Waterproof Portable Rechargeable Speaker XC-5219

Waterproof Portable Rechargeable Speaker XC-5219
User Manual
Waterproof Portable Rechargeable
Speaker
XC-5219
Distributed by:
TechBrands by Electus Distribution Pty. Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
Ph: 1300 738 555
Int’l: +61 2 8832 3200
Fax: 1300 738 500
www.techbrands.com
Specifications:
Weatherproof rating:
Output Power:
Frequency response:
Impedance:
Sensitivity:
S/N Ratio:
Distortion:
Charge time:
Use time:
Power:
Dimensions:
IPX4
2 x 3 WRMS
9Hz-18kHz
4 Ohm
80dB±2dB
≥65dB
≤1%
3.5-4.5 hours
4-5 hours
1800mAh Li-ion Battery
186(L) x 62(H) x 56(D) mm
Charging the battery:
- Open the protective cover on the side of the unit.
- Plug the charging cable into the charging port, and the other end into a USB
power terminal. The LED indicator will turn red.
- Once the charging is completed, the LED indicator will turn off.
Bluetooth® pairing:
- Press and hold the power button to turn on the speaker.
Press it again to turn off.
- The blue LED will flash along with a ‘beep’ sound to indicate it’s in Bluetooth
mode and ready for pairing.
- Turn on the Bluetooth® function of your device and search for “XC5219”, select
to pair, and if prompted for a password type “0000”. After the connection is
successful the blue LED will stop flashing.
- Select the music to play from your device, or use as per the Operation
Instructions below.
NFC (Near Field Communication):
1. To use the NFC function, you must have an NFC enabled device. Ensure that the
NFC on your device is turned on, and hold your NFC enabled device over the
NFC logo on the speaker.
2. This will connect your device to the speaker, and any previous devices that were
connected will be disconnected.
3. Select the music to play from your device, or use as per the Operation
Instructions below.
AUX Link:
1. After powering on the unit, use a 3.5mm audio cable to connect your music
device with the speaker. The LED on the front will turn red.
2. Select the music to play from your device, or use as per the Operation
Instructions below.
The call control buttons will not work in AUX link mode.
Button Description:
Press once to skip to the previous track
Press and hold to decrease the volume
Press once to skip to the next track
Press and hold to increase volume
Press once to pause or play the music
Press and hold to disconnect the Bluetooth®
Press to pick up/hang up phone call
Press twice quickly to redial the last phone number
Switch the speaker On/Off
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement