Add-On Computer Peripherals (ACP) SFP-FE-SX-MM1310-AO network transceiver module Datasheet
Add to my manualsadvertisement
SFP-‐FE-‐SX-‐MM1310-‐AO
HUAWEI 40GBASE-‐CU QSFP+ DAC
TWINAX 5M PASSIVE
SFP-‐FE-‐SX-‐MM1310-‐AO
4 Channel 10GBase QSFP+ Tranceiver Cable
Features www.addoncomputer.com
• QSFP+ conforms to the Small Form Factor SFF-‐8436
• 4-‐channel Full-‐Duplex Passive Copper Cable Transceiver
• Support for multi-‐gigabit data rates: 1 Gb/s – 10 Gb/s
(per channel)
• Maximum aggregate data rate: 40 Gb/s (4 x 10 Gb/s)
• Copper link length up to 5m (passive limiting)
• High-‐Density QSFP 38-‐PIN Connector
• Power Supply: +3.3V
• Lower power consumption: 0.02 W (typ.)
• I2C based two-‐wire serial interface for EEPROM signature which can be customized
• Temperature Range: 0~70°C
Standard Compliance
• IEEE 802.3ba
• SFF-‐8436
• InfiniBand
Applications
• 10 Gigabit Ethernet
• 40 Gigabit Ethernet
• InfiniBand 4x SDR, DDR, QDR
• 2, 4, 8, 10 Gigabit Fiber Channel
• Fiber Channel over Ethernet
• SAS, Servers, Hubs, Switches,
Routers
• QSFP+ MSA
• RoHS Compliant
Product Description
AddOn Computer’s SFP-‐FE-‐SX-‐MM1310-‐AO passive cable assemblies are high performance, cost effective I/O solutions for 40G LAN, HPC and SAN applications. The QSFP+ passive copper cables are compliant with SFF-‐8436,
QSFP+ MSA and IEEE P802.3ba 40GBASE-‐CR4. It offers low power consumption, and short-‐reach interconnect
applications. The cable each lane is capable of transmitting data at rates up to 10Gb/s, providing an aggregated rate of 40Gb/s. www.addoncomputer.com Phone: 877.292.1701 1
16
17
18
19
13
14
15
20
21
22
23
24
25
26
10
11
12
7
8
9
3
4
5
6
1
2
Absolute Maximum Ratings
Parameter
Storage Ambient Temperature
Operating Case Temperature
Power Supply Voltage
Power Dissipation
Pin Descriptions
Pin Logic
Symbol
Tc
V
CC3
PD
Min.
-‐40
0
3.14
Symbol Name/Descriptions
CML-‐O
CML-‐O
CML-‐O
CML-‐O
CML-‐O
CML-‐O
CML-‐O
CML-‐O
CML-‐I
CML-‐I
CML-‐I
CML-‐I
GND
Tx2-‐
Tx2+
GND
Tx4-‐
Tx4+
Module Ground
Transmitter inverted data input
Transmitter non-‐inverted data input
Module Ground
Transmitter inverted data input
Transmitter non-‐inverted data input
LVTTL-‐I
LVTTL-‐I
GND Module Ground
MODSEIL Module Select
ResetL Module Reset
LVCMOS-‐I
VCCRx
SCL
LVCMOS-‐I/O SDA
+3.3v Receiver Power Supply
2-‐wire Serial interface clock
2-‐wire Serial interface data
GND
RX3+
RX3-‐
GND
RX1+
RX1-‐
GND
GND
RX2-‐
RX2+
GND
RX4-‐
RX4+
GND
Module Ground
Receiver non-‐inverted data output
Receiver inverted dta output
Module Ground
Receiver non-‐inverted data output
Receiver inverted data output
Module Ground
Module Ground
Receiver inverted data output
Receiver non-‐inverted data output
Module Ground
Receiver inverted data output
Receiver non-‐inverted data output
Module Ground
Typ.
3.3 www.addoncomputer.com Phone: 877.292.1701
Max.
85
70
3.47
0.02
Ref.
1
1
1
1
1
1
2
2
1
2
2
1
1
Unit
°C
°C
V
W
2
27
28
29
30
31
32
33
34
35
36
37
CML-‐I
CML-‐I
CML-‐I
CML-‐I
LVTTL-‐O
LVTTL-‐O
LVTTL-‐I
Tx3+
Tx3-‐
GND
Tx1+
Tx1-‐
ModPrsL Module Present, internal pulled down to GND
IntL Interrupt output, should be pulled up on host board
VCCTx +3.3v Transmitter Power Supply
VCC1 +3.3v Power Supply
LPMode Low Power Mode
GND Module Ground
Transmitter non-‐inverted data input
Transmitter inverted data input
Module Ground
Transmitter non-‐inverted data input
Transmitter inverted data input
38 GND Module Ground 1
Note:
1. GND is the symbol for signal and supply (power) common for the QSFP+ module. All are common with the QSFP+ module and all module voltages are references to this potential unless otherwise noted.
Connect these directly to the host board signal-‐common ground plane.
2. Vcc Rx, Vcc1 and Vcc Tx are the receiver and transmitter power supplies and shall be applied concurrently. Requirements defined for the host side of the Host Edge Card Connector are listed in Table
6. Recommended host board power supply filtering is shown in Figure 4. Vcc Rx Vcc1 and Vcc Tx may be internally connected within the QSFP+ Module in any combination. The connector pins are each rated for a maximum current of 500 mA.
Electrical Pin-‐out Details
2
1
2
1
www.addoncomputer.com Phone: 877.292.1701 3
Mechanical Dimensions
www.addoncomputer.com Phone: 877.292.1701
4
QSFP+ Host Board Schematic for Passive Copper Cables www.addoncomputer.com Phone: 877.292.1701 5
Contact Information
AddOn Computer, Inc. is a leading supplier of Memory Upgrade, Network Transceivers and Network connectivity products to Channel Partners, Resellers and OEMs, with more than seventeen years of direct industry experience. AddOn Computer has been the exclusive supplier to Ingram Micro's "Memory Upgrades" program
for the past nine years.
AddOn Computer maximizes profitable opportunities for our partners. Our ability to source product worldwide, ensures that our pricing will always be competitive. Offering turnkey solutions, AddOn Computer has forged a reputation as a solutions provider, delivering high quality, cost effective product in a timely and reliable manner.
Corporate office:
AddOn Computer
30400 Esperanza
Rancho Santa Margarita, CA 92688
Tel: 877-‐292-‐1701
Fax: 949-‐266-‐9273
Email: [email protected]
Email: [email protected]
Web: http://www.addoncomputer.com
www.addoncomputer.com Phone: 877.292.1701 6
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement