Accusplit 625M8D User's Manual
ACCUSPLIT®
ALLIANCE™ 625M8D
MULTIMODE TIMER/STOPWATCH
OPERATING INSTRUCTIONS
E RECALL
UP/DOWN
B
RESET/SPLIT
A
START/STOP
C MODE
ROTARY
SWITCH
D SET
INTRODUCTION
This unit has five modes: Stopwatch, Auto Repeat Countdown
Timer, Dual Display Countdown Timer, Pacer, and Preset
Countdown Timer.
Press C (MODE) to change between modes. Note: Timing must
be stopped and reset to zero to change modes.
MEMORY STOPWATCH
SPLIT TIMING
1. Press C to move the cursor to point to
2. Press A to start stopwatch
3. Press B repeatedly to remember the last 8 splits
• Lower display shows cumulative split and upper
display shows lap split
• After 5 seconds, the unit will unlock splits to display
current running split time
4. Press E to recall the last 8 splits
5. Press A to stop counting
6. Press B to reset to zero
START-STOP TIMING
1. Press C to move the cursor to point to
2. Press A to start counting
3. Press A repeatedly to remember the last 8 time-cuts
4. Press E to recall the last 8 times-outs
5. Press A to stop counting
6. Press B to reset to zero
AUTO REPEAT COUNTDOWN TIMER
1. Press C to move the cursor to point to AUTO
2. Press D to enter set mode
• Press B to set hours, E to set minutes, A to set seconds
• Press A & B at the same time to reset digits to zero
3. Press A to start countdown timing
4. Press E to show the time from start ( )
5. Press E again to return to countdown timing ( )
6. Press A again to stop counting
7. Press B to return to the original setting
8. When time is up, the unit will beep once, then start
counting again. The number of cycles completed is
recorded in brackets in upper left of display.
DUAL DISPLAY COUNTDOWN TIMER
1. Press C to move the cursor to point to
DUAL
2. Press E to change the dual display timer mode (SU
or Id or UP)
3. Press D to adjust the timer on the lower display
Press D again to adjust the timer on the upper display
• Press B to set hours, E to set minutes, A to set seconds
• Press A & B at the same time to reset digits to zero
• Press D again to complete the settings
4. SU - Two countdown timers work simultaneously
• Press A to start
• Press A to stop (STOP: flashes)
• Press B to reset to the original settings
Id - Two countdown timers work independently
• Press A to start/stop lower display
• Press B to start/stop upper display
• Press A & B at the same time to reset to the original
settings
UP - Two count up timers work independently
• Press A to start/stop lower display (STOP: flashes
when stopped)
• Press B to start/stop upper display (STOP: flashes
when stopped)
• Press A & B at the same time to reset to zero
PACER WITH COUNT UP TIMER
1. Press C to move the cursor to point to
PACE
2. Press D to adjust the frequency
• Press A to increase the digits
• Press B to decrease the digits
3. Press A to start pacer
4. Press A again to the stop
5. Press B to reset to zero
6. Press E to turn the pacer’s beep ON or OFF
and the symbol (((•))) will appear or disappear
7. Upper display shows count up timer
16 PRESET COUNTDOWN TIMER
1. Press C to move the cursor to point to (1-60)
2. Turn the rotary switch to the desired minutes (1-60)
3. Press A to start countdown timing
4. Press A again to stop countdown timing
5. Alarm Sounds
6. Press B to return to the original setting
To Show Count Up Timing
1. When the time is not up.
a. Press E to check elapsed time ( )
b. Press E again to return to countdown ( )
2. When the time is over,
a. Press E to check the time from start ( flashes)
b. Press E again to show overtime ( flashes)
ACCUSPLIT®
ALLIANCE™ 625M8D
MULTIMODE TIMER/STOPWATCH
FUNCTIONS AND FEATURES
PRESET INTERVAL COUNTDOWN TIMER
(in seconds)
•
•
•
•
•
•
Selectable preset timer intervals – 1, 2, 3, 5,
10, 12, 15, 20, 25, 30, 35, 40, 45, 50, 55, and
60 minutes
Selectable display of Count UP or
Count DOWN
30 second warning beep
3 second start of 1 second warnings
Alarm at zero for 5 seconds
Then selectable display of total elapsed
time or overtime
USER SELECTABLE AUTO REPEAT TIMER
(1 second to 100 hours)
•
•
•
•
•
Repeat timer
Alarm at zero for each repeat
3 second warnings (if interval over 5 minutes)
Selectable display of time remaining in an
interval or cumulative elapsed time
Repeat timer counter to 99
8 DUAL MEMORY STOPWATCH
(1/100 second to 10 hours)
•
•
•
•
Saves in memory the last 8 Dual Split
(Lap and Cum) Splits
Split Counter up to 99
Memory Review during timing
5 second Automatic Split release and return
to running display
DUAL TIMERS
(1 second to 100 hours)
• 3 special timer modes
—“SU” is Two Simultaneous Timers with one
button Start/Stop
—“ID” is Two Independent Timers with own Start/Stop button
—“UP” is Two Independent Timers counting
UP with own Start/Stop button
• Single interval timing
• Two-button Reset to return to pre-set interval
and Two-button Reset to zero during setting
of interval
PACER/RATE TIMER
(beats per minute)
•
•
•
•
Timer up to 100 hours by second
Signal/Pace Counter up to 10,000
Selectable Pace/Rate frequency from 10 to
240 by 10
Selectable ON or OFF Pace/Rate beep
BATTERY
(see back of timer)
• CR 2032 3V lithium battery Panasonic or
equivalent
• Not water-resistant
REGISTER NOW Please return
your AL625M8D Registration to
the Repair Center address in the
warranty, and we will let you
know about future products.
Email (preferred)
User
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label on back of unit for details, or check
http://support.ACCUSPLIT.com
Eat Right! Walk More! Live Well!
The ACCUSPLIT Lifestyle
ACCUSPLIT, Inc. • 2290M Ringwood Ave. • San Jose, CA 95131
800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • [email protected]
960-012A
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement