ZR-2 Owner`s Manual
ZR-2 REPEATER
Introduction
ZR-2 Repeater Owner's Manual ©2012 Universal Remote Control, Inc.
The information in this manual is copyright protected. No part of this
manual may be copied or reproduced in any form without prior written
consent from Universal Remote Control, Inc.
UNIVERSAL REMOTE CONTROL, INC. SHALL NOT BE LIABLE FOR
OPERATIONAL, TECHNICAL OR EDITORIAL ERRORS/OMISSIONS
MADE IN THIS MANUAL.
The information in this manual may be subject to change without prior
notice.
URC - Control the Experience is a registered trademark of Universal
Remote Control, Inc.
All other brand or product names are trademarks or registered trademarks
of their respective companies or organizations.
ZR-2 REPEATER
ZR-2 REPEATER
ZR-2 Front and Rear Panel Descriptions
Thank you for purchasing the ZR-2 Repeater. The ZR-2 is used to extend
the operational range between Total Control products that work on Total
Control's 2.4 GHz RF network (i.e. TRC-780 to the MRX Advanced System
Controller). Once joined to an MRX, it wirelessly repeats communication
between a Total Control remote and an MRX Advanced System Controller.
Specifications
The front and rear panel consists of:
POWER LED
STATUS LED
DATA LED
USB
TEST
Features and Benefits
Power LED: When illuminated this light indicates the ZR-2 is powered.
l Wirelessly extend the range between Total Control RF products.
l Additional ZR-2 Repeaters can be joined to extend the RF signal to every
corner of the home, or small office.
l Compact size allows for easy installation
l Seamless integration with the Total Control System
Parts Guide
Status LED: The LED shows the RF signal strength between the ZR-2 and
the MRX Advanced System Controller. Pressing the Test button on the
Front of the unit refreshes the signal strength.
When the LED is:
l
OFF: There is no signal to communicate between Total Control
products. Press the Test button to reconnect to the MRX Advanced
System Controller.
l Orange: Poor signal strength. URC recommends relocating the unit for
strong signal reception.
The ZR-2 Repeater includes:
Data LED: The Data LED flashes as the ZR-2 Repeater transmits data.
Test: Press to obtain the current signal strength status between the ZR-2 and
the MRX Advanced System Controller.
USB: INSTALLER ONLY!! Used for updating the unit's firmware.
Page 1
Limited Warranty Statement
1. Limited Warranty and Disclaimers
Universal Remote Control, Inc. (“URC”) warrants that the URC equipment shall be free from defects in material
and workmanship under normal usage for one (1) year from purchase when such is purchased from URC. This
limited warranty is valid only in the United States of America. URC warrants that the software will substantially
conform in any material respect to its functional specifications at the time of delivery. URC SHALL NOT BE
LIABLE FOR OPERATIONAL, TECHNICAL OR EDITORIAL ERRORS AND/OR OMISSIONS MADE IN THE
URC DOCUMENTATION. URC DOES NOT WARRANT THAT THE URC SOFTWARE IS BUG-FREE OR
ERROR FREE OR THAT THERE ARE NO ERRORS/BUGS IN THE URC SOFTWARE.
URC warrants that at the time of purchase the URC equipment and the URC software complied with all
applicable regulations and policies of the Federal Communications Commissions (“FCC”) regarding
electromagnetic interference caused by electronic/computing devices and to the extent that the URC equipment
and/or the URC software fails to so comply, URC shall, at its own expense, take all reasonable measures to
promptly cause such to comply.
URC equipment purchases from other than an authorized URC dealer or distributor are without warranty.
l Green: Receiving optimal signal strength.
1 - ZR-2 Repeater
1 - Owner's Manual
RF Frequency: 2405 ~ 2480 MHz(Two-way RF)
Effective Range: Typically 50-75 ft, depending on environment
Size: L x D x H = 2.559" x 0.984" x 1.968"
Weight: 2 oz.
Power Supply: 100 ~ 240V~, 50/60Hz, 0.3A
Page 2
THIS LIMITED WARRANT DOES NOT COVER TECHNICAL ASSISTANCE FOR HARDWARE OR SOFTWARE
USAGE EXCEPT AS EXPRESSLY PROVIDED FOR HEREIN, THE EQUIPMENT, SOFTWARE AND
DOCUMENTATION OF URC ARE SUPPLIED “AS IS” WITHOUT ANY WARRANTY, EXPRESS, STATUTORY
OR IMPLIED, OF ANY KIND. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, URC
EXPRESSLY DISCLAIMS ALL WARRANTIES, EXPRESS, STATUTORY OR IMPLIED, INCLUDING BUT NOT
LIMITED TO THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
URC DOES NOT WARRANT, GUARANTEE, OR MAKE ANY REPRESENTATIONS REGARDING THE USE
OF, OR THE RESULTS OF THE USE OF, THE EQUIPMENT, SOFTWARE OR DOCUMENTATION IN TERMS
OF CORRECTNESS, ACCURACY, RELIABILITY OR OTHERWISE. EXCEPT AS EXPRESSLY PROVIDED FOR
Page 3
500 Mamaroneck Avenue, Harrison, NY 10528
Phone: (914)835-4484 FAX: (914) 835-4532
www.universalremote.com
OCE-0133A Rev 01
ZR-2 REPEATER
ZR-2 REPEATER
HEREIN, TECHNICAL SERVICES ARE SUPPLIED “AS IS”, WITHOUT ANY WARRANTY, EXPRESS,
STATUTORY OR IMPLIED, OF ANY KIND. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW,
URC EXPRESSLY DISCLAIMS ALL WARRANTIES, EXPRESS, STATUTORY OR IMPLIED, INCLUDING BUT
NOT LIMITED TO THE WARRANTIES OF QUALITY OR REASONABLE SKILL AND CARE, OR OUTCOME
OR RESULTS.WITHOUT IN ANY WAY LIMITING THE GENERALITY OF THE OTHER PROVISIONS HEREIN,
WARRANTY DOES NOT COVER: (I) DAMAGE FROM MISUSE, NEGLECT OR ACTS OR NATURE, (II)
MODIFICATIONS, (III) INTEGRATION WITH THIRD PARTY CONTENT (IV) BEYOND THE WARRANTY
PERIOD AND/ OR FAILURE TO FOLLOW URC WARRANTY CLAIM PROCEDURE.
CONSEQUENTIAL DAMAGES OF ANY KIND OR LOSS OF PROFITS OR BUSINESS OPPORTUNITY, EVEN
IF URC IS ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
The warranty limitations and warranty disclaimers may not apply to end user in whole or in part, where such are
restricted or excluded by applicable law and such shall apply to the maximum extent permitted by applicable
law.
In the event of any warranty claim, URC will, at its sole option, repair the URC equipment using new or
comparable rebuilt parts, or exchange the URC equipment for new or rebuilt equipment. In the event of a
defect, these are the end user’s exclusive remedies.
All the URC equipment returned for service, exchange or repair require an RGA number. To obtain an RGA
number, you must complete a Return Request Form which you may obtain by calling (914) 835-4484 or
contacting URC at returnrequest@universalremote.com. To obtain warranty service, end user must deliver the
URC equipment, freight prepaid, in its original packaging or packaging affording adequate protection to URC at
420 Columbus Avenue, Valhalla, NY 10595. It is end user’s responsibility to backup any macro programming,
artwork, software or other materials that may have been programmed into the unit. It is likely that such data,
software, or other materials will be lost during service and URC will not be responsible for any such damage or
loss. A dated purchase receipt, bill of sale, installation contract or other verifiable proof of purchase is required.
For the URC equipment support and other important information, please visit URC's website available at
www.universalremote.com or call the Customer Service Center at (914) 835-4484.
This limited warranty only covers the URC equipment issues caused by defects in material or workmanship
during ordinary consumer use. It does not cover product issues caused by any other reason, including but not
limited to product issues due to commercial use, acts of God, third-party installation, misuse, limitations of
technology, or modification of or to any part of the URC equipment. This limited warranty does not cover the
URC equipment sold as used, as is, refurbished, so called "B stock" or consumables (such as batteries). This
limited warranty is invalid if the factory applied serial number has been altered or removed from the URC
equipment. This limited warranty specifically excludes the URC equipment sold by unauthorized resellers.
With the exception of URC’s IR-only, broad-based consumer remotes, none of URC’s PC programmable remotes
or any of our Total Control® whole-house equipment are authorized for online internet sales. Buying URC’s PC
programmable remotes or any of our Total Control® whole-house equipment online means buying equipment
that does not have a URC’s limited warranty. Such equipment is not eligible for URC tech support or software
IN NO EVENT SHALL URC BE LIABLE FOR LOSS OF OR DAMAGE TO DATA, COMPUTER SYSTEMS OR
COMPUTER PROGRAMS.URC’S LIABILITY, IF ANY, FOR DIRECT DAMAGES OF ANY FORM SHALL BE
LIMITED TO ACTUAL DAMAGES, NOT IN EXCESS OF AMOUNTS PAID BY END USER FOR THE URC
EQUIPMENT.
IN NO EVENT SHALL URC BE LIABLE FOR ANY EVENTS BEYOND ITS CONTROL, INCLUDING ANY
INSTANCE OF FORCE MAJEURE. IN NO EVENT SHALL URC BE LIABLE FOR THE ACTS OR OMISSIONS OF
END USER OR ANY THIRD PARTY.
THE LIMITATIONS OF LIABILITY MAY NOT APPLY TO END USER IN WHOLE OR IN PART, WHERE SUCH
ARE RESTRICTED LIMITED OR EXCLUDED BY APPLICABLE LAW AND SUCH SHALL APPLY TO THE
MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW.
URC SHALL NOT BE HELD RESPONSIBLE FOR THE STATEMENTS MADE BY OTHERS.
SOME STATES OR JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL
OR CONSEQUENTIAL DAMAGES, OR ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY
LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO END USER. THIS LIMITED
WARRANTY GIVES END USER SPECIFIC LEGAL RIGHTS AND END USER MAY HAVE OTHER RIGHTS
WHICH VARY FROM STATE TO STATE OR JURISDICTION TO JURISDICTION.
ZR-2 REPEATER
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one more of the following measures:
u Reorient or relocate the receiving antenna.
u Increase the separation between the equipment and receiver.
End User Agreement
u Connect the equipment into an outlet on a circuit different from that to
The terms and conditions of the End User Agreement available at www.universalremote.com/eua.php shall
apply.
which the receiver is connected.
u Consult the dealer or an experienced radio/TV technician for help.
ZR-2 REPEATER
Warning!
Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
Note : The manufacturer is not responsible for any Radio or TV interference
caused by unauthorized modifications to this equipment. Such
modifications could void the user's authority to operate the equipment.
FCC Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the authority to operate equipment.
The antenna(s) used for this transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Federal Communication Commission (FCC) Radiation Exposure
Statement
This remote device is approved as a hand-held and hand-operated only
portable (relative to hand) device which is normally operated at 20 cm
from a person's body.
support, either.
2. URC’S Limitations of Liability
IN NO EVENT SHALL URC BE LIABLE FOR INDIRECT, SPECIAL, INCIDENTAL, EXEMPLARY, PUNITIVE OR
Page 5
Page 6
Page 7
Page 8
ZR-2 Repeater
Owner's Manual
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising