DESCRIPTION This selects what is sent to the control room headphones and speakers EXT1 is the output of a PODBLASTER / ALPS / COMPOSER PRO Audio Processor – If fitted to your system. S2 Mixer Quick Start This sends the output of the channel to the PGM Output. This button must be selected on channels you want to stream around the building. This selects what is sent to the LED PPM Meters CR MON follows what you have selected to listen to on the Monitor Channel.. This sends the output of the channel to the AUD Output. This button must be selected on channels you want to record back into Myriad. This controls the volume of the studio speakers. PLEASE NOTE: The speakers will MUTE when the MIC channels are used, this is to prevent audio feedback which can damage your hearing. This selects which input should be used for the channel. Normally this is INP1 for Myriad and CD channels & MIC for Mic channels. This sends the input from any channel you select on CUE / PFL to the speakers, so you can hear the channel you want to pre-fade. This is an Equalizer (EQ) to adjust the sound of the Input signal. LOCK indicates that the AES / EBU DIGITAL Output is in sync and operating correctly. This controls the volume of the studio headphones. PLEASE NOTE: The headphones are NOT level limited, prolonged loud levels can damage your hearing. TRIM is used to increase or decrease the volume of the input. BAL / PAN is used to adjust the input to be greater on the Left or Right of the stereo outputs. This sends the input from any channel you select on CUE / PFL to the speakers, so you can hear the channel you want to pre-fade. CUE / PFL is used to listen to the channel before you raise the fader. That way you can cue up CD’s or check how interviews end. You should use this to set the channels input level before raising the fader (PFL = Pre Fade Level). This sends splits the headphone feed so that you can hear CUE / PFL in one ear and the PGM / AUD / EXT1 output in the other. This is perfect for beat matching a CD on pre-fade with one already playing on air. This is the LED PPM METER (Peak The FADER is used to add the channel to the PGM or AUD mix. This is your final level control. Programme Meter), a visual guide to the levels of the inputs and the final mix. If the indicators reach RED then distortion can be introduced into the mix, this cannot be removed after recording. Ideal levels should LINE HOLD captures the call from the telephone handset, and routes it to the mixer. peak at PPM 5 (0vu). ON turns the channel on and introduces it to the PGM or AUD mix. TBU Channel Myriad / CD Channel Mic AUD PGM Monitor Channel O/P Channel O/P Channel Channel Installation Documentation Sonifex S2 Mixer Quick Start Guide © P Squared Ltd 2009 1-2 Maritime House, Maritime Business Park, Livingstone Road, Hessle, East Yorkshire, HU13 0EG. Job: Drawn by; DWG NO S2 David Boulton S2_INFO SCALE 1:20 [email protected] +44(0)1482 350 700 REV SHEET 1 OF 1
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement