50 Ohms 1040AF-DIF0-0.5 AODR Modulation Input RF Output Input

50 Ohms 1040AF-DIF0-0.5 AODR Modulation Input RF Output Input
DESIGN GOALS
Modulation Input
Input Impedance
Digital Input (SMB Male)
RF Output
Center Frequency (Fc)
Output Power (SMA Female)
Rise/Fall Time
RF Contrast Ratio
Harmonic Distortion
Output Impedance
Output VSWR
Bandwidth
Power Supply Voltage (+Vcc)
ALC Voltage Level
OUTLINE DRAWING
50 Ohms
Standard TTL Levels
40 MHz ± 0.1%
0.5 W
25 nsec Typ.
35 dB min
-20 dBc
50 Ohms
1.5 : 1 Max
20 MHz
+24 V @ 550 mA
+3.5 to +21 V nominal
Notes:
1. Output power factory set to 0.5 W at a 2.4 V, 30 mA input. Power stability less than 5% over
the heat sink's ambient temperature range of 0-40° C, after 5 minute warm-up.
2. When calculating the contrast ratio, it is understood that only the power of the 40 MHz
fundamental shall be used. The higher harmonics have no effect on the AO modulator's
performance.
3. A +21 Volt nominal input on the ALC corresponds to full RF output power. Zero RF power
occurs at an ALC voltage below +3.5 Volts. Full RF power occurs if ALC input is left
unconnected.
THIS DOCUMENT IS THE PROPERTY OF CRYSTAL TECHNOLOGY, INC. IT IS NOT TO BE REPRODUCED OR
DISCLOSED IN WHOLE OR IN PART OTHER THAN BY EMPLOYEES OF CRYSTAL TECHNOLOGY AND ITS
CONTRACTED REPRESENTATIVES AND DISTRIBUTERS. ANY EXCEPTION REQUIRES THE WRITTEN
CONSENT OF AN AUTHORIZED REPRESENTATIVE OF CRYSTAL TECHNOLOGY.
TOLERANCES:
.XX ± .01
.XXX ± .005
DR
T. Moon
10/23/2014
DESCRIPTION:
MATERIAL:
FINISH:
CHK
AODR 1040AF-DIF0-0.5
APP
PART NUMBER:
APP
97-03307-75
REV:
1
1 of 1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement