advertisement
3000
Electronic Entry Device
USER OPERATING INSTRUCTIONS
FEATURES
See Manager Instructions for additional features.
USER Combination
• Open Lock
• Change Combination
WRONG TRY PENALTY
• Four (4) consecutive invalid combination
initiates five (5) minute delay period.
LOW BATTERY WARNING
• Repeated LED flashing and beeping during
opening indicates battery is low and needs
immediate replacement.
AUDIO AND VISUAL SIGNAL
• Double signal - two (2) LED flashes and two
(2) beeps - indicates entry is valid
or accepted.
• Triple signal - three (3) LED flashes and
three (3) beeps - indicates invalid or
not accepted.
OPENING THE LOCK
1. Enter valid six (6) digit combination (factory set to 1-2-3-4-5-6).
2. The lock will confirm a valid combination entry with a double signal.
3. Within four (4) seconds, turn the handle to the open position.
4. Pull door open.
• Invalid Combination Entry - Lock will signal three (3) times.
WRONG TRY PENALTY
• Entry of four (4) consecutive invalid combinations starts a five (5) minute
delay period.
- LED flashes red at ten (10) second intervals.
• At the end of the delay period, two (2) more consecutive invalid combinations
will restart the five (5) minute delay period.
NOTE: Entry will not respond to keystrokes during delay period.
(P/N) 750.118 Rev B 02/12 • © copyright 2006-2012 Kaba Mas LLC
Page 1 of 2
CHANGING YOUR Combination
ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN
1. Enter “zero” six times.
2. Enter your existing six (6) digit combination one time.
3. Enter your NEW six (6) digit combination two times.
4. If a mistake is made wait thirty (30) seconds and repeat steps 1 - 3.
5. Test lock operation several times before closing the door.
CAUTION: When selecting a combination do not use birthday or other predictable data that could give correlation between the user and combination. Keep the combination secret.
• Valid Combination Entry - Double signal after valid six (6) digit combination
is entered.
• Invalid Combination Entry - Triple signal indicates the old combination is
still valid.
BATTERY LOW WARNING
• Repeated LED flashing and beeping during an
opening indicates that the battery is low and needs
immediate replacement.
• Uses two (2) 9-Volt alkaline batteries only. (Example:
Duracell™ or Eveready™ alkaline batteries.) It is
recommended that batteries be replaced at least
once a year.
If battery is depleted and will not allow lock to open, follow Instructions below. Lock contains a nonvolatile memory; even with batteries removed, the lock will retain all programming.
CHANGING YOUR BATTERY
1. Slide the keypad housing up and carefully pull away
from mounting surface to expose battery compartment.
2. Remove the two (2) old 9-Volt alkaline batteries.
3. Remove the connector by unsnapping it from
the two terminals on the top of the battery.
CAUTION: Hold onto battery terminal connector to avoid pulling the wires out of housing.
4. Press and hold the zero (0) key for ten (10) seconds
before installing the two (2) new batteries.
5. Carefully position the keypad over the mounting screws and slide the keypad
housing down. Ensure there are no wires or cables trapped between the input pad
and the safe door. Pinched cables can result in a short circuit.
Mounting Instructions available at www.kaba-mas.com.
(P/N) 750.118 Rev B 02/12 • © copyright 2006-2012 Kaba Mas LLC
Page 2 of 2
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project