Aiwa SX-AVR30 User's Manual
SPEAKER SYSTEM
SX-AVR30
OPERATING INSTRUCTIONS
MANUAL DE INSTRUCCIONES
E (Español)
MODE D’EMPLOI
F (Français)
BEDIENUNGSANLEITUNG
ISTRUZIONI PER L’USO
(Deutsch)
I (Italiano)
NL
(Nederlands)
NÁVOD K OBSLUZE
Cz
(Česky)
INSTRUKCJA OBSŁUGI
EZ
D
GEBRUIKSAANWIJZING
HASZNÁLATI UTASÍTÁS
8C-AS2-906-01
020320ACK-H-FO
En (English)
M (Magyar)
Po
(Polski)
ENGLISH
PRECAUTIONS
WARNING
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
“CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.”
OBSERVERA
Så länge som apparaten är ansluten till nätet flyter en
svag ström genom densamma, även då den är avstängd.
Om man under en längre tid ej har för avsikt att använda
den, drag då ur nätkabeln.
BEMÆRK
Apparatet er stadig forbundet med lysnettet, så længe
stikket er tilsluttet til stikkontakten, selv om afbryteren
er slået fra. Hvis
apparatet ikke bruges i længere tid, skal netledningen
trækkes ud.
Read the Operating Instructions carefully and completely before
operating the unit. Be sure to keep the Operating Instructions for
future reference. All warnings and cautions in the Operating
Instructions and on the unit should be strictly followed, as well
as the safety suggestions below.
Installation
1 Water and moisture — Do not use this unit near water, such
as near a bath, sink, swimming pool, or the like.
2 Heat — Do not use this unit near sources of heat, including
heating vents, stoves, or other appliances that generate heat.
It also should not be placed in temperatures less than 5°C or
greater than 35°C.
3 Mounting surface — Place the unit on a flat, even surface.
4 Ventilation — The unit should be situated with adequate space
around it so that proper heat ventilation is assured. Allow 10
cm clearance from the rear and the top of the unit, and 5 cm
from each side.
- Do not place the unit on a bed, rug, or similar surface that
may block the ventilation openings.
- Do not install the unit in a bookcase, cabinet, or airtight rack
where ventilation may be impeded.
5 Objects and liquid entry — Take care that objects or liquids
do not get inside the unit through the ventilation openings.
6 Carts and stands — When placed or mounted on a stand or
cart, the unit should be moved with care.
Quick stops, excessive force, and uneven surfaces may cause
the unit or cart to overturn or fall.
7 Wall or ceiling mounting — The unit should not be mounted
on a wall or ceiling, unless specified in the Operating
Instructions.
Electric Power
1 Power sources — Connect this unit only to power sources
specified in the Operating Instructions, and as marked on the
unit.
2 AC power cord
- When disconnecting the AC power cord, pull it out by the AC
power plug. Do not pull the cord itself.
- Never handle the AC power plug with wet hands, as this could
result in fire or shock.
- Power cords should be firmly secured to avoid being severely
bent, pinched, or walked upon. Pay particular attention to the
cord from the unit to the power socket.
- Avoid overloading AC power sockets and extension cords
beyond their capacity, as this could result in fire or shock.
3 When not in use — Unplug the AC power plug from the AC
power socket if the unit will not be used for several months or
more. When the cord is plugged in, a small amount of current
continues to flow to the unit, even when the power is turned off.
Maintenance
Clean the unit only as recommended in the Operating
Instructions.
2
ENGLISH
Damage Requiring Service
Have the unit serviced by a qualified service technician if:
- The AC power cord or plug has been damaged
- Foreign objects or liquid have got inside the unit
- The unit has been exposed to rain or water
- The unit does not seem to operate normally
- The unit exhibits a marked change in performance
- The unit has been dropped, or the cabinet has been damaged
DO NOT ATTEMPT TO SERVICE THE UNIT YOURSELF.
TABLE OF CONTENTS
PRECAUTIONS ........................................................................ 2
BEFORE USE .......................................................................... 4
SPECIFICATIONS .................................................................... 4
POSITIONING .......................................................................... 5
CONNECTION .......................................................................... 6
OPERATING SUB WOOFER ................................................... 7
En
Check your system and accessories
SX-AVR30
Sub woofer: SX-AVR30 (1)
Satellite speakers
Front: SX-AVR30F (2)
Centre: SX-AVR30C (1)
Rear: SX-AVR30R (2)
Sub woofer connecting cord : 1
Speaker cord : 1, 30 metres of 20 gauge
Operating instructions, etc.
ENGLISH
3
BEFORE USE
This speaker system consists of a sub woofer and satellite
speakers (front, centre and rear speakers).
The satellite speakers have the same appearance. See the back
of the speakers to check the sort of the speakers, front, centre
and rear.
[SUB WOOFER]
On AC voltage
The rated voltage of the unit shown on the rear panel is 230 V
AC. Check that the rated voltage matches your local voltage.
Howling or buzzing sound
A howling or buzzing sound may be heard if a turntable or a
stereo system is placed near the unit. Move the unit away from
the equipment or decrease the volume.
SPECIFICATIONS
[Sub woofer: SX-AVR30]
Input terminal:
INPUT jack
Input sensitivity/impedance:
1 V/33 kohms (at 100 Hz)
Power output:
55 W (4 ohms, T.H.D. 1% at 100
Hz)
60 W (4 ohms, T.H.D. 10% at 100
Hz)
117 W (DIN MUSIC POWER)
Frequency response:
20 Hz - 450 Hz
Speaker type:
Bass reflex, magnetically shielded
Speaker unit:
200 mm cone
Power requirement:
AC 230 V, 50 Hz
Power consumption:
55 W
Dimension(W × H × D): 280 × 417 × 395 mm
Weight:
9.5 kg
[SATELLITE SPEAKERS]
[Satellite speakers: SX-AVR30F/C/R]
Speaker’s impedance
Speaker:
Either of the two front and rear speakers can be connected to R
(right) or L (left) terminals.
Full-range, 80 mm, bass reflex
type, magnetically shielded
(except rear)
Impedance:
8 ohms
Maximum input power: 100 W (peak)
Dimension (W × H × D): 98 × 143 × 115 mm
Weight:
0.7 kg
[COMMON]
Accessory:
The speaker’s impedance is 8 ohms. Make sure that the
connected receiver is equipped with 8-ohms output speaker
terminals such as AIWA AV-NW50/51 and AV-NW30/31.
Speaker’s L/R
Using the unit near a TV set
Although the unit is magnetically shielded (except rear speakers),
there may be cases in which the picture on some TV sets may
become magnetically distorted.
- If the TV picture is distorted, turn off the power of the TV set
and turn it on again after 15 to 30 minutes.
- If there seems to be no improvement, move the unit further
away from the TV set.
- Furthermore, do not place magnets or objects using them,
such as audio racks, toys near the TV set.
These may cause magnetic distortion due to interaction with
the unit.
Keep away magnetic items
Keep cassette tapes, personal credit cards etc. using magnetic
cording away from the unit. The recorded information may be
damaged or some noise may be added.
4 ENGLISH
Sub woofer connecting cord (1),
Speaker cord, 30 metres of 20
gauge (1)
Specifications and external appearance are subject to
change without notice due to product improvement.
POSITIONING
En
Position the speakers according to the following
recommendations to maximize your Home Theater experience.
Refer to the operating instructions of the receiver as well.
Using a speaker mounting kit (not
supplied)
For best surround sound quality
Each speaker (except sub woofer) is equipped with a "M5"
threaded insert on the back. When attaching a part of the
mounting kit, such as a ball shaft, insert and rotate it into the
threaded female insert.
Sub woofer: Can be placed just about any place in the listening
room without being heard as a distinct source, because very low
frequencies are non-directional in nature.
A typical location for the sub woofer is somewhere along the
front wall, near the TV or one of the front speakers, or any of the
room corners with excellent results.
Centre speaker: Should be placed on top of or below the
television.
Rear speakers: Can be placed either behind the listening position
or to the side depending on your furnishings and the shape of
your room. They can be placed on stands or mounted on the
rear walls using brackets commercially available.
Alternatively they can be mounted on the side walls.
The ideal height for the rear speakers is 60 - 90 cm above the
listening position.
Left and right front speakers: Can be placed directly beside or
up to 90 - 120 cm on either side of the television.
For further information, refer to the instructions of the mounting
kit.
AIWA disclaims any responsibility for injury to persons or
other accidents caused by not fitting the speakers properly
or if the place of the installation is not suitable.
ENGLISH
5
CONNECTION
Right
Left
Front speakers
B
Sub woofer
A/V receiver (AV-NW30)
A
ANTENNA
COAXIAL
(VIDEO 2)
AM LOOP
FM 75Ω
(COAXIAL)
OPTICAL
(VIDEO 1)
OPTICAL
(DVD)
DIGITAL IN
PCM
/DOLBY DIGITAL
/DTS
DVD
VIDEO 2
/LD/TV
IN
IN
IN
OUT
B
SUB
WOOFER
VIDEO 1/MD MONITOR
SURROUND CENTER
SPEAKERS SPEAKER
R
L
OUT
VIDEO OUT
A
VIDEO
FRONT
SPEAKERS
R
L
0
0
0
9
9
9
0
L
AUDIO
R
IN
DVD
IN
VIDEO 2
/LD/TV
Right
Surround speakers
Before connecting the speakers, turn off the power of your stereo
receiver and the sub woofer.
Refer to the operating instructions of the receiver as well.
IN
OUT
VIDEO 1/MD
OUT
IN
TAPE
IN
IN
AUX
CD
Left
IMP: 8Ω
IMP: 8Ω
B
9
IMP: 8Ω
Centre speaker
B
B
1 Connect the cords to the speakers.
[ASUB WOOFER]
Connect the INPUT jack on the sub woofer and the SUB
WOOFER output jack on the receiver with the supplied
connecting cord.
[BSATELLITE SPEAKERS]
Before connecting the speakers, cut the supplied speaker cord
to the desired length and strip approximately 10 mm of insulation
from each wire.
10 mm
To make sure that the all channels are connected with the
same polarity, connect the cords as follows.
Blue striped cords: to the red or blue + terminals
Clear cords: to the - black terminals
2 Connect the other ends of the cords to the
speaker terminals on the receiver.
Front speaker cords: to the FRONT SPEAKERS terminals
Centre speaker cord: to the CENTER SPEAKER terminals
Rear speaker cords: to the SURROUND SPEAKERS terminals
Note that the blue stripe cords should be connected to the +
(red) speaker terminals on the receiver (and the clear cords
to the - (black) terminals).
6 ENGLISH
OPERATING SUB WOOFER
AUTO POWER
VOLUME
POWER
TURN OVER
POWER: Turns the power on and off.
VOLUME: Adjusts the volume of the sub woofer.
- The volume level should be balanced with that of all other
channels.
- If the sound is distorted, turn VOLUME down on the sub woofer
or lower the sub woofer level on the receiver.
- To avoid overloading the sub woofer, do not set the volume of
the receiver so high that the sound becomes distorted.
NOTE
After using, press POWER to turn off the power.
If the sub woofer will not be used for a long time, unplug the AC
cord from the outlet.
AUTO POWER: Switches AUTO POWER function on and off.
When the function is set to ON:
- The power is automatically turned off and the unit enters the
standby mode when receiving no signals for about 12 minutes.
- The power is automatically turned on when receiving the signal
input again.
If the level of the signal input is low, the sound may be cut or the
unit may not turn on again by this function.
TURN OVER: Adjusts the output sound range between "300 Hz
and under" and "40 Hz and under".
Turning it clockwise changes the output sound range wider and
reproduces comparatively high frequency sound as well.
Adjust it to suit your preference and a playback source.
ENGLISH
7
En
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement