Kingston Technology ValueRAM KVR16LR11S8/4KF memory module Datasheet

Memory Module Specifi cations

KVR16LR11S8/4KF

4GB 1Rx8 512M x 72-Bit PC3L-12800

CL11 Registered w/Parity 240-Pin DIMM

DESCRIPTION

This document describes ValueRAM's 512M x 72-bit (4GB)

DDR3L-1600 CL11 SDRAM (Synchronous DRAM), low voltage, registered w/parity, 1Rx8 ECC, memory module, based on nine

512M x 8-bit FBGA components. The SPD is programmed to

JEDEC standard latency DDR3-1600 timing of 11-11-11 at

1.35V or 1.5V. This 240-pin DIMM uses gold contact fingers.

The electrical and mechanical specifications are as follows:

FEATURES

•

JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~

1.575V) Power Supply

• VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)

•

800MHz fCK for 1600Mb/sec/pin

•

8 independent internal bank

•

Programmable CAS Latency: 11, 10, 9, 8, 7, 6

•

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

•

8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or

MRS]

•

Bi-directional Differential Data Strobe

•

Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

•

On Die Termination using ODT pin

•

On-DIMM thermal sensor (Grade B)

•

Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

•

Asynchronous Reset

•

PCB : Height 1.180” (30.00mm), double sided component

SPECIFICATIONS

CL(IDD)

Row Cycle Time (tRCmin)

Refresh to Active/Refresh

Command Time (tRFCmin)

Row Active Time (tRASmin)

Maximum Operating Power

UL Rating

Operating Temperature

Storage Temperature

11 cycles

48.125ns (min.)

260ns (min.)

35ns (min.)

(1.35V) = TBD W*

94 V - 0

0 o C to 85 o C

-55 o C to +100 o C

*Power will vary depending on the SDRAM and

Register/PLL used.

SDRAM SUPPORTED

Kingston (F-Die)

Continued >>

Document No. VALUERAM1381-001.A00 12/03/13 Page 1

MODULE DIMENSIONS:

(units = millimeters)

Document No. VALUERAM1381-001.A00 Page 2