Airaid 400-941 User's Manual

Airaid 400-941 User's Manual
INSTALLATION INSTRUCTIONS
#400-941 Modular Intake Tube (MIT)
OR
#400-741 Airaid Jr. Kit
2004-05 Ford F-150 4.6L
(Does Not Fit Heritage Body)
Thank you for purchasing the Airaid Intake System. Please read the instruction manual carefully before
proceeding with the installation. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for
questions regarding fit or instructions. Your Airaid Intake System was carefully inspected and packaged.
Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid.
The air filter element is protected from direct exposure to water and debris; care should be taken not to drive
through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable
and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
Thank you for selecting Airaid.
Packing List:
KIT941T
KITDCR02
KITHUMPHS08
KITHOSE02
KIT941HP
KIT131MOUNT
KIT09FWZ019
Modular Intake Tube
Silicone Reducer
Silicone Hump Hose
5/8” x 20” Rubber hose
Hardware Pack
Hose Mount
¼” Flat Washer
1
1
1
1
1
1
1
Packing List (cont’d):
KITSMP19M4 #19 Speed Clamp
KITHS72
#72 Hose Clamp
KITHS56
#56 Hose Clamp
KITHS48
#48 Hose Clamp
Tools Required for this Installation:
Flat Head Screwdriver
2
2
1
1
Installation Instructions. Read Me!
1. Disconnect negative battery
cable. Disconnect valve cover
breather hose from factory
intake tube and valve cover.
2. Loosen hose clamps
connecting the factory intake
tube to the air filter assembly
and throttle body.
5. Install the supplied silicone
hump hose and two #72 hose
clamps on factory air filter
assembly. Leave hose clamps
loose until final assembly.
6. Install supplied silicone
reducer on end of throttle
body. Install #48 hose clamp
on small end of the reducer and
#56 hose clamp on the big end
of the reducer. Leave hose
clamps loose until final
assembly.
8. Tighten hose clamps on both
ends of the Modular Intake
Tube.
9. Install the supplied rubber hose
on the Modular Intake Tube.
Connect the other end of the
hose to the valve cover.
Secure both ends of the hose
with the supplied speed
clamps.
3. Remove the factory intake
tube assembly from engine.
4. Airaid Jr. Kit PN#400-741
If you purchased the Airaid Jr.
Kit PN#400-741, replace the
factory air filter with the
Airaid Premium filter included
with the kit.
7. Install the Airaid Modular
Intake Tube on engine.
10. Double check your work to be
certain that all nuts, bolts, and
clamps are securely fastened.
Reconnect the negative
battery cable.
Before
After
Don’t Forget Your AIRAID
Filter Tune-Up Kit!
P/N 790-550
Instructions Revision
Date: 9/28/04
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement