Havis DS-DA-413 Laptop Screen Support For DS-GTC-310 Series Docking Stations (Rear Mount) Installation Instructions

EXTENSION ARM

TETHER

SCREEN HOLDER

CLAMP

DS-GTC-300 SERIES

DOCKING STATION (NOT

INCLUDED)

DRAWING NUMBER:

DS-DA-413_INST_10-14

MAIN SCREEN SUPPORT

NIGHT EYES: USB (DS-DA-102)

(NOT INCLUDED)

M4-1.79 X 10

THREAD FORMING

SCREW (DS-DA-102)

P-CLAMP (DS-DA-102)

INSTALLATION INSTRUCTIONS:

NOTE: Docking station depicted may not match identically to product otherwise noted.

1.

SCREEN STIFFENER SO MOUNTING HOLES LINE UP WITH THREADED

INSERTS AT REAR OF DOCKING STATION.

2.

3.

4.

NOTE: When a pre-applied thread-locking patch is not present on hardware, it is recommended to apply a drop of medium strength (blue) thread locking adhesive to the threads of the hardware prior to assembly.

DOCK COMPUTER IN DOCKING STATION.

EXTEND EXTENSION ARM OUT ALLTHE WAY TO END OF TRAVEL.

5.

6.

2X #8-32 X 3/8" FHMS

SCREEN STIFFENER

BRACKET

7.

8.

SLIDE EXTENSION ARM IN SO THAT SCREEN HOLDER TOUCHES SIDE

OF SCREEN.

ADJUST SCREEN HOLDER IN SO IT FITS TIGHT AGAINST SCREEN.

NOTE:

- SCREEN HOLDER IS DESIGNED TO DETACH AND BE HELD BY TETHER WHEN

SCREEN IS CLOSED.

- CLAMP CAN BE TIGHTENED BY LOOSENING LEVER ARM, ROTATING NUT AND

THEN RETIGHTENING LEVER ARM.

REAR OF DOCKING

LOCK/ RELEASE HANDLE

ITEM #

1

WARNING: ALL HAVIS INC. PRODUCTS ARE DESIGNED WITH SAFETY OF USE AND INSTALLATION IN MIND. HOWEVER,

IT IS THE SOLE RESPONSIBILITY OF THE OWNER/OPERATOR OF A VEHICLE USING HAVIS INC. MOUNTING AND

DOCKING EQUIPMENT, TO INSURE THAT THE EQUIPMENT IS INSTALLED SO THAT IT WILL NOT INTERFERE WITH VEHICLE

OPERATION, INTERFERE WITH SAFETY DEVICES, OBSTRUCT VIEW OF DRIVING CONDITIONS, OR IN ANY WAY

DEGRADE OCCUPANT SAFETY. IMPROPER INSTALLATION CAN CAUSE SERIOUS INJURY IN THE EVENT OF AN

ACCIDENT. INSTALLATION SHOULD ONLY BE PERFORMED BY QUALIFIED PROFESSIONALS. COMPUTERS AND

MOTION DEVICES MUST BE MOVED TO AND STOWED/SECURED IN THEIR SAFE DRIVING POSITIONS BEFORE

OPERATING VEHICLE.

- NIGHT EYES:USB (DS-DA-102) CAN BE INSTALLED ONTO MAIN SCREEN

STIFFENER SUPPORT USING P-CLAMP AND SCREW PROVIDED IN NIGHT EYES

HARDWARE KIT. PLACE P-CLAMP AROUND NIGHT EYES, AS SHOWN. ALIGN WITH

HOLE ON BACK OF MAIN SCREEN SUPPORT AND INSTALL SCREW. TIGHTEN TO 10

IN-LBS. 10%.

HARDWARE KIT CONTENTS

DESCRIPTION

SCREW, FLAT HEAD, #8-32 X 3/8" LONG

QTY.

2

FINISH

WITH PATCH

DRIVE STYLE/SIZE

#2 PHILLIPS

PRODUCT DESCRIPTION

THIS PRODUCT SUPPLIES SUPPORT

FOR THE SCREEN OF THE COMPUTER

WHEN DOCKED.

DS-DA-413

1-800-524-9900

WWW.HAVIS.COM

10-03-14

PRODUCT NAME

SCREEN STIFFENER

DS-GTC-300 SERIES

WEIGHT: (GMS)

REV. DATE

F-730-019 REV A