Sound Bar

Startup Guide

HT-MT300/MT301

Bar Speaker Subwoofer

4-688-01221(1)

What’s in the box

Bar Speaker (1) Subwoofer (1) Remote control (1)

R03 (size AAA) battery (2) Optical digital cable (1) AC adapter (1)

U.K./Ireland models

AC power cord (mains lead) (1)

Australia/New Zealand models

AC power cord (mains lead) (1)

Speaker pad for the subwoofer (4)

Operating Instructions Startup Guide (this document)

To set up the remote control

When installing the subwoofer horizontally, use the speaker pad

(supplied).

1

Connecting with a TV

Is there an optical digital jack on your TV?

YES NO

Audio signal Optical digital cable (supplied)

Blu-ray Disc™ player, cable box or satellite box, etc.

Blu-ray Disc player, cable box or satellite box, etc.

Audio signal Analog audio cable (not supplied)

2

Turning on the system

 /

Power indicator (green)



AC power cord (mains lead) (supplied) AC adapter (supplied)

 Connect the AC adapter and AC power cord (mains lead), then connect the AC adapter to the Bar Speaker. Connect the AC power cords (mains leads) of the Bar Speaker and subwoofer to the AC outlets (mains).

 Press  (power) on the remote control of the system.

An input indicator lights up.

 Confirm that the power indicator of the subwoofer is lit in green.

If not, refer to “Subwoofer” of “Troubleshooting” in the Operating Instructions (separate document).

Note

• Do not place magnetic cards on the system or near the system.

• Do not place metal objects other than a TV around the system. Wireless functions may become unstable.

To install the subwoofer under a sofa

 Put the speaker pads on the subwoofer, then place the subwoofer under a sofa with the speaker facing upward.

 Hold down VOICE on the remote control of the system for 5 seconds.

The USB and ANALOG indicators flash twice, then the sofa mode is activated. The sound quality is changed to suit when the subwoofer is installed under a sofa.

Speaker pad (supplied)

Subwoofer

3

Listening to the sound

 /

Power

Input

TV



+/–

SW



+/–

 Turn on the TV, then select the desired program or input using the remote control of the TV.

 Press TV on the remote control of the system to turn on the TV indicator.

If you connected your TV to the ANALOG jack in step 1, press ANALOG on the remote control of the system.

 Adjust the volume.

Adjust the volume by pressing  +/– on the remote control of the system.

Adjust the volume of the subwoofer by pressing SW  +/– on the remote control of the system.

Setup completed! Enjoy!

Please refer to the supplied Operating Instructions for details about the other functions and Troubleshooting.

Operating Instructions

Note

• If the TV’s headphone jack also serves as an audio output jack, check the TV’s audio output settings. For details, refer to the TV’s operating instructions.

• Make sure that the cables are firmly inserted.

© 2017 Sony Corporation Printed in Malaysia