Brodit ProClip 654865 Datasheet

27 January, 2015, www.brodit.com, © 2015 Brodit AB

Product 654865

654865 ProClip

Angled mount

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

EAN: 7320286548656

Item no 654865 fits:

Mazda BT 50 13-15 (Australia)

1 (2)

INSTALLATION INSTRUCTIONS

1.

2.

3.

4.

Please read the instructions and look at the pictures before attaching the ProClip.

1. Press the thin end of the enclosed gap opener into the gap between the center console frame and the dash board, to widen the gap. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel of the adhesive tape cover on the ProClip. Press the angled edge on the right part of the ProClip into the gap between the climate control panel and the surrounding frame.

2. Press forward on the left side of the ProClip so the angled edge hooks into the gap above the gap opener.

3. Press on the left part of the ProClip so the angled edge goes all the way into the gap. Pull out the gap opener.

4. The ProClip is in place.

2 (2)