Denver TC-18C User manual

Location of controls

INSTRUCTION MANUAL

(1) FUNCTION SWITCH

(CD/POWER OFF/RADIO)

(2) BAND SWITCH

(3) FM ANTENNA

(4) CD DOOR

(5) TUNING KNOB

(6) BASS BOOST BUTTON

(7) CD SKIP/SEARCH FORWARD

BUTTON

(8) CD SKIP/SEARCH BACKWARD

BUTTON

(9) CD PROGRAM BUTTON

(10) CD REPEAT BUTTON

(11) CD STOP BUTTON

(12) CD PLAY/PAUSE BUTTON

English - 1

(13) CD LED DISPLAY

(14) CD PLAY/PAUSE LED

INDICATOR

(15) CD REPEAT LED INDICATOR

(16) CD PROGRAM LED

INDICATOR

(17) BATTERY DOOR

(18) FM STEREO LED INDICATOR

(19) SPEAKER LEFT

(20) SPEAKER RIGHT

(21) STEREO HEADPHONE JACK

(22) VOLUME CONTROL KNOB

(23) AC SOCKET

AC Operation

Before operation please ensure that the VOLTAGE on the set corresponds to the VOLTAGE of your local area. Unravel the AC Line Cord; insert one end into the AC jack on the set and the other end into a standard AC outlet.

Remarks:

1.In case of malfunction due to electrostatic discharge (ESD), reset the unit by reconnecting the AC cord again to resume to normal operation.

2. When not in use – Unplug the AC power cord completely from the AC socket.

BATTERY OPERATION

Disconnect the AC Cord Set completely. Open the BATTERY COMPARTMENT

DOOR and insert UM-2/ “C” size x 8 batteries (not supplied) making sure that the indicated battery polarity is observed.

RADIO OPERATION

1. Slide the FUNCTION switch to the “RADIO” position.

2. Slide the BAND switch to the desired waveband.

3. Turn the TUNING KNOB to your desired radio station.

4. Adjust the sound level by rotating the VOLUME CONTROL KNOB.

5. To turn off the radio, simply slide the FUNCTION SWITCH to “POWER

OFF” position.

Note: Radio frequency is shown on the TUNING KNOB.

FM STEREO INDICATOR

When tune to a FM stereo broadcast the “FM ST.” LED indicator will light up.

In weak signal areas the FM Stereo signal may not be strong enough and can cause excessive background noise. In this case, slide the BAND SWITCH to

“FM” position.

ANTENNA

For best reception, fully extend the FM Antenna to receive FM station.

BASS BOOST

To increase bass at all volume levels, slide the BASS BOOST BUTTON to “ON” position to boost the low frequency tone for an emphasized bass sound. To release the super bass, simply slide the switch to “OFF” position.

English - 2

CD OPERATION (CD-R/RW PLAYBACK COMPATIBLE)

PLAYING COMPACT DISC

GETTING STARTED

NOTE: Should skipping of tracks occur during CD playing try reduce the volume.

When CD is playing, do not open the CD Door.

1. Open the CD DOOR by pulling up the CD DOOR. Put a CD into the CD

COMPARTMENT and close the CD DOOR. Set the FUNCTION SWITCH to

“CD” position.

2. When the CD DOOR is closed with a CD inside, the total number of tracks of the disc will be shown on the CD LED DISPLAY and will go to “STOP” mode.

3. If the CD DOOR is not closed or there has no disc inside, the DISPLAY will show “ ” and go to “STOP” mode.

PLAY/PAUSE MODE

1. When the PLAY/PAUSE BUTTON is pressed during CD stop mode, the first track will be played. The PLAY/PAUSE LED INDICATOR will be lighted.

The CD LED DISPLAY will show the specific number of tracks played.

2. For interruption while the CD is playing, press the CD PLAY/PAUSE

BUTTON once. The PLAY/PAUSE LED INDICATOR will flash continuously.

3. Though the sound stops, the disc will continue to spin. To re-start playback, press the CD PLAY/PAUSE BUTTON once again. The music will start from the exact position where it was interrupted.

4. To stop the CD, press the CD STOP BUTTON once whether the CD is in

Play or Pause mode.

5. To turn off the CD, slide the FUNCTION SWITCH to “POWER OFF” position.

REPEAT MODE

1. REPEAT 1:

When the REPEAT BUTTON is pressed once, the REPEAT LED INDICATOR will light and flash continuously. This single track of music will be repeated.

2. REPEAT ALL:

When the REPEAT BUTTON is pressed twice, the REPEAT LED

INDICATOR will stay lit. The whole disc can be played continuously.

3. TO CANCEL THE REPEAT FUNCTION

Press the REPEAT BUTTON until the lighted REPEAT LED INDICATOR is turned off.

English - 3

SKIP AND SEARCH MODE

1. During play or pause mode, when CD SKIP FORWARD “>>” or CD SKIP

BACKWARD “<<” Button is pressed once, it will go to the next track or go back to the beginning of the track.

2. During play mode, when CD SKIP FORWARD “>>” or CD SKIP

BACKWARD “<<” BUTTON is pressed and held, it will search the track with audible high speed forward or backward playback.

Program Mode

1. During the CD stop mode, press the PROGRAM BUTTON once. The

PROGRAM LED INDICATOR will light up and blink continuously while the

LED DISPLAY will show the number of Program to be memorized starts from first program “01” and blink continuously as well. Press the CD SKIP

FORWARD “>>” or CD SKIP BACKWARD “<<” BUTTON to your desired musical track, the CD LED DISPLAY will show the appropriate track number. Press the PROGRAM BUTTON to store the desired track in memory.

2. Repeat above procedure until all desired tracks have been programmed.

A total of 20 tracks can be stored in memory. After complete programming, LED DISPLAY will show “01” again and flash continuously.

3. To start the PROGRAMMED playback, press the CD PLAY/PAUSE BUTTON once.

4. To check the program you have stored after complete programming, press PROGRAM BUTTON once.

Note: While PROGRAM LED INDICATOR is lighted up and flashing, never press the CD STOP BUTTON otherwise all programmed memory will be cancelled automatically.

5. To cancel the PROGRAMMED play mode, simply open the CD DOOR or press the CD STOP BUTTON once.

STEREO HEADPHONE JACK (PHONES/EARPHONES NOT INCLUDED)

For private listening, insert the plug of a stereo headphone into the STEREO

HEADPHONE JACK and adjust the VOLUME CONTROL KNOB accordingly.

During the use of a headphone the Speakers are automatically disconnected.

English - 4

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE APPLIANCE TO

RAIN OR MOISTURE. DO NOT REMOVE COVER; PILOT LAMPS SOLDERED IN

PLACE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO

QUALIFIED SERVICE PERSONNEL.

Instructions on environment protection

Do not dispose of this product in the usual household garbage at the end of its lifecycle; hand it over at a collection point for the recycling of electrical and electronic appliances. The symbol on the product, the instructions for use or the packing will inform about the methods for disposal.

The materials are recyclable as mentioned in this marking. By recycling, material recycling or other forms of re-utilization of old appliance, you are making an important contribution to protect our environment.

Please inquire at the community administration for the authorized disposal location.

English - 5