Installation Instructions 2-wire Reversing Switch for the Signal Mate

Installation Instructions 2-wire Reversing Switch for the Signal Mate
.
Installation Instructions
2-wire Reversing Switch for the Signal Mate TriAnchor light
The Signal Mate TriAnchor light may be operated using only 2 wires. This reversing switch
will select between Anchor and Tricolor by reversing the polarity of the voltage applied to
the two wires. The Red and Black wires from the TriAnchor should be used.
WIRING
1.
2.
3.
The reversing switch is a DPDT toggle switch with a Center-Off position. The
terminals are pre-wired for reversing polarity. Wire the TriAnchor to the top two
terminals of the switch as shown in the drawing below. The short cross copper
straps should remain in place.
Attach incoming power and ground wires to the two middle terminals. The power
wire should first pass through a circuit breaker of 2 amps or less.
WARNING: It is important to provide proper fusing or circuit breaker sizing. A
circuit breaker larger than 2 amps will increase the risk of fire or injury. Signal
Mate is not responsible for any injury, death, or property damage resulting from the
installation, use, misuse, or failure of this switch or the light.
Tri-Color
Red
V+
Tri-Color
Black
Ground
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising