Installation Kit EHS Cisco Part B
Installation Kit EHS Cisco
Part B
electronic hook switch
- Remote controlled telephone system
- Call control
- external adapter
- no software required
Product code
SKN 300 for:
7940
7941
7960
7961
7970
7971
Part A
Part B
Instruction manual for
authorized specialized staff
SKN 300
CENTER
SERVICE- UND
DIENSTLEISTUNGSZENTRUM
GMBH LEIPZIG
Tel.-Hotline: 0341 8684230
Zentral-Fax: 0341 8684233
E-Mail: info@modicom.de
04299 Leipzig
Schönbachstraße 65a
Wireless Headsetsolution for Cisco
at IPP 79xx terminal with adapter
7
4
1
0
8
5
2
9
6
3
#
*
CISCO IP PHONE
7940 SERIES
CISCO IP PHONE
7940 SERIES
Terminal
connection
socket
CISCO
IP PHONE 79xx Serie
mobil unit
Headset assortment
Network plug
System port
remote controlled IP telephone without motor management system
- Operation: call pick up, call hold and call waiting using remote control
- Call transfer and call placement using receiver headset
Adapterwire
for controlling
(0,75 m)
Plantronics
base-CSxx/CA40
voyager
wireless Headset
Receiver Telephone Controlling
Receiver
connection
socket
Westernwire 4/4
(0,75 m)
originale receiver wire
(coiled wire)
http://www.modicom.de
- Sevices for adapted solutions -
Adapter EHS SKN 300
final assembly
lift sopport stand halfway
open the phone
(remove 4x bolts)
lift rear side
pull notches out off
guiding gib on left side
pull notches out off
guiding gib on right side
detach faceplate
demount faceplate upwards
push hookswitch
demount clip by pushing forward
open phone
bolt underneath clip of hand set
1x
10 mm long
3x
Positioning of attechment bolts, 4 x
8 mm long
open right side and keep it open with card board
open notch with flat screwdriver right side
open notch with flat screwdriver left side
rotate the phone, lay down and detach the rear panel
Adapter
installation side
put rear
panel down
pull connector
put down
insert EHS adapter
through port for headset jack
Adapter
with plug
and jack
Ribbon cabel with
cord grip
insert Adapter
EHS-Modul
insert adapter
connect
plug and
jack
rear panel
turned
connect adapter
to socket on
main board
form wire
Scroll spring!
tie down helps
Location of scroll spring of hook switch
attach rear panel,
pull wire back to mark
close notches
cord grip:
pull wire
back to mark
attach rear panel using bolts
fit cord grip in
assembling of bolts, face plate and clip
Ready to ose!
press on sticky stands
put wire and EHS modul
underneath support stand
Funktion test
power supply
mode of operation
is self-explanatory
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising