pdf135 04 229 003 EH 0115

pdf135 04 229 003 EH 0115
135-04-229-003-EH-0115.pdf
135-04-229-003-EH-0115
JX-P420 SERIES
4 to 20 mA OUTPUT
The JX-P420 series linear position measuring transducer is a low cost device for use in
moderate duty applications in hostile wet or dry environments. The chemical resistant thermoplastic
case of the transducer provides NEMA 4 (IP-65) ingress protection for applications where exposure to
washdown, rain, oil and other liquids may occur. The sealed case is achieved through the use of o-rings
and a low friction shaft seal. An integral dust wiper insures that the wire rope stays clear of debris as
it is extracted and retracted. The standard electrical connection includes a sealed bulkhead fitting and
multi-conductor electrical cable. An optional connector and mating connector are also available. As a
convenience, optional connector locations on the transducer body are offered. The wire rope exit direction
may be specified at time of order or may be user adjusted at time of installation.
The JX-P420 series transducer is a loop powered device with a 4 to 20 mA current output that requires a
two wire connection. The transducer, power supply, and current monitor are connected in series. Zero and span
adjustment potentiometers are accessible by removing two sealing screws in the rear of the transducer housing. Zero and span allow
for adjustment for a full 4 to 20 mA output at between 50% and 100% of maximum linear travel.
SPECIFICATIONS
GENERAL
Measurement Range........................See Range Table below
Sensing Device ................................Precision Potentiometer
Resolution.........................................Essentially Infinite
Linearity
2", 2.8", 3.8", 4.7" ranges...............±1.0% Full Scale
10" to 25" ranges............................±0.5% Full Scale
30" to 80" ranges............................±0.25% Full Scale
Repeatability ....................................±0.02% Full Scale
Construction ....................................Thermoplastic Body
Wire Rope.........................................Ø.018 (0.46 mm) Jacketed Stainless Steel
Wire Rope Tension............................See Supplemental Data[1]
Weight ..............................................6.7 oz. (190 gm)
Connections .....................................Electrical cable, or plastic connector
Life
Ranges to 4.7"................................2,000,000 full stroke cycles
Ranges 10" to 25"...........................500,000 full stroke cycles
Ranges 30" to 80"..........................250,000 full stroke cycles
ENVIRONMENTAL
Operating Temperature.....................-25°C to 75°C
Storage Temperature........................-50°C to 80°C
Operating Humidity...........................100% R.H. NEMA 4,
90% R.H. non-condensing NEMA 12
Vibration...........................................15 G’s 0.1 ms max.
Shock................................................50 G’s 0.1 ms max.
Ingress Protection.............................NEMA 4X (IP-65) or NEMA 12 (IP-52)
ELECTRICAL
Output........................................................................ 4 to 20 mA
Load Resistance (Total Loop).................................... See Graph Below
Excitation Voltage ...................................................... 9 to 35 VDC
Minimum Supply Voltage........................................... (.02 x Load Res.) + 9 VDC
Insulation Resistance................................................. 100 Megohms min. at 100 VDC
Zero Set Adjustment Range....................................... 0 to 30% of Range
Span Set Adjustment Range...................................... 80% to 100% of Range
Protection................................................................... Fused & Reversed Polarity
LOAD RESISTANCE VS INPUT VOLTAGE
ZERO & SPAN ACCESS
FOOTNOTES TO SPECIFICATIONS
1. Supplemental Data section located at end of JX Series pages.
MODEL Number
NUMBER CONFIGURATION
Model
Configuration
Basic Configuration
(for all ranges)
JX-P420-50-N11-20S-31N
RANGE
2���������������2" (50 mm)
2.8���������2.8" (70 mm)
3.8���������3.8" (96 mm)
4.7........ 4.7" (120 mm)
10........... 10" (250 mm)
15........... 15" (390 mm)
20..........20" (500 mm)
25..........25" (640 mm)
30..........30" (750 mm)
40........ 40" (1000 mm)
50........ 50" (1250 mm)
60........ 60" (1500 mm)
80........80" (2000 mm)
WIRE ROPE
INGRESS PROTECTION
CONNECTOR LOCATION
N.........Ø.018 (0,45 mm) Nylon Jacketed Stainless Steel
Use Number designators shown
1.........Standard (See Table A & B for values)
1.................... IP-65 (NEMA 4X) dust and
spraying water protection
2.................... IP-52 (NEMA12) dust and dripping liquids
WIRE ROPE EXIT DIRECTION
ELECTRICAL OUTPUT POLARITY
Use Number designators shown
S..................... Standard (increasing output as wire rope is extended)
R..................... Reversed (decreasing output
as wire rope is extended)
WIRE ROPE TENSION
ELECTRICAL CONNECTION
END VIEW
1........... Bulkhead fitting with electrical cable
3........... 3 pin connector with mating connector
(electrical cable with connector optional)
Notes: With option 1, electrical cable must be
included from option box 9.
With option 3, mating connector may be ordered
with or without electrical cable. See Electrical
Cable options for cable lengths.
TOP VIEW
ELECTRICAL CABLE
N................................No Electrical Cable[1]
1................................1 m (3’ )[2]
2................................2 m (6.5’ )[2]
3................................3 m (10’ )[2]
4................................4 m (13.5’ )[2]
5................................5 m (16.5’ )[2]
1) Selection N applies to (option box 7)
Electrical Connection option 3 only (3 pin
connector with mating connector).
2) One of options 1 through 5 is required
when (option box 7)Electrical Connection
option 1 (Bulkhead Fitting) is selected or
if electrical cable is required with mating
connector when Electrical Connection
option 3 (3 pin connector with mating
connector) is required.
135-04-229-003-EH-0115.pdf
135-04-229-003-EH-0115
JX SERIES
SUPPLEMENTAL DATA
DIMENSIONAL INFORMATION
JX Series – Ranges to 50” (1250 mm)
JX Series – Ranges 60” (1.5 m) and 80” (2 m)
TABLE A
RANGE
2, 10
2.8, 15, 30
3.8, 20, 40
4.7, 25, 50
TABLE B
DIM “A”
NOMINAL
WIRE ROPE
TENSION
(in)
(mm)
(oz)
(N)
.36
.50
.66
.82
9.1
12.7
16.7
20.8
16
14
11
8
4.4
3.9
3.1
2.2
(dimensions in brackets are millimeters)
RANGE
DIM “A”
60
80
.98 24.9
1.28 32.5
(in)
(mm)
NOMINAL
WIRE ROPE
TENSION
(oz)
(N)
10
8.6
2.8
2.4
(dimensions in brackets are millimeters)
10067 – Auxiliary Wire Rope Extension Kit
The auxiliary wire rope extension may be used to facilitate mounting the transducer
remotely from the measurement point. The clip on the extension attaches to the eye fitting
on the transducer. The eye fitting on the opposite end, which is identical to the fitting on
the transducer, mounts to the moving element. The extension kit is also available with
the clip end unterminated for situations where it is more convenient to size the wire rope
length during installation. Clip and crimp fitting are included with the unterminated version.
Ø.188 (Ø4.8 mm) Eye Fitting
This end connects to the
moving element.
Clip--This end connects to
fitting on transducer
Crimp Sleeve
"L" ± 0.3 cm (0.12")
DIMENSION “L”
Specify Dimension “L” in centimeters to the
nearest whole centimeter
NOTES:1.1 cm = 0.394”, 1 inch = 2.54 cm
2.Shortest length “L” is 5 cm (approximately 2”)
UNTERMINATED CLIP END
Leave Blank...... Completed kit (No designator required)
U...................... Unterminated Clip End
(clip and crimp sleeve included in kit)
Headquarter Switzerland:
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Phone +41 44 877 35 00
[email protected]
Office Germany:
Pewatron AG
Neumarkter Straße 86a
D-81673 Munich
Phone +49 89 260 38 47
[email protected]
We are here for you. Addresses and Contacts.
Sales Switzerland & Liechtenstein
Sales International Key Accounts
Postcode 3000 – 9999
Postcode 1000 – 2999
Basil Frei
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Eric Letsch
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Peter Felder
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Phone + 41 44 877 35 18
Mobile + 41 76 279 37 26
Phone + 41 44 877 35 14
Mobile + 41 76 491 66 70
Phone + 41 44 877 35 05
Mobile + 41 79 406 49 83
[email protected]
[email protected]
[email protected]
Sales Germany
Postcode 00000 – 31999
Postcode 38000 – 39999
Postcode 80000 – 99999
Postcode 32000 – 37999
Postcode 40000 – 79999
Sales Austria
Kurt Stritzelberger
Pewatron AG
Neumarkter Straße 86a
D-81673 Munich
Gerhard Vetter
Pewatron AG
Fürstenbergstraße 12
D-55422 Bacharach-Medenscheid
Kurt Stritzelberger
Pewatron AG
Neumarkter Straße 86a
D-81673 Munich
Phone + 49 89 260 52 80
Mobile + 49 171 803 41 35
Phone + 49 674 394 75 75
Mobile + 49 163 762 74 30
Phone + 49 89 260 52 80
Mobile + 49 171 803 41 35
[email protected]
[email protected]
[email protected]
Pressure Sensors
Gas sensors / Gas sensor modules
Load cells
Linear position sensors
Angle sensors
Philipp Kistler
Phone + 41 44 877 35 03
[email protected]
Thomas Clausen
Phone + 41 44 877 35 13
[email protected]
Eric Letsch
Phone + 41 44 877 35 14
[email protected]
Accelerometers
Power supplies
Current sensors
Eric Letsch
Phone + 41 44 877 35 14
[email protected]
Sebastiano Leggio
Phone + 41 44 877 35 06
[email protected]
Sebastiano Leggio
Phone + 41 44 877 35 06
[email protected]
Drive technology
CH Postcode 5000 – 9999 / DE
Drive technology
CH Postcode 1000 – 4999 / AT / IT / FR
Roman Homa
Mobile + 41 79 444 00 86
[email protected]
Christian Mohrenstecher
Mobile +41 76 444 57 93
[email protected]
Sales Other Countries / Product Management
Competitive sensor & power supply solutions worldwide
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement