AS-1100 Manual - Galaxy Audio
USER'S MANUAL
www.galaxyaudio.com/AS1100.php
USING THIS SYSTEM AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE.
USE AS LOW A VOLUME AS POSSIBLE.
WARNING!
In order to use this system safely, avoid prolonged listening at excessive sound pressure levels. Please use the following guidelines established by
the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.
90 dB SPL at 8 hours
95 dB SPL at 4 hours
100 dB SPL at 2 hours
105 dB SPL at 1 hour
110 dB SPL at ВЅ hour
115 dB SPL at 15 minutes
120 dB SPL — avoid or damage may occur
It is difficult to measure the exact Sound Pressure Levels (SPL) present at the eardrum in live applications. In addition to the volume setting on the
Personal Monitors, the SPL in the ear is affected by ambient sound from floor wedges or other devices. The isolation provided by the fit of quality
earpieces is also an important factor in determining the SPL.
Here are some general tips to follow in the use of this product to protect your ears from damage.
• Turn up the volume control only far enough to hear properly.
• Ringing in the ears may indicate that the gain levels are too high. Try lowering the gain levels.
• Have your ears checked by an audiologist on a regular basis. If you experience wax buildup in your ears, stop using the system until an
audiologist has examined your ears.
• Wipe the ear molds with an antiseptic before and after use to avoid infections. Stop using the earphones if they are causing great discomfort
or infection.
1.
2.
3.
4.
5.
6.
7.
READ these instructions.
11. ONLY USE attachments/accessories specified by the manufacturer.
KEEP these instructions.
12. UNPLUG this apparatus during lightning storms or when unused for long periods of
HEED all warnings.
time.
FOLLOW all instructions.
13. REFER all servicing to qualified service personnel. Servicing is required when the
DO NOT use this apparatus near water.
apparatus has been damaged in any way, such as power-supply cord or plug is damCLEAN ONLY with dry cloth.
aged, liquid has been spilled or objects have fallen into the apparatus, the apparatus
DO NOT block any ventilation openings. Install in accordance with the manuhas been exposed to rain or moisture, does not operate normally, or has been
facturer's instructions.
dropped.
8. DO NOT install near any heat sources such as radiators, heat registers, stoves,
14. DO NOT expose the apparatus to dripping and splashing. DO NOT put objects filled
or other apparatus (including amplifiers) that produce heat.
with liquids, such as vases, on the apparatus.
9. DO NOT defeat the safety purpose of the polarized or grounding-type plug. A
15. Remove the batteries from the receiver if the system will not be used for a long
polarized plug has two blades with one wider than the other. A grounding type
period of time. This will avoid any damage resulting from a defective, leaking
plug has two blades and a third grounding prong. The wider blade or the third
battery.
prong are provided for your safety. If the provided plug does not fit into your
16. DO NOT throw used batteries into a fire. Be sure to dispose of or recycle used
outlet, consult an electrician for replacement of the obsolete outlet.
batteries in accordance with local waste disposal laws.
10. PROTECT the power cord from being walked on or pinched, particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
LICENSING INFORMATION
THIS RADIO EQUIPMENT IS INTENDED FOR USE IN PROFESSIONAL ENTERTAINMENT
AND SIMILAR APPLICATIONS.
Changes or modifications not expressly approved by Galaxy Audio Incorporated could void your
authority to operate the equipment. Licensing of Galaxy Audio wireless microphone equipment is
the user's responsibility, and licensability depends on the user's classification and application, and
on the selected frequency. Galaxy Audio strongly urges the user to contact the appropriate
telecommunications authority concerning proper licensing, and before choosing and ordering
frequencies.
NOTE: THIS EQUIPMENT MAY BE CAPABLE OF OPERATING ON SOME FREQUENCIES NOT
AUTHORIZED IN YOUR REGION. PLEASE CONTACT YOUR NATIONAL AUTHORITY TO
OBTAIN INFORMATION ON AUTHORIZED FREQUENCIES FOR WIRELESS MICROPHONE
PRODUCTS IN YOUR REGION
Licensing: Note that a ministerial license to operate this equipment may be required in certain
areas. Consult your national authority for possible requirements.
FCC Consumer Alert for Wireless Microphones (U.S.)
Most users do not need a license to operate this wireless microphone system. Nevertheless,
operating this microphone system without a license is subject to certain restrictions: the system may
not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts);
and it has no protection from interference received from any other device. Purchasers should also be
aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are
subject to change.
For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCC's
wireless microphone website at www.fcc.gov/cgb/wirelessmicrophones
Introduction
Thank you for choosing a Galaxy Audio Wireless Personal Monitor system. You have joined
thousands of other satisfied customers. Our years of professional experience in design and
manufacturing ensure our products' quality, performance and reliability.
System Components
All AS-1100 systems include the following components:
AS-1100T Transmitter
AS-1100R Receiver
Power Supply
One Pair EB-3 Earbuds
One Antenna
Rack Ears
User Manual
SET
2
AS-1100T Transmitter Features:
Front Panel:
1
2
3
4
5
7
6
1
Headphone Jack.
5
Transmitter Menu Down Button.
Please See (system setup) on page 4.
2
Headphone Output Level Control.
Turn left to decrease the level,
turn right to increase the level.
6
Transmitter Set Button.
Please See (System Setup) on page 4.
7
On/Off Switch.
Press and hold two seconds to turn On,
press and hold to turn Off.
3
LCD screen.
Please See (System Setup) on page 4.
4
Transmitter Menu Up Button.
Please See (System Setup) on page 4.
Back Panel:
1
3
4
1
DC Power Input Jack.
2
Stereo/Mono Switch.
Stereo position preserves Left/Right
signals throughout system. Mono
position mixes Left/Right signals together.
3
3
2
Left Channel XLR/1/4" Combo Input Jack.
5
6
7
4
Right Channel XLR/1/4" Combo
Input Jack.
5
Left Channel Input Level Control.
6
Right Channel Input Level Control.
7
Antenna Jack. 50 ohms.
System Setup
GROUP
CHANNEL
MHz
AF L
AF R
1
GROUP
CHANNEL
MHz
AF L
AF R
2
GROUP
CHANNEL
MHz
AF L
AF R
3
GROUP
CHANNEL
Transmitter Programming:
Select a Group and/or Channel:
Press SET button. While Group number is flashing, press or
button to select a group as shown in 1 . Then press SET button
again. While Channel number is flashing, press or button to
select a Channel, as shown in 2 .
Note: When using multiple systems, for optimum results set all
of the systems to the same group number and select a different
channel number for each system in that group.
Audio Input Level Display:
Displays left and right channel audio input level, as shown in 3 .
Full Display:
Displays left and right channel audio input levels and selected
frequency, as shown in 4 .
Note: Adjust audio input levels to peak on only the loudest signals.
MHz
AF L
AF R
4
Receiver screen
GROUP
CHANNEL
MHz
RF
AF
STEREO
MONO
5
GROUP
CHANNEL
Body Pack Receiver Programming
Select a Group and/or Channel:
Press and hold SET button. While GROUP number is flashing, press
or button to select a Group as shown in 5 . Then press SET
again. While CHANNEL is flashing, press or button to
select a channel, as shown in 6 .
Battery Status:
Five level Battery Status Indicator, as shown in 7 . Replace batteries
when indicator starts blinking.
MHz
RF
AF
STEREO
MONO
6
GROUP
CHANNEL
MHz
RF
AF
STEREO
Stereo/Mono Mode Display:
The STEREO or MONO indicator 8 will automatically light to
display the type of signal being received, as selected on the
Transmitter.
Full Display:
Displays Battery Status, RF/Audio Level, Stereo/Mono
Mode and Selected Frequency, as shown in 9 .
MONO
7
GROUP
CHANNEL
GROUP
CHANNEL
2
MHz
RF
AF
MHz
RF
AF
STEREO
8
MONO
STEREO
MONO
9
4
Body Pack Receiver
Features:
1
2
3
4
1
Antenna.
2
RF Signal LED.
Lights when RF Signal is received.
3
Earphone Jack.
4
Output Level Control and On/Off Switch.
5
LCD Screen.
Please See (System Setup) on page 4.
6
Receiver Menu Down Button.
Please See (System Setup) on page 4.
7
Receiver programming SET Button.
Please See (System Setup) on page 4.
8
Receiver Menu Up Button.
Please See (System Setup) on page 4.
CHANNEL
GROUP
MHz
5
RF
AF
STEREO
MONO
15
6
SET
7
8
Wearing the Body Pack Receiver
Clip the receiver to a belt. For best results, slide the receiver
until the belt is pressed against the base of the clip.
+ +
-
Changing Batteries
SET
Expected life for two Alkaline batteries is approximately 6 hours.
When the LCD Battery Indicator is flashing (see below), the
batteries should be changed immediately, as shown on the left.
GROUP
CHANNEL
MHz
RF
AF
STEREO
5
MONO
Specifications
System
Transmitter
Band: UHF
Frequency Range: CODE D 584~607 MHz
CODE L 655~679 MHz
Transmitter Output Level: 10dBm
Operating Range Under Typical Conditions
300' (92m)
Note: Actual range depends on RF signal
absorption, reflection, and interference.
Audio Frequency Response: +/-3dB 60Hz~16KHz
Total Harmonic Distortion: +/-30KHz deviation
1KHz tone <1%
Dynamic Range: >90dB A-weighted
Operating Temperature Range:
14ВєF to 122ВєF (-10Вє C to +50Вє C)
Note: battery characteristics may limit this range
Max Audio input level: +6dBV
Gain Adjustment Range: 40dB
Input Impedance: 100KΩ
Dimensions: 1.5" x 8.3" x 3.78"
(38 x 212 x 96mm) (HWD)
Weight: 21oz. (605g)
Power Requirements: 12-18 VDC at
300 mA (supplied by external power supply)
XLR input:
Impedance balanced
Pin1 Ground (cable shield)
Pin2 Audio
Pin3 No Audio
Body Pack Receiver
Audio Output Level: 100mW
Sensitivity: -94dBm for 30dB
Image Rejection: >55dB
Dimensions: 3.74" x 2.6" x 1"
(95 x 65 x 25mm) (HWD)
Weight: 3.5oz. (100g) without batteries
Power Requirements: 2 (AA) size
alkaline or rechargeable batteries
Battery Life: About 5 hours
Accessories and Replacement Parts
Many of these parts and accessories may be found and purchased from the Galaxy Audio website in either the
Galaxy Store (www.galaxyaudio.com/store.php) or in the accessories tab of each products web page.
AS-EXTBNC - BNC Connector and Cable for front mounting the antennas on the DHTQUAD.
AS-ANTBNC - Replacement BNC Antenna for use with Galaxy Audio Wireless Personal
Monitors. (Part number will vary based on the Frequency Code of specific unit)
AS-CLIP911R - Replacement Belt Clip for AS-900, AS-1100, MBP52, & MBP64
PS-13.5-.35.5 - 600mA Replacement Power Supply for AS-900, AS-1100, AS-1800, VES,
VSC, ECD, ECM, PSE, & DHT.
AS-UA12-14.5 - 1000mA Universal Power Supply for Replacement Power Supply for AS-900,
AS-1100, AS-`1800, VES, VSC, ECD, ECM, PSE, DHT, DHTRQUAD, & CTS. Includes
adapters for most other countries.
ANT-PDL - Directional antenna used to decrease interference to other equipment. Frequency
range 500-900MHz The UHF wide-band (500-900 MHz) directional LPDA (log periodic dipole
array) antenna reduces outside interference while providing increased send/receive signal
range. Each antenna paddle is matched to 50 ohms impedance with a low-loss BNC
connector; 7dBi gain. For permanent or temporary installation; mounts to 5/8"-27 threads.
EB3 - Ear buds which come standard with our Wireless Personal Monitor Systems with 1/8" 3.5mm Jack.
EB3S - Replacement Sleeves for EB-3 Ear Buds. 5 pair in each pack. Available in Small,
Medium, or Large.
MRE900/1100 - Replacement Single Rack Kit for AS-900 & AS-1100: 2 pieces with screws.
BATTCVR11005264 - Replacement Battery Cover for AS-1100 Body Pack.
6
THREE YEAR LIMITED WARRANTY
WARRANTY Information can be viewed online at
http://www.galaxyaudio.com/warranty.php
USER'S MANUAL
Specifications in this manual are subject to change without notice.
For the most up to date manual and information
visit www.galaxyaudio.com.
1-800-369-7768
www.galaxyaudio.com
В© Copyright Galaxy Audio 2014
Printed in China
V20141105
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement