and
select a different channel number for each system in
that group.
Stereo/Mono Mode Selection:
Press “SET” button 3 times, “Mode Select” will display,
press
or to select Stereo or Mono, as shown in
Diagram 3 .
Locking Selection:
Press “SET” button 5 times, “LOCK SELECT” will display,
press or to select Lock or Unlock, as shown in
Diagram 4 .
Audio Input Level Indication
Displays left and right audio input level, as shown in
Diagram 5 .
Note: Adjust audio input levels to indicate “0” on the
loudest signals.
Bodypack Receiver Programming
Adjusting Left and Right Balance:
Press ▲ or ▼ to adjust left and right earphone balance,
as shown in Diagram 1 . “-0-” indicates center balance.
Select a Group and Channel:
Press “SET” button, “GROUP” will flash, press ▲ or ▼ to
select suitable frequency group number, as shown in
Diagram 2 on the left. Then press “SET” again,
“CHANNEL” flashes, press ▲ or ▼ to select suitable
channel, as shown in Diagram 3 on the left.
Battery Indication
Four level battery status indicator, as shown in Diagram
4 . Replace batteries when indicator blinks. ”Low
Battery” LED (page 4) will also light at this point.
Equalization Setup:
Press “SET” button 3 times, “EQ” will flash, press ▲ or ▼
to select EQ mode. “ON” (Offers more high-end
response: 6dB boost at 10KHz), “OFF” (Is Normal, Flat),
as shown in Diagram 5 .
Limiter selection:
Press “SET” button 4 times, “LIMITER” will flash, press
▲ or ▼ to select Limiter “On” or “Off”, as shown in
Diagram 6 .
Locking Selection:
Press “SET” button 5 times, “
” will flash, press ▲ or
▼ to select Lock or Unlock, as shown in Diagram 7 .
Stereo/FOCUS selection:
Press “SET” button 6 times. When the receiver is set to
stereo operation, the left-right signals are available as
usual. When the receiver is set to FOCUS operation, the
left-right signals are mixed and are available as a mono
signal in both headphone channels. Use the ▲ / ▼ rocker
buttons to adjust the relative levels of the two separate
channels in the mixed mono signal, as shown in
Diagram 8 . Press "ESC" after any programming to exit
menu and return to full display.
Full Display
Displays Battery Status, RF/Audio Level, Stereo/Mono
Mode, EQ Mode, Lock Status, Limiter Mode and
Selected Frequency, as shown in Diagram 9 .
System
Bodypack Receiver
Frequency Range and Transmitter Output Level
Frequency Range: CODE D 584~607 MHz
CODE L 655~679MHz
Transmitter Output Level: 10dBm
Audio Output Level: 100mW
Sensitivity:
-94dBm for 30dB
Operating Range Under Typical Conditions
300' (92m)
Note: actual range depends on RF signal
absorption, reflection, and interference
Image Rejection: >65dB
Audio Frequency Response: +/-3dB
60Hz~16KHz
Weight:
3.2oz (90g) without batteries
Total Harmonic Distortion: +/-30KHz deviation
1KHz tone <1%
Power Requirements:
2 (AA) size alkaline or rechargeable
batteries
Dimensions: 3.5" x 2.5" x .9"
(90mm H x 64mm W x 23mm D)
S/N ratio(at 1 mV and peak deviation) >80 dB
Battery Life: About 6 hours
Dynamic Range >90dB A-weighted
Operating Temperature Range
14ºF to 122ºF (-10 Cº to +50 Cº)
Note: battery characteristics may limit this range
Transmitter
Max Audio input level: +6dBV
Gain Adjustment Range: 40dB
Input Impedance: 6.8K?
Dimensions: 1.7" x 7.9" x 3.7" (44mm H x 200mm W x 96mm D)
Weight: 21oz. (600 g)
Power Requirements:
12-18 V dc at 300mA supplied by external
power supply
XLR input:
Impedance balanced
Pin1 Ground(cable shield)
Pin 2 Audio
Pin 3 No Audio
A RETURN AUTHORIZATION (RA) NUMBER MUST BE OBTAINED from Galaxy Audio prior to any
items being returned to Galaxy Audio for return or repair. Contact customer service @ (800)369-7768.
Galaxy Audio warrants the materials and workmanship of its products as follows:
A limited THREE YEAR Warranty applies to the following products:
1. HOT SPOTS-including HSRG, HSVC, PA5XD & GALACTIC MONITOR PACKAGE
2. MICRO SPOTS-including MSVC, MSPM, MSPA(DC)
3. CRICKET Polarity Test Set
4. JACKS IN THE BOX – including the MULTI MIXER
5. Hot Spot Accessories
A limited ONE YEAR Warranty applies to the following products:
1. CHECKMATE Series-including CM130, CM140, CM150, CM160, CM-C200 and accessories
2. ANY SPOT Series-including AS-1000(R)(T), 500 & 700 SERIES, TOUR GUIDE/TRANSLATOR
SYSTEMS, WIRELESS CAMERA KIT
3. ANY SPOT Accessories & Components
4. TRAVELER SERIES-including ANY SPOT TRAVELER, WIRELESS SPEAKERS, WIRED PA
SYSTEM PACKAGES, TRAVELER W/ECHO
5. TRAVELER Accessories
The following are not covered by the warranty:
1. Damage to or deterioration of the exterior of the item which occurs after delivery
2. Damage after initial delivery resulting from accident, misuse or neglect
3. Damage resulting from failure to follow instructions contained in the owner's manual
4. Damage resulting from the performance of repairs by someone other than the Galaxy Audio
repair department
5. Damage occurring during the shipment or delivery of any Galaxy Audio product to Galaxy Audio after
initial delivery of the product to you.
6. Damage to any Galaxy Audio product which has been altered or on which the serial number has been
effaced or removed.
7. Damage to or deterioration of the exterior of the item which occurs after delivery
Galaxy Audio does not authorize any third party including any dealer or Service Center to assume any
liability on behalf of Galaxy Audio or to make any warranty for Galaxy Audio
DEFECTIVE MERCHANDISE POLICY-WARRANTY
A RETURN AUTHORIZATION (RA) NUMBER MUST BE OBTAINED from Galaxy Audio prior to any
items being returned to Galaxy Audio for return or repair. Contact customer service @ (800)369-7768.
The Galaxy Audio warranty policy is to repair and return defective merchandise. Items under
warranty may be replaced at no charge if deemed un-repairable by the Galaxy Audio technician. Proof of
purchase may be required to verify warranty status. Customer will be responsible for shipping charges to
repair facility, repaired product will be returned
shipping prepaid by Galaxy Audio. Freight charges will not be reimbursed. Credit for defective warranty
merchandise must have authorization from the Galaxy Audio main office
before credit will be issued and will be subject to applicable restock and replacement charges.
A twenty (20%) restock fee will apply to warranty items returned for credit. The cost of replacement parts
to bring the item back to “like new” condition will also be deducted from credit for warranty items
DEFECTIVE MERCHANDISE POLICY-NON WARRANTY
A RETURN AUTHORIZATION (RA) NUMBER MUST BE OBTAINED from Galaxy Audio prior to any
items being returned to Galaxy Audio for return or repair. Contact customer service @ (800)369-7768.
Repair charges are $30.00 per hour (no minimum) plus parts. Customer will be responsible for all
shipping charges. Prepayment is expected if customer is not set up with open account terms in advance.
Discounts are not applicable on repairs. Open account terms for repairs will be Net Thirty (30) days.
Some items past the warranty time period may qualify for a standard replacement cost. Please contact
Galaxy Audio for more information.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement