PS-300 - Canohm
PS-300
Pillow Speaker
■■
■■
■■
Volume
Adjust to desired audio output level
Amplifier on / off: switch on to increase audio output level
Note
Install one aaa / um-4 / r3 battery (battery not included)
to power the optional internal audio amplifier only connect
to headphone jack, as connection to higher output speaker
connection will cause damage.
E&OE
■■
Listen to Audio Devices with comfort and privacy
In-Line Volume Control
Built-in Power Amplifier to Enhance the Audio Output Level
Switch Off Built-in Amplifier To Power Speaker Directly
See over page for technical specifications.
4/30 Prohasky Street,
Port Melbourne Victoria 3207
Telephone 03 9644 7888
Facsimile 03 9646 7366
Email
sales@canohm.com.au
www.sangean.com.au
www.canohm.com.au
ABN 57 004 817 949
November 2016
PS-300
SPECIFICATIONS
Speaker
57mm 16 ohm 50mW full range
Amplifier output power
Typical 50mW 16 ohm
Input impedance 200 ohm
Frequency response
100Hz ~20kHz
Maximum input power
50mW (amplifier OFF)
Input sensitivity 500mVrms
57mm Mylar
16 ohm
Yes
30 mW
SUM - 4 x1
3.5 mm (D)
2 metre stereo cable
70 x 86 x 14.5
90 1200 / 47.24
Volume control
Bypass headphone
& Booster
12 months
4/30 Prohasky Street,
Port Melbourne Victoria 3207
Email
sales@canohm.com.au
E&OE
Output Devices Speaker
Size
Impedance
Magnetically Shield
Output Power Typical
Batteries (Speaker)
Power Supply
Batteries (Main Power)
I/O Socket
input cable and plug
Dimensions
W x H x D (mm) Weight (g)
Particular Performance Length of the cable (mm/inch)
2
3
Warranty
Telephone 03 9644 7888
Facsimile 03 9646 7366
www.sangean.com.au
www.canohm.com.au
ABN 57 004 817 949
November 2016
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising