Setup Guide This guide provides information for setting up a network connection for the printer. Wireless Connection Preparation for Connection Printer Setup Setup Procedure Selection Push Button Method WPS Troubleshooting Wireless Connection a Preparation for Connection Before Starting Wireless Connection Setup 1. Make sure that the printer is turned on. If the power is on, the ON button (A) will be lit. Notes on Wireless Connection • Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your printer to. • The conﬁguration, router functions, setup procedures and security settings of the network device vary depending on your system environment. For details, refer to the manual of your network device or contact its manufacturer. • Check if your device supports IEEE802.11n, 802.11g or 802.11b. • If your device is set to the "IEEE802.11 n only" mode, WEP or TKIP cannot be used as a security protocol. Change the security protocol for your device to something other than WEP and TKIP or change the setting to something other than "IEEE802.11 n only." • For ofﬁce use, consult your network administrator. • Take added care when connecting to a network that is not protected with security measures, as there is a risk of disclosing data such as your personal information to a third party. • An "Ad-hoc connection," which establishes a direct connection to the computer over a wireless connection without an access point, is not supported. Be sure to prepare an access point. b Printer Setup 1. Press the Setup button (A) on the printer. 2. Use the or button (A) to select Device settings. 3. Press the OK button (B). 4. Select LAN settings. 5. Press the OK button. 6. Select Wireless LAN setup. 7. Press the OK button. The (blue) Wi-Fi lamp (A) lights up when wireless connection is enabled. The printer will automatically search for access points supporting WPS (Wi-Fi Protected Setup). c Setup Procedure Selection Push Button Method → d-A WPS → d-B d-A Push Button Method d Connection Using WPS 1. Press and hold the WPS button on the access point (for about 5 seconds). For details on pressing the WPS button, refer to the access point manual. 2. Press the OK button on the printer within 2 minutes. The (blue) Wi-Fi lamp on the printer ﬂashes while searching for or connecting to the access point. 3. When the left screen appears, press the OK button. 4. Press the COPY button (A). The network connection setup is now complete. d-B WPS d Connection Using WPS 1. Select WPS. 2. Press the OK button. 3. Select Push button method. 4. Press the OK button. 5. Press and hold the WPS button on the access point (for about 5 seconds). For details on pressing the WPS button, refer to the access point manual. 6. Press the OK button on the printer within 2 minutes. The (blue) Wi-Fi lamp on the printer ﬂashes while searching for or connecting to the access point. 7. When the left screen appears, press the OK button. 8. Press the COPY button (A). The network connection setup is now complete. Troubleshooting WPS Multiple APs detected The screen appears when multiple access points are detected. Wait for a while, then conﬁgure WPS settings again. Press the WPS button on only one access point. Failed to connect The screen appears when an error occurs. Check the access point settings, then conﬁgure WPS settings again. For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Timeout error The screen appears when WPS setup was not completed within a speciﬁed time. Complete the setup within the speciﬁed time.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project