Abocom UFT128 User's Manual
UFT128
USB Fast Ethernet
+ ISDN TA
The USB LAN ISDN Adapter provides outside-the-box plugand-play local area network connections for USB-enabled PCs,
notebooks and laptops. This adapter uses a B type USB port to
connect with the USB host, and an RJ-45 port to connect with a
10/100 Fast Ethernet LAN link. Installation is easy and no
external power is required! The network sharing is easier than
ever.
ISDN (Integrated Service Digital Network) is the most
convenient and economical way to use the existing copper wire
for both voice and data communication. Data transmission rate
can reach up to 128K. It can not only provides 128K
transmission but also allows voice conversation and fast
Internet Access simultaneously.
APPLICATION
* Answering Machine with BVRP or RVS-COM
* Euro File Transfer with BVRP or RVS-COM
* Fax with BVRP or RVS-COM
* Internet Access
* Phone with BVRP or RVS-COM
Hardware Interface
* ISDN S/T
* USB
LED
* Link
* B1
*Multiframe support
*Analog part: included with adaptive detection
threshold and equalizer
USB Interface
*USB 1.0 specification full compliance, 1.1
specification compatibility (1.1 power management
compliance), 12 Mbps full speed
*On-chip USB transceiver with digital PLL
*6 isochronous endpoints for B1, B2 , D channels data
. interrupt endpoint for I430
*ISDN protocol and data.control endpoint for USB
standard plus vendor specific request
*Communication device class and vendor requests
*Bus or self powered application (pin programmable)
*Onnow power management (D0, D2, D3) suspend
mode compliance
*Pin programmable high/low power USB device
registration, wake-up capability, USB device
identification
* LAN
* B2
Supported operating systems
* Windows 98SE / ME / 2000 / XP
Switch Protocol
*DSS1: Euro-ISDN
Software Interface
*CAPI 2.0
*ISDN WAN Miniport
S/T ISDN Interface
*Support OSI level 1 conform to UIT-T I.430 for basic access
at S and T interfaces (ETSI 300012/ANSI T1.605)
*Line interface transformer direct drive
*Full-duplex transmission at 192kbps on separate transmit and
receive twisted pairs using alternate mark inversion (AMI)
line coding
*2 B channels at 64kbps each plus 1 D channel at 16kbps
*All I.430 wiring configurations supported including passive
bus for TE'S distributed point to point and point to multipoint
General
*USB hot plug and play interface
*Control access and interrupt handling provided
through the USB interface
*All FIFOS and FIFOS management needed included
for USB/ISDN data processing
*Internal PLL to generate the USB 48MHz clock from
a 15.36MHz crystal
*Internal regulator for 3.3V generation from USB bus
5V
*48 pin TQFP package
*0.35 micron HCMOS 6 process
LAN Specifications
Network standard
*IEEE 802.3 for 10BaseT
*IEEE 802.3u for 100BaseTX
Data Rate
*10/100 Mbps
*Double data transfer rate in full duplex mode
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement