Kingston Technology ValueRAM 4GB DDR3L-1600MHz Server Premier

Kingston Technology ValueRAM 4GB DDR3L-1600MHz Server Premier
Memory Module Specifications
4GB 1Rx8 512M x 72-Bit PC3L-12800
CL11 240-Pin ECC DIMM
This document describes ValueRAM's 512M x 72-bit (4GB)
11 cycles
DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 1Rx8, ECC,
Row Cycle Time (tRCmin)
48.125ns (min.)
low voltage, memory module, based on nine 512M x 8-bit FBGA
Refresh to Active/Refresh
Command Time (tRFCmin)
260ns (min.)
components. The SPD is programmed to JEDEC standard
latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This
Row Active Time (tRASmin)
35ns (min.)
240-pin DIMM uses gold contact fingers. The electrical and
Maximum Operating Power
(1.35V) = 1.458 W*
UL Rating
94 V - 0
Operating Temperature
0o C to 85o C
Storage Temperature
-55o C to +100o C
mechanical specifications are as follows:
JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~
1.575V) Power Supply
VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 11, 10, 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
Bi-directional Differential Data Strobe
Thermal Sensor Grade B
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
Asynchronous Reset
PCB: Height 1.18” (30mm), single sided component
Hynix B-Die
Continued >>
Document No. VALUERAM1457-001.A00
Page 1
Document No. VALUERAM1457-001.A00
Page 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF