Advertisement
Advertisement
AFW 30
ANTI-FEEDBACK WORKSTATION
TM
EQUALIZER, PEAK LIMITER, SABINE FBX FEEDBACK SUPPRESSION
Tuning and calibrating an audio system, whether it’s for a conference or a concert, is a complex procedure at the best of times!
Simply stopping feedback is only a part of it - you still need to adjust the actual frequency response of the system in the room.
In the ideal world you’d have an equalizer to set the system EQ curve, something to eliminate feedback, and something else to keep the system level under control.
So, we’d like to introduce you to the ARX contribution to the ideal world - the ARX
AFW 30 Anti Feedback Workstation.
A super accurate 30 band graphic equalizer, with 30 of our new XR Extended Res-
olution long throw faders providing up to
± 10dB of cut and boost, a fast, smooth sounding peak limiter, plus onboard 9 band
FBX Feedback Exterminator DSP circuitry licensed from Sabine.
The first 6 FBX filters lock in at the primary feedback nodes, leaving 3 filters ‘floating’ to handle any short term feedback problems, such as presenters or artists moving the microphone in front of the speakers, or too close to monitors, or something similar. These are usually short term problems, and once they have passed, the floating filters go back to a waiting mode.
Operation of the AFW 30 is simplicity itself. Just use the EQ section to set the curve you require, press the Reset switch in the anti feedback section for 4 seconds, and start increasing the system gain.
If the system is in a fixed installation, simply power everything down when you’ve finished. The AFW 30 remembers your anti-feedback settings next time it is used - there’s no need to reset the circuit when it is turned back on.
The AFW 30 also features a Variable
Threshold Output Limiter to ensure freedom from System overload and
Amplifier clipping.
The ARX AFW 30 Anti Feedback
Workstation has an application for every mode of live and installed audio: Monitors, Front of House, Church installations, TV audience monitors,
Conferences.
In fact, anywhere there’s a live microphone and loudspeakers, there’s a need for the AFW 30.
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
!
Automatic Feed-
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212 back control
1234567890123456789012345678901212 !
Genuine Sabine
1234567890123456789012345678901212
1234567890123456789012345678901212 FBX Feedback
1234567890123456789012345678901212
1234567890123456789012345678901212 Exterminator DSP
1234567890123456789012345678901212
1234567890123456789012345678901212 !
30 band Graphic
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
Equalizer with
1234567890123456789012345678901212
1234567890123456789012345678901212
Extended Resolu-
1234567890123456789012345678901212
1234567890123456789012345678901212 tion long throw
1234567890123456789012345678901212
1234567890123456789012345678901212 faders
1234567890123456789012345678901212
1234567890123456789012345678901212 !
Fast, smooth
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212 Output limiter
1234567890123456789012345678901212
1234567890123456789012345678901212
!
Intuitive, 'user
1234567890123456789012345678901212
1234567890123456789012345678901212 friendly' layout
1234567890123456789012345678901212
1234567890123456789012345678901212 !
Ultra low noise
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
‘Constant Q’
1234567890123456789012345678901212
1234567890123456789012345678901212 circuitry
1234567890123456789012345678901212
1234567890123456789012345678901212
!
Balanced Inputs
1234567890123456789012345678901212
1234567890123456789012345678901212 and Outputs on
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
XLR and Jack
1234567890123456789012345678901212
1234567890123456789012345678901212 connectors
1234567890123456789012345678901212
1234567890123456789012345678901212
!
Flawless perform-
1234567890123456789012345678901212
1234567890123456789012345678901212 ance in any audio
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212 environment
1234567890123456789012345678901212
1234567890123456789012345678901212
!
Security cover
1234567890123456789012345678901212
1234567890123456789012345678901212 available
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
Input
40 K Ohm Balanced
20 K Ohm Unbalanced
Output
300 Ohm Balanced
150 Ohm Unbalanced
Nominal Operating Level
0 dB
Maximum Input Level
+20 dB
Maximum Output Level
+20 dB EQ section only
+10 dB FBX in
Signal to Noise Ratio
EQ section only
–93 dB Unweighted
FBX in
–82 dB Unweighted
Gain
User Variable oo to +10 dB
Distortion
0.004% EQ section only
0.02% FBX in measured@ 1 KHz, +4dB
Frequency Response
20 Hz to 20 KHz, ±0.5 dB
Dynamic Range
+113 dB EQ section only
+92 dB FBX in
Equalizer Filters
30 x Constant Q on standard ISO frequencies
FBX Filters
6 fixed, 3 dynamic
FBX Filter Range
51Hz to 17 KHz
FBX Filter Width
1/5th or 1/10th octave
Switchable; refer manual
FBX Filter Depth
0dB to –40dB
FBX Filter Reset Time
Minimum 4 seconds
Peak Limiter Threshold
Variable –10 dB to +10 dB
AC requirements
100–120, 220–240 VAC,
50-60Hz, 18 VA
Size
482 x 88 x 205 mm
19”W x 3½”H x 8”D
Our policy is one of continuous improvement, and therefore designs may change without notice. However, unless otherwise stated, specifications will always equal or exceed those previously given.
• 30 x Extended Resolution long throw centre grounding faders per channel, on standard
ISO frequencies
• Reset control for Feedback Exterminator
DSPcircuitry
• Clip LED indicates imminent clipping, monitored at all vital stages through the AFW-30
• Active/Bypass switch for Feedback Exterminator DSP circuitry
• Limiter Threshold control and Limit LED
• Level control from oo to +10 dB
• Hardwire Active/Bypass switch for unit
• Power LED indicates AFW-30 is connected to AC power
• Balanced Input and Output TRS sockets. Tip
+ HOT, Ring – COLD, Sleeve GROUND
• Balanced Input and Output XLR connectors.
Pin 2 + HOT, Pin 3 – COLD, Pin 1 GROUND
• Feedback Exterminator filter width switch
• IEC 3 pin AC connector and integral fuseholder.
ARX Systems are based in Melbourne, Australia, where all ARX Products are assembled and tested in our ‘state-of-the-art’ manufacturing facility
For over 20 years ARX has designed, manufactured and supported Audio Products for
Professional users and applications worldwide
The Workstation shall be a single channel unit in a steel chassis eight inches deep, two rack units high, with a steel front panel.
The EQ section shall have 30 x 60mm (45mm travel) centre grounding sliders on standard
ISO frequencies, from 25 Hz to 20 KHz. At the 0 point each slider shall be grounded, and in effect removed from the circuit.
The Anti Feedback section shall consist of an onboard FBX Feedback Exterminator DSP card, with Reset switch, an Amber LED to indicate the onset of clipping, and an Active or Bypassed switch. Additionally there shall be a rear panel switch for changing the FBX filter width from 1/5th to 1/10 octave.
The Limiter Threshold shall be variable by a front panel control, from –10dB to +10dB, with a Limit LED to indicate Limiting taking place.
There shall be an overall Output level control, variable from oooooooooo to +10dB and also an overall Active or Bypass switch on the front panel. An LED on the front panel shall indicate AC power being applied.
The unit shall have electronically Balanced inputs and outputs, on TRS jack and XLR type connectors, with passive RFI filters and an Input impedance of 40 Kohms. The Input headroom shall be +20dB, and the frequency response shall be 20 Hz to 20 KHz, ±0.5dB.
The Output impedance shall be 300 ohms, and the maximum Output level +20dB (+10dB
FBX in), with a Signal to Noise ratio of better than –93dB unweighted (-82dB with FBX in).
Total Harmonic Distortion shall be 0.004%
(0.02 FBX in) @ 0dB, 1 KHz.
AC Power shall be supplied via a removable mains cable, connecting to an IEC connector with an integral fuse /voltage change switch on the rear panel.
The unit shall be the ARX AFW 30 Anti Feedback Workstation.
Specifications available on CD ROM.
Latest updates available at: www.arx.com.au
ARX Systems Pty Ltd; PO Box 15, Moorabbin, Victoria 3189, Australia
Phone: 03 9555 7859 Fax: 03 9555 6747 International Fax +61 3 9555 6747
Email: [email protected] Internet: www.arx.com.au
©2003 ARX Systems Pty.Ltd. ACN 006 471 825. All rights reserved. ARX Systems® is a Registered Trade Mark.
‘AFW 30’and ‘Anti-Feedback Workstation’ are Trademarks of ARX Systems. FBX Feedback Exterminator is a
Registered Trademark of Sabine, Inc, and is the brand name of its line of automatic feedback controllers.
![](http://s3.manualzz.com/store/data/028580152_1-3b937ef9c545b7cf1323fe88a6742109-210x147.png)
Advertisement