1-Port 10/100Base-TX + 1-Port BNC Ethernet over Coaxial Extender

1-Port 10/100Base-TX + 1-Port BNC Ethernet over Coaxial Extender
VC-202A
1-Port 10/100Base-TX + 1-Port BNC Ethernet over
Coaxial Extender
The VC-202A equips one RJ-45 and one BNC Port to transmit the
Ethernet data over the most widespread coaxial cable. Therefore, it is very
suitable and costless for upgrading legacy devices to new digital devices of
IP-based network because almost every house or block on the street could
use the existing coaxial cable to transmit data to the Internet and the
whole building could share the Internet line in the wide network area with
minimum cost. Reuse the existing cable instead of new wire can save extra
wiring cost as the coaxial cable and Ethernet line are already available.
Easy Installation
There are two selectable models of the VC-202A, one is used for client
side (CPE) and the other is for central side (CO). The VC-202A converter is
Ethernet Distance extension via Coaxial
PLANET VC-202A is the high-performance Ethernet-over-Coaxial extender
that converts between twisted pair (UTP) and coaxial cable for every kind
of IP Ethernet application. It offers the absolutely fastest data transmission
speed over existing coaxial cable without the need of rewiring. On the
UTP side, the VC-202A uses a modular EIA / TIA 568 RJ-45 connector
that supports CAT-5/5e or above wiring with the distance up to 100
meters (328 feet). On the coaxial cable side, the VC-202A utilizes a BNC
connector that supports 50ohm or 75ohm coaxial cable with the distance
up to 3km. It is ideal for extending the distance and signal conversion by
transmitting the Ethernet data from the coaxial cable for any type of IP
network device such as IP camera, wireless access point, NVR and digital
signage.
a plug and play device without the need of configuring by software and
is also compliant with all kinds of network protocols. Moreover, the rich
diagnostic LEDs on the front-panel show the operating status of individual
port and the whole system.
Provides Superior Upstream and Downstream Transmission
The VC-202A defines asymmetric (Plan 998) and symmetric mode for the
transmission of upstream and downstream signals. The symmetric mode
provides similar transmission rate on both downstream and upstream.
On the other hand, the asymmetric mode performs higher transmission
quality in short range for central side (CO). In all, when the VC-202A is in
symmetric mode, it provides better upstream performance, and when it is
in asymmetric mode, it gives better downstream performance.
Before
Key Features
UTP
NVR
IP Camera
• Defines Asymmetric (Plan 998) and Symmetric for the
transmission of upstream and downstream signals
100m
• Cost-effective Profile 17a CO / CPE bridge solution
After (with VC-202A)
• One box design, CO / CPE selectable via DIP Switch
UTP
Coaxial
UTP
• Complies with IEEE 802.3, IEEE 802.3u and IEEE 802.3x
standards
VDSL2
IP Camera
VC-202A
VC-202A
NVR
3.0km
• DMT (Discrete Multi-Tone) line coding
100BASE--TX UTP
VDSL2
VDSL2 Coaxial Cable
Cost-effective / Quick Upgrade Legacy Devices to All-IP network
PLANET VC-202A Ethernet extender provides a quick replacement and
smooth migration solution from existing analog system to full digital
system. For example:
- Upgrade analog camera to digital IP Camera
- IP Digital Signage deployment
- Cable TV to IPTV
• Half Duplex Back-Pressure and IEEE 802.3x Full Duplex Pause
Frame Flow-Control
• Supports up to 1,536 bytes packet size, IEEE 802.1Q VLAN tag
transparent
• Standalone transceiver for simple bridge modem application
• Advantage of minimum installation time (Simply as Plug-andPlay)
• Selectable target band plan and target SNR margin
• Supports extensive LED indicators for network diagnostics
• Co-work with PLANET MC family Media Chassis (MC-700 /
1500 / 1500R / 1500R48)
• Compact in size, easy installation
1
VC-202A
Applications
Community / Campus Surveillance and Security over IP
To take advantage of digital surveillance system and keep the benefits of coaxial cable, the VC-202A helps the community, campus and enterprises
to upgrade analog camera system to IP camera surveillance without using additional new wires. The Extender is a switching architecture with one
RJ-45 10/100Mbps Fast Ethernet port and one BNC Ethernet over Coaxial port. Just plug-in the UTP cable of IP camera to Ethernet port and the
existing coaxial cable to the BNC connector. It is easy to deploy and extend the distance with signal conversion by transmitting the Ethernet data
from the standard coaxial cable. Furthermore, with high transmit data rate, the VC-202A solution supports multiple IP cameras input for sharing in
one coaxial cable to reduce the cost of cabling.
Analog Camera
A/V
DVR Utility
A/V
A/V
DVR
Analog Camera
A/V
100BASE-TX UTP
A/V
Audio Line / Video Line
Reuse Coaxial Cable, Digitalized IP Surveillance
IP Camera
VC-202A CPE
VDSL2
IP Camera NVR
VDSL2
VDSL2
VC-202A CO+
MC-700 Chassis
Ethernet
Switch
VDSL2
IP Camera
100BASE-TX UTP
VDSL2
3.0 km
Long Reach
VDSL2 Coaxial Cable
IP Cameras Quick Expansion
IP Camera
VC-202A CO
VC-202A CPE
CAM Viewer
VDSL2
Ethernet Switch
Reuse Coaxial
Cable
100BASE-TX UTP
VDSL2
IP Camera
VDSL2 Coaxial Cable
3.0 km
Long Reach
2
VC-202A
Applications
MTU / MDU / Hospitality Solution
IPTV, VOD and digital message broadcasting services are the worldwide hot trends, and more and more service providers have upgraded the client
side devices from analog system to digital system gradually. The VC-202A will be the best solution because it provides cost-effective and high
speed network services by utilizing the existing coaxial cable infrastructure. IP network installation is straightforward. With enough bandwidth, the
100/100Mbps symmetric capability of VC-202A makes many Multi-Media services on local Internet come true, such as VOD (Video on Demand),
Voice over IP, Video phone, IPTV, distance education, and so on. It satisfies most of entertainment and communication layer. Meanwhile, this kind of
infrastructure also minimizes the burden on the Internet.
HOTEL
VC-202A CO
IPTV
VDSL2
Room
Laptop
VC-202A CO
VDSL2
Room
VC-202A CO
IP Camera
VDSL2
Room
Internet
VC-202A CPE+
MC-700 Chassis
Ethernet
Switch
IPTV Provider
VDSL2
VDSL2 Coaxial Cable
100Base-TX UTP
Media Center
1000Base-T UTP
Commercial Location Media Network and Electronic Billboards
More and more media network and electronic billboards are built in commercial locations to deliver information over office buildings, shopping
centers and stations in the cities. Integrating with Set-Top Box and LCD TV, the VC-202A provides an immediate and interactive broadcasting system
over direct Ethernet connection instead of constant content and data exchange by human resource. It can also be integrated with IPTV and Web TV.
Through the remote management function, administrators can interrupt the TV program for the News and the commercials. It saves labor and gets
better commercial effect.
Media
Broadcast
• CF/USB/CDROM with constant content
Center
Internet
•
•
•
•
•
•
• Human Resource
• Content change every week, slow
Broadcast via Ethernet directly
Immediately, Interactive
Lower Human Resource
Integrate eith IPTV ,Webtv
Live news insert
Remote program schedule
RJ-45
Set-Top Box
Media
Content
LCD TV
OLD
NEW
3
VC-202A
Specification
Product
1-Port 10/100Base-TX + 1-Port BNC Ethernet over Coaxial Extender
Model
Hardware Specification
VC-202A
Ports
DIP Switch
Functionality
Encoding
LED Indicators
Cabling
Performance
Dimension (W x D x H)
Weight
Power Requirement
Power Consumption
Standard Conformance
Regulation Compliance
Standards Compliance
10/100Base-TX: 1 RJ-45, Auto-negotiation and Auto-MDI / MDI-X
Coaxial: 1 BNC, female connector
4 position DIP switch
CO / CPE mode select
Selectable fast and interleaved mode
Selectable target Band Plan
Selectable target SNR mode
DMT (Discrete Multi-Tone) line coding
- ITU-T G.997.1
- ITU-T G.993.1
- ITU-T G.993.2 (Profile 17a Support)
One Power
3 for Coaxial (BNC):
- Green, LNK
- Green, CO mode
- Green, CPE mode
2 for per RJ-45 10/100Base-TX port
- Green, LNK / ACT
- Green, Speed
Ethernet : 10Base-T: 2-pair UTP Cat.3, 4 and 5 up to 100m (328ft)
Ethernet : 100Base-TX: 2-pair UTP Cat.5, 5e and 6 up to 100m (328ft)
Coaxial Cable: 50ohm, RG58A / U, RG58C / U, RG58 / U or equivalent; 75ohm, RG-6(Distance up to 3.0km)
Asymmetric
Symmetric
200m ->100/65Mbps
400m ->100/64Mbps
600m ->100/59Mbps
800m ->100/53Mbps
1000m -> 94/44Mbps
1200m -> 84/36Mbps
1400m -> 74/28Mbps
1600m -> 66/19Mbps
1800m -> 60/14Mbps
2000m -> 44/15Mbps
2200m -> 35/12Mbps
2400m -> 32/10Mbps
2600m -> 29/8Mbps
2800m -> 27/6Mbps
3000m -> 25/5Mbps
200m ->99.7/100Mbps
400m ->100/100Mbps
600m -> 86/91Mbps
800m -> 79/80Mbps
1000m -> 69/66Mbps
1200m -> 60/52Mbps
1400m -> 51/41Mbps
1600m -> 45/36Mbps
1800m -> 40/29Mbps
2000m -> 27/26Mbps
2200m -> 23/24Mbps
2400m -> 22/21Mbps
2600m -> 20/18Mbps
2800m -> 18/15Mbps
3000m -> 17/13Mbps
97 x 70 x 26 mm
0.2 kg
5V DC 2A
6.3Watts / 21BTU (maximum)
FCC Part 15 Class A, CE
IEEE 802.3 10Base-T
IEEE 802.3u 100Base-TX
IEEE 802.3x Full Duplex Pause Frame Flow-Control
ITU-T
- G.993.1
- G.997.1
- G.993.2 (Profile 17a Support)
Environment
Networking Protocol
Storage
Temperature:
Humidity:
Temperature:
Humidity:
0 ~ 50 Degree C
5~90%, relative humidity (non-condensing)
-10~70 Degree C
5~90%, relative humidity (non-condensing)
* The actual data rate will vary on the quality of the copper wire or coaxial cable and environment
4
VC-202A
Ordering Information
VC-202A
1-Port 10/100Base-TX + 1-Port BNC Ethernet over Coaxial Extender
Relative Product
IVC-2002
Industrial Ethernet Extender ( 1 BNC / RJ-11 + 4-Port 10/100TX-17a Profile, -40~75 Degree C)
MC-700
MC-1500
MC-1500R
7-Slot 10" Media Converter Chassis
15-Slot 19" Media Converter Chassis
15-Slot 19" Media Converter Chassis (AC Power) with Redundant Power System
5
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement