AB Soft 6424 User's Manual
OUTDOOR STORAGE
y
OUTDOOR STORAGE BUILDING
OWNER’S MANUAL
C
op
MODEL 6424
30” OUTDOOR STORAGE EXTENSION KIT
**A MINIMUM OF TWO ADULTS ARE REQUIRED FOR ASSEMBLY**
BEFORE BEGINNING ASSEMBLY
Identify and inventory all parts using the checklist boxes on the Parts List. Keep the
hardware bags and their contents separate. If any parts are missing, call our Customer
Service Department.
SAFETY INSTRUCTIONS
y
Failure to follow these safety instructions may result in serious injury or property damage. Proper and complete
assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability
of serious injury exists if this display is not installed, maintained, or operated properly. • If using a ladder during assembly,
use extreme caution. Follow all warnings and cautions on the ladder carefully. • 2 people are required for assembly. •
Misuse could result in system failure. • If technical assistance is required, contact the manufacturer.
Most injuries are caused by misuse and/or failure to follow instructions.
Save this instruction in the event that the manufacturer has to be contacted for replacement parts.
op
** Do Not Contact the Store **
For Assistance, including missing or broken parts,
Call Customer Service at:
1 (800) 225-3865
Hours: Monday - Friday 9:00 a.m. to 5:00 p.m. (MST).
Call, or visit our Web site for Saturday hours.
PARTS LIST
C
ID Reorder# Part # *
Description
Qty
108 ZS10882
1013592 Wall Panel
1
125 ZS12582
CB12500 Window Wall Panel
1
110 1029724
CB11000 Center Floor Panel
1
114 1009262
1009258 Lower Roof Panel
2
117 CB11780C CB11700 Center Roof Cap
1
AA 1009232
------Skylight
1
AB 1021645
------Roof Truss Channels 2
AC 1021644
------Roof Truss Brace
1
AD 1021649
------Roof Support
2
AE ZS01200
------Window
1
Hardware Bag [1026292]
TA 1021654
Truss Connector
1
TB BB04500 Threaded Rod
1
TD BN00300 1/4” Cap Nut
2
TE BN01600 #10 Cap Nut
6
TF BS06100 #10 x 3/8” Pan-Head Screw
8
TH BS07500 .25” x .625” Screw
45
TI
BS05900 #10 x .5” Pan-Head Screw
6
TJ BW01200 #10-1” Fender Washer
6
TK 1007360
Window Latch
2
*
Tools and Materials
Required for Assembly
(Not Included)
1.
2.
3.
7/16” Wrenches (2)
3/8” Wrenches (2)
#2 Phillips screwdriver or
Electric drill with Phillips head
Part Numbers are listed when different from the Reorder Number.
The Part Number will appear on most of the plastic parts.
INSTRUCTION #1045398
8/25/2008
HARDWARE IS ACTUAL SIZE
(Unless otherwise indicated)
AB
AA
AC
AD
TA
TB
117
108
114
TJ
TI
TD
TE
110
125
TF
TK
AE
TH
If you are Installing a New Shed
1. Check contents of boxes and compare to parts listed on the Parts List.
2. Follow instructions that came with your shed, but add extra floor panel, wall panels, Roof Cap
and Skylight at appropriate points in the assembly.
If you are Extending an Existing Shed
1. Remove any bolts or screws being used to anchor the shed to the ground.
2. Remove any objects from back shelves.
3. Remove any shelves, pegboards, or other objects hanging on the last two Side Wall Panels on
either side.
4. Check contents of boxes and compare to parts listed on the Parts List.
5. Follow the steps in this manual.
6. If you are extending an 8’ x 5’ shed you will need to modify the following instructions by not
removing as many parts as shown in the illustrations.
3
**Save all hardware for re-assembly!**
1
a. Remove last three skylights.
2
a. Remove the back 3 roof caps.
3
a. Remove the back Roof panels and Roof support bars.
4
4
a. Remove the next Roof panels and Roof support bars.
5
a. Remove the Roof Truss.
5
6
a. Remove the last two Side Wall Panels.
Note: If you’re adding onto a side entry shed, remove the panels (in gray) from the side of the shed rather than
removing the back of the shed. If you’re adding on to both sides, remove the panels (in gray) from both sides of
the shed (as illustrated), and follow the remaining steps.
7
a. Slide the back section of the shed away from the front. You will need to tip the back
section forward slightly in order to disconnect the floor panels
Be sure that there is nothing
on the back shelves before
moving the back section.
One person should support the
back wall while it is being tipped
and moved.
6
8
Assemble Window
a. Remove plastic sheeting from Window (AE) and slide Window into slot
on the Window Wall Panel (125). Attach a Window Latch (TK) above each
corner of the Window as shown. When tightening screws (TH), be sure
that Window Latches will slide freely. Do not overtighten. Insert screw (TF)
into the hole in the window. Set panel aside.
TF (1)
TH (4)
TK (2)
AE
Insert window with bent edge
at top and pointing away from
the wall.
Place Screw (TF) in this hole to
keep window from sliding up
too far. Insert until flush with the
window
7
9
a. Add new Floor Panel (110). Then, slide the back section into place
and connect the floor panels (you will need to tip the panels forward
slightly to connect the panels).
Tip up one floor panel and line up tabs
and then lay floor panel flat.
10
a. Add Wall Panels (108).
Insert a wood block directly
under the tab you want to
insert, then slide block to
next tab and repeat.
8
11 Assemble Truss
TF (6)
a. Attach Brace (AC) to two Roof Truss Channels (AB) (one on each
side of Brace. Secure Brace with Screws (TF) and Nuts (TE).
Follow picture above to
connect Brace to a Truss
Channel at each end of the
Brace.
TE (6)
The nut goes on
outside of the truss.
b. Use Truss Connector (TA) to attach Roof Truss Channels at top. Secure with Screws (TF) and Nuts
(TE). Before completely tightening, lay assembly on its side to be sure Channels and Brace are parallel.
Completely tighten all hardware.
WARNING
Do not overtighten the Cap Nut. If the end of
the Bolt breaks through the plastic cap, call our
Customer Service Department.
Be sure that Truss Connector
is aligned with the Truss
Channels.
9
c. Slide a Threaded Rod through the Truss Support
Brace and the top of the Truss Connector.
TD (2)
TB
TB
d. Secure the top and bottom of the Threaded Rod with a 1/4” Cap Nut (TD).
TD
WARNING
Do not overtighten the Cap Nut.
TD
10
12
a. Add Truss.
13
a. Add Roof Panels (114) and Roof
Supports (AD).
Roof Panel Ridge
Roof Panel
Wall
b. Add a center Roof Cap (117).
11
14
a. Add next Truss.
15
a. Add Roof Panels (114) and Roof
Supports (AD).
b. Add a center Roof Cap (117).
12
16
a. Add Roof Panels (114) and Roof
Supports (AD).
b. Add the last Center Roof Cap (117) and the End
Roof Cap.
17
a. Add Skylights
13
Enhance your Lifetime® Outdoor Shed by purchasing the
following Shed Accessories:
Model #
0110
Corner Shelf (2 pack)
Two 10” radius shelves with hardware.
0130
30” Shelf Kit w/ hardware (3 pack)
Three 30” x 10” Steel-Reinforced Shelves with shelf brackets and hardware.
0150
90” Shelf Kit w/ hardware
One 90” x 9” Steel-Reinforced Shelf with shelf bracket and hardware.
0113
16” Pegboard Strips w/ hardware
Two sixteen inch Pegboard Strips with hooks. Great for hanging large items such as:
rakes, shovels, or other tools.
0190
Shelf Support Channel
Two Shelf Support Channels that allow the 30” shelves on either of the side walls of
your shed.
To purchase shed accessories,
visit us at:
www.buylifetime.com
Or call:
1 (800) 424-3865
Congratulations on your Lifetime® Outdoor Shed purchase. By following the instructions
below, your new Lifetime shed should provide you with years of service and enjoyment.
Cleaning and Care
The polyethylene walls and shelves are stain- and solvent resistant. To clean, use a mild soap and a soft-bristled
brush. Abrasive cleaning materials may scratch the plastic and are not recommended. Repair scratches or rust
spots on the metal by Sanding the affected area lightly; using a rust preventative spray primer; and finally, spraying
with a high-gloss spray enamel paint. Avoid placing a direct heat source on or near surfaces unless using a heat
barrier.
For warranty details or to register your product, visit
www.lifetime.com or call 801-776-1532
14
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement