Digitus DS-31101-1 User manual

ESATA II

EXPRESS CARD

User Manual

DS-31101-1

All brand names and trademarks are properties of their respective owners.









Features and Benefits





Fully compliant with ExpressCard Specification 1.0

ExpressCard/34 Form Factor Module



Serial ATA generation 2 transfer rate of 3.0Gbps

One eSATA (external Serial ATA) port

Supports hot plug for external Serial ATA port

Support SATA II NCQ (Native Command Queuing) to maximize system performance

Supports Windows ® 2000, XP/2003/Vista/7

(32-bit and 64-bit)

Bus Interface

 ExpressCard/34

Connector

 1 x eSATA

System Requirements

 Windows ® 2000, XP/2003/Vista/7 (32-bit and 64-bit)

ExpressCard-enabled system with an available

ExpressCard slot

Package Contents





1 x eSATA II 300 1-Port ExpressCard

1 x Driver CD

 1 x User Manual

Note: Contents may vary depending on country/market.

2

Hardware Installation

General instructions for installing the card are provided below.

Since the design of system may vary, refer to your system’s reference manual for further information, if needed.

Insert the Card into the ExpressCard slot of your system.

Make sure it is inserted all the way in for a solid connection.

Driver Installation

1. Please insert the CD driver bound with eSATA II 300 1-Port

ExpressCard into your CD-ROM Drive.

2. At the Windows desktop, click Start, Run.

(Change D: to match your CD-ROM drive letter)

4. Follow the on-screen instructions to complete the installation

To Verify Driver Installation

3. Look for the following:

Windows® 2000/XP/2003: Double click SCSI and RAID

Controller:

- Silicon Image SiI 3531 SATA Controller should be

® Vista/7:

- Silicon Image SiI 3531 SATA Controller should

be displayed

3

Hot-Plugging Hard Disk Drives

To remove a drive from a powered up system, do the following: select Disable/Enable.

4. You can now remove the target disk.

4